1# 2# Specific board setup for the D-Link DIR-825B1 router. 3# 4# The DIR-825B1 has the following hardware: 5# 6# + AR7161 CPU SoC 7# + AR9223 2.4GHz 11n 8# + AR9220 5GHz 11n 9# + RealTek RTL8366S Gigabit switch 10# + m25p64 based 8MB flash 11# + 64MB RAM 12# + uboot environment 13 14# $FreeBSD$ 15 16#NO_UNIVERSE 17 18include "AR71XX_BASE" 19ident "DIR-825B1" 20hints "DIR-825B1.hints" 21 22# Since the kernel image must fit inside 1024KiB, we have to build almost 23# everything as modules. 24# nodevice random 25nodevice gpio 26nodevice gpioled 27nodevice gif 28nodevice gre 29nodevice if_bridge 30nodevice usb 31nodevice ehci 32nodevice wlan 33nodevice wlan_xauth 34nodevice wlan_acl 35nodevice wlan_wep 36nodevice wlan_tkip 37nodevice wlan_ccmp 38nodevice wlan_rssadapt 39nodevice wlan_amrr 40nodevice ath 41nodevice ath_pci 42nodevice ath_hal 43nodevice umass 44nodevice ath_rate_sample 45 46nooptions INET6 47 48# GEOM modules 49device geom_map # to get access to the SPI flash partitions 50device xz 51options GEOM_UZIP 52options GEOM_PART_GPT 53 54options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\" 55options AR71XX_REALMEM=64*1024*1024 56 57options AR71XX_ENV_UBOOT 58 59# options MSDOSFS # Read MSDOS filesystems; useful for USB/CF 60 61# options MD_ROOT 62# options MD_ROOT_SIZE="6144" 63 64options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash 65options ATH_EEPROM_FIRMWARE # Use EEPROM from flash 66device firmware # Used by the above 67