| /linux-6.15/Documentation/misc-devices/ |
| H A D | xilinx_sdfec.rst | 4 Xilinx SD-FEC Driver 50 - Activate the SD-FEC core 51 - Monitor the SD-FEC core for errors 61 - Activate the SD-FEC core 112 SD-FEC core is configured plus if the SD-FEC has not been configured for PL 117 - Get the SD-FEC core status 119 - Stop the SD-FEC core 181 Bypass the SD-FEC 190 Start the SD-FEC core 195 Get SD-FEC Status [all …]
|
| /linux-6.15/drivers/mmc/host/ |
| H A D | Kconfig | 3 # MMC/SD host controller drivers 6 comment "MMC/SD/SDIO Host Controller Drivers" 548 SD/MMC card reader, say Y or M here. 589 SD/MMC/SDIO devices. 651 tristate "MMC/SD/SDIO over SPI" 743 tristate "VIA SD/MMC Card Reader Driver" 749 SD/MMC/SDHC. 933 support MMC or SD memory cards. 1041 tristate "Broadcom SDIO/SD/MMC support" 1070 supports SD/MMC/SDIO devices. [all …]
|
| /linux-6.15/drivers/infiniband/hw/hfi1/ |
| H A D | sdma.c | 49 #define SD(name) SEND_DMA_##name macro 317 reg &= SD(DESC_CNT_CNT_MASK); in sdma_set_desc_cnt() 318 reg <<= SD(DESC_CNT_CNT_SHIFT); in sdma_set_desc_cnt() 1935 write_sde_csr(sde, SD(CTRL), in sdma_sendctrl() 1960 write_sde_csr(sde, SD(LEN_GEN), in sdma_setlengen() 1962 write_sde_csr(sde, SD(LEN_GEN), in sdma_setlengen() 2028 write_sde_csr(sde, SD(MEMORY), in init_sdma_regs() 2065 sdma_dumpstate_helper(SD(CTRL)); in sdma_dumpstate() 2078 sdma_dumpstate_helper(SD(TAIL)); in sdma_dumpstate() 3144 SD(CHECK_SLID_MASK_SHIFT)) | in sdma_update_lmc() [all …]
|
| /linux-6.15/Documentation/driver-api/mmc/ |
| H A D | mmc-dev-attrs.rst | 2 SD and MMC Block Device Attributes 6 SD or MMC device. 14 SD and MMC Device Attributes 22 scr SD Card Configuration Register (SD only) 25 (SD and MMCv1 only) 27 (SD and MMCv1 only) 32 (SD and MMCv4 only) 51 always one 512 byte sector. For SD, "erase_size" is 512 54 SD/MMC cards can erase an arbitrarily large area up to and 72 (especially for SD where it is just one sector), [all …]
|
| /linux-6.15/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6ull-dhcom-som-cfg-sdcard.dtsi | 7 * Special SoM configuration: SD card 9 * Enabled: Micro SD card on module or 10 * external SD card via DHCOM depends on hardware variant 17 * To use usdhc1 as SD card, the WiFi node must be deleted. The associated 44 /* Micro SD card on module or external SD card via DHCOM */
|
| H A D | imx6qdl-dhcom-drc02.dtsi | 13 * Special SoM hardware required which uses the pins from micro SD card. The 15 * Tx and Rx are routed to the DHCOM UART1 rts/cts pins. Therefore the micro SD 102 &usdhc2 { /* SD card */ 108 * Due to the use of can2 the micro SD card on module have to be
|
| /linux-6.15/Documentation/devicetree/bindings/dma/ |
| H A D | stericsson,dma40.yaml | 23 1: SD/MMC controller 0 (unused) 24 2: SD/MMC controller 1 (unused) 25 3: SD/MMC controller 2 (unused) 50 28: SD/MMC controller 2 51 29: SD/MMC controller 0 54 32: SD/MMC controller 1 63 41: SD/MMC controller 3 64 42: SD/MMC controller 4 65 43: SD/MMC controller 5
|
| /linux-6.15/Documentation/devicetree/bindings/mmc/ |
| H A D | sdhci-am654.yaml | 62 description: Output tap delay for SD/MMC legacy timing 74 description: Output tap delay for SD high speed timing 80 description: Output tap delay for SD UHS SDR12 timing 86 description: Output tap delay for SD UHS SDR25 timing 92 description: Output tap delay for SD UHS SDR50 timing 98 description: Output tap delay for SD UHS SDR104 timing 104 description: Output tap delay for SD UHS DDR50 timing 132 description: Input tap delay for SD/MMC legacy timing 144 description: Input tap delay for SD high speed timing 150 description: Input tap delay for SD UHS SDR12 timing [all …]
|
| H A D | aspeed,sdhci.yaml | 8 title: ASPEED SD/SDIO/MMC Controller 15 The ASPEED SD/SDIO/eMMC controller exposes two slots implementing the SDIO 39 description: The SD/SDIO controller clock gate 58 description: The SD bus clock 61 description: The SD interrupt shared between both slots
|
| H A D | cdns,sdhci.yaml | 7 title: Cadence SD/SDIO/eMMC Host Controller (SD4HC) 41 description: Value of the delay in the input path for SD high-speed timing 53 description: Value of the delay in the input path for SD UHS SDR12 timing 59 description: Value of the delay in the input path for SD UHS SDR25 timing 65 description: Value of the delay in the input path for SD UHS SDR50 timing 71 description: Value of the delay in the input path for SD UHS DDR50 timing
|
| H A D | mmc-controller-common.yaml | 44 # *NOTE* on CD and WP polarity. To use common for all SD/MMC host 86 - for SD/SDIO cards the SDR104 mode has a max supported 125 SD high-speed timing is supported. 135 SD UHS SDR12 speed is supported. 140 SD UHS SDR25 speed is supported. 145 SD UHS SDR50 speed is supported. 150 SD UHS SDR104 speed is supported. 155 SD UHS DDR50 speed is supported. 244 Controller is limited to send SD commands during initialization. 308 sequence. To successfully detect an (e)MMC/SD/SDIO card, that [all …]
|
| H A D | socionext,uniphier-sd.yaml | 7 title: UniPhier SD/SDIO/eMMC controller 63 - description: ID of SD instance 66 The argument is the ID of SD instance.
