| /linux-6.15/Documentation/devicetree/bindings/display/mediatek/ |
| H A D | mediatek,hdmi-ddc.yaml | 7 title: Mediatek HDMI DDC
14 The HDMI DDC i2c controller is used to interface with the HDMI DDC pins.
|
| /linux-6.15/Documentation/devicetree/bindings/gnss/ |
| H A D | u-blox,neo-6m.yaml | 17 The U-blox GNSS receivers can use UART, DDC (I2C), SPI and USB interfaces.
28 The DDC Slave Address, SPI chip select address, the number of the USB hub
30 depending on the bus used. Required for the DDC, SPI or USB busses.
|
| /linux-6.15/Documentation/devicetree/bindings/display/connector/ |
| H A D | hdmi-connector.yaml | 32 description: phandle link to the I2C controller used for DDC EDID probing
36 description: GPIO signal to enable DDC bus
|
| H A D | vga-connector.yaml | 19 description: phandle link to the I2C controller used for DDC EDID probing
|
| H A D | dvi-connector.yaml | 23 description: phandle link to the I2C controller used for DDC EDID probing
|
| /linux-6.15/Documentation/devicetree/bindings/display/ |
| H A D | allwinner,sun4i-a10-hdmi.yaml | 44 - description: The HDMI DDC clock
68 - description: DDC Transmission DMA Channel
69 - description: DDC Reception DMA Channel
|
| H A D | dp-aux-bus.yaml | 16 particular, DP sinks support DDC over DP AUX which allows tunneling
17 a standard I2C DDC connection over the AUX channel.
|
| H A D | brcm,bcm2835-hdmi.yaml | 37 Phandle of the I2C controller used for DDC EDID probing
|
| H A D | brcm,bcm2711-hdmi.yaml | 79 Phandle of the I2C controller used for DDC EDID probing
|
| /linux-6.15/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6q-prti6q.dts | 254 /* DDC */
474 /* NOTE: DDC is done via I2C2, so DON'T
475 * configure DDC pins for HDMI!
481 /* DDC */
|
| H A D | imx6dl-alti6p.dts | 275 /* DDC */
460 /* NOTE: DDC is done via I2C2, so DON'T configure DDC
|
| H A D | imx6qdl-mba6.dtsi | 229 /* DDC */
449 /* NOTE: DDC is done via I2C2, so DON'T
450 * configure DDC pins for HDMI!
|
| H A D | imx53-kp-ddc.dts | 11 model = "K+P imx53 DDC";
|
| /linux-6.15/Documentation/devicetree/bindings/display/samsung/ |
| H A D | samsung,exynos-hdmi-ddc.yaml | 7 title: Samsung Exynos SoC HDMI DDC
|
| H A D | samsung,exynos-hdmi.yaml | 34 Phandle to the HDMI DDC node.
39 there is no power provided for DDC epprom, some TV-sets do not pulls up
|
| /linux-6.15/arch/arm64/boot/dts/freescale/ |
| H A D | imx8qm-apalis.dtsi | 27 /* Apalis I2C2 (DDC) */
305 /* Apalis I2C2 (DDC) */
|
| /linux-6.15/Documentation/devicetree/bindings/display/rockchip/ |
| H A D | rockchip,dw-hdmi.yaml | 82 The unwedge pinctrl entry shall drive the DDC SDA line low. This is
83 intended to work around a hardware errata that can cause the DDC I2C
|
| /linux-6.15/arch/arm/boot/dts/nvidia/ |
| H A D | tegra124-apalis-eval.dts | 100 * GEN2_I2C: I2C2_SDA/SCL (DDC) on MXM3 pin 205/207 (e.g. display EDID)
115 /* I2C4 (DDC): unused */
|
| H A D | tegra124-apalis-v1.2-eval.dts | 112 * I2C4 (DDC): I2C4_SDA/SCL (DDC) on MXM3 pin 205/207
|
| /linux-6.15/arch/arm/boot/dts/marvell/ |
| H A D | dove-sbc-a510.dts | 118 * - HDMI/DVI DDC channel
121 * - VGA DDC channel
|
| /linux-6.15/Documentation/fb/ |
| H A D | intel810.rst | 54 - Supports EDID probing either by DDC/I2C or through the BIOS
250 e. If you want support for DDC/I2C probing (Plug and Play Displays),
251 set 'Enable DDC Support' to 'y'. To make this option appear, set
|
| /linux-6.15/Documentation/devicetree/bindings/display/bridge/ |
| H A D | synopsys,dw-hdmi.yaml | 52 The HDMI DDC bus can be connected to either a system I2C master or the
|
| /linux-6.15/Documentation/devicetree/bindings/display/tegra/ |
| H A D | nvidia,tegra20-hdmi.yaml | 69 description: phandle of an I2C controller used for DDC EDID
|
| /linux-6.15/arch/x86/kernel/cpu/ |
| H A D | centaur.c | 87 DDC = 1<<14, enumerator
|
| /linux-6.15/drivers/video/fbdev/ |
| H A D | Kconfig | 169 bool "DDC for CyberPro support"
174 Say Y here if you want DDC support for your CyberPro graphics
680 bool "Enable DDC Support"
728 bool "Enable DDC Support"
807 bool "Enable DDC Support"
894 DDC (I2C) bus present on all Matroxes, an I2C bus which
896 G400, and the secondary head DDC bus, present on G400 only.
955 bool "DDC/I2C for ATI Radeon support"
960 Say Y here if you want DDC/I2C support for your Radeon board.
1068 bool "DDC for S3 support"
[all …]
|