|
| H A D | marvell,xenon-sdhci.yaml | 89 All those types of PHYs can support eMMC, SD and SDIO. Please note that 133 always occur with PHY enabled in eMMC HS SDR, SD SDR12, SD SDR25, 134 SD Default Speed and HS mode and eMMC legacy speed mode. 218 // For SD/SDIO 259 // For SD/SDIO with compatible "marvell,armada-3700-sdhci":
|
| /linux-6.15/Documentation/devicetree/bindings/clock/ |
| H A D | idt,versaclock5.yaml | 38 SH SP Output when the SD/OE pin is Low/High 88 shut down if the SD/OE pin is driven high. If 0, this disables the 90 the value of the SD/OE pin. This property corresponds to the SH 97 If 1, this enables output when the SD/OE pin is high, and disables 98 output when the SD/OE pin is low. If 0, this disables output when 99 the SD/OE pin is high, and enables output when the SD/OE pin is 179 /* Set the SD/OE pin's settings */
|
| /linux-6.15/drivers/gpu/drm/sti/ |
| H A D | NOTES | 14 - The HDMI / DVO / HD Analog / SD analog IP builds the video signals 18 - The SD analog signal is typically used for legacy TV 29 dec | | | mixer| | +---+ SD analog +--> CVBS 45 - The Bridges/Connectors are mapped to the HDMI / DVO / HD Analog / SD analog 57 | | | mixer| | +-> | | SD analog | <-+
|
| /linux-6.15/Documentation/devicetree/bindings/iio/adc/ |
| H A D | sigma-delta-modulator.yaml | 15 "sd-modulator" can be used as a generic SD modulator, 44 // Backend binding example. SD modulator configured as an IIO backend device 52 // Legacy binding example. SD modulator configured as an IIO channel provider
|
| /linux-6.15/Documentation/devicetree/bindings/soc/socionext/ |
| H A D | socionext,uniphier-sdctrl.yaml | 7 title: Socionext UniPhier SD interface logic 13 SD interface logic implemented on Socionext UniPhier SoCs is 14 attached outside SDHC, and has some SD related functions such as
|
| H A D | socionext,uniphier-mioctrl.yaml | 15 SD/eMMC, and MIO-DMAC. 18 Recent SoCs have SD interface logic specialized only for SD functions
|
| /linux-6.15/drivers/clk/qcom/ |
| H A D | Kconfig | 48 USB, UFS, SD/eMMC, PCIe, etc. 216 i2c, USB, SD/eMMC, etc. 224 i2c, USB, SD/eMMC, etc. 232 i2c, USB, SD/eMMC, etc. 240 i2c, USB, SD/eMMC, etc. 256 i2c, USB, SD/eMMC, etc. 306 i2c, USB, SD/eMMC, etc. 366 I2C, USB, SD/eMMC, etc. 374 i2c, USB, SD/eMMC, etc. 1077 I2C, USB, SD/UFS, PCIe, etc. [all …]
|
| /linux-6.15/Documentation/devicetree/bindings/media/i2c/ |
| H A D | adv7343.txt | 6 definition (SD), enhanced definition (ED), or high definition (HD) video 22 - ad,adv7343-sd-config-dac-out: array configure SD DAC Output's 1 and 2, 0 = OFF 42 /* Use SD DAC output 1 */
|
| /linux-6.15/drivers/mmc/ |
| H A D | Kconfig | 7 tristate "MMC/SD/SDIO card support" 13 If you want MMC/SD/SDIO support, you should say Y here and
|
| /linux-6.15/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra194-p3668-0000.dtsi | 5 model = "NVIDIA Jetson Xavier NX (SD-card)"; 13 /* SDMMC1 (SD/MMC) */
|
| /linux-6.15/arch/arm/boot/dts/marvell/ |
| H A D | kirkwood-openrd.dtsi | 79 * (serial@12100) and SD (mvsdio@90000). 82 * High: SD 88 output-high; /* Select SD by default */
|
| /linux-6.15/Documentation/devicetree/bindings/regulator/ |
| H A D | vqmmc-ipq4019-regulator.yaml | 7 title: Qualcomm IPQ4019 VQMMC SD LDO regulator 13 Qualcomm IPQ4019 SoC-s feature a built a build SD/EMMC controller,
|
| /linux-6.15/Documentation/translations/zh_CN/scheduler/ |
| H A D | sched-domains.rst | 64 SD标志位调节了哪些东西。 66 体系结构可以把指定的拓扑层级的通用调度域构建器和默认的SD标志位覆盖掉,方法是创建一个
|