wifi: ath12k: Add firmware coredump collection support

In case of firmware assert snapshot of firmware memory is essential for
debugging. Add firmware coredump collection support for PCI bus.
Collec

wifi: ath12k: Add firmware coredump collection support

In case of firmware assert snapshot of firmware memory is essential for
debugging. Add firmware coredump collection support for PCI bus.
Collect RDDM and firmware paging dumps from MHI and pack them in TLV
format and also pack various memory shared during QMI phase in separate
TLVs. Add necessary header and share the dumps to user space using dev
coredump framework. Coredump collection is disabled by default and can
be enabled using menuconfig. Dump collected for a radio is 55 MB
approximately.

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.2.1-00201-QCAHKSWPL_SILICONZ-1
Tested-on: WCN7850 WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4

Signed-off-by: Sowmiya Sree Elavalagan <[email protected]>
Acked-by: Jeff Johnson <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jeff Johnson <[email protected]>

show more ...

Kconfig: reduce the amount of power sequencing noise

Kconfig will ask the user twice about power sequencing: once for the QCom
WCN power sequencing driver and then again for the PCI power control
dr

Kconfig: reduce the amount of power sequencing noise

Kconfig will ask the user twice about power sequencing: once for the QCom
WCN power sequencing driver and then again for the PCI power control
driver using it.

Let's automate the selection of PCI_PWRCTL by introducing a new hidden
symbol: HAVE_PWRCTL which should be selected by all platforms that have
the need to include PCI power control code (right now: only ARCH_QCOM).

The pwrseq-based PCI pwrctl driver itself will then be selected by the
drivers binding to devices that may require external handling of the
power-up sequence (currently: ath11k and ath12k) based on the value
of HAVE_PWRCTL.

Make all PCI pwrctl Kconfig symbols hidden so that no questions are
asked during configuration.

Fixes: 4565d2652a37 ("PCI/pwrctl: Add PCI power control core code")
Reported-by: Linus Torvalds <[email protected]>
Closes: https://lore.kernel.org/lkml/CAHk-=wjWc5dzcj2O1tEgNHY1rnQW63JwtuZi_vAZPqy6wqpoUQ@mail.gmail.com/
Acked-by: Jeff Johnson <[email protected]> # drivers/net/wireless/ath
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Bartosz Golaszewski <[email protected]>

show more ...

wifi: ath12k: initial debugfs support

The initial debugfs infra bringup in ath12k driver and create the ath12k debugfs
and soc-specific directories in /sys/kernel/debug/

For each ath12k device, dir

wifi: ath12k: initial debugfs support

The initial debugfs infra bringup in ath12k driver and create the ath12k debugfs
and soc-specific directories in /sys/kernel/debug/

For each ath12k device, directory will be created in <bus>-<devname>
schema under ath12k root directory.

Example with one ath12k device:
/sys/kernel/debug/ath12k/pci-0000:06:00.0

ath12k
`-- pci-0000:06:00.0
|-- mac0

To enable ath12k debugfs support (CONFIG_ATH12K_DEBUGFS=y)

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1

Signed-off-by: Ramasamy Kaliappan <[email protected]>
Signed-off-by: Ramya Gnanasekar <[email protected]>
Acked-by: Jeff Johnson <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>
Link: https://msgid.link/[email protected]

show more ...

wifi: ath12k: use select for CRYPTO_MICHAEL_MIC

Let ath12k select this option automatically which makes building
more intuitive if the user enables this driver (rather than the
driver not building u

wifi: ath12k: use select for CRYPTO_MICHAEL_MIC

Let ath12k select this option automatically which makes building
more intuitive if the user enables this driver (rather than the
driver not building unless CRYPTO_MICHAEL_MIC is explicitly enabled).

Further investigation shows that ath11k and ath12k are the only who use
'depends on' with CRYPTO_MICHAEL_MIC:

./drivers/net/wireless/intel/ipw2x00/Kconfig: select CRYPTO_MICHAEL_MIC
./drivers/net/wireless/intersil/hostap/Kconfig: select CRYPTO_MICHAEL_MIC
./drivers/net/wireless/intersil/orinoco/Kconfig: select CRYPTO_MICHAEL_MIC
./drivers/net/wireless/ath/ath11k/Kconfig: depends on CRYPTO_MICHAEL_MIC
./drivers/net/wireless/ath/ath12k/Kconfig: depends on CRYPTO_MICHAEL_MIC
./drivers/staging/rtl8192e/Kconfig: select CRYPTO_MICHAEL_MIC
./drivers/staging/ks7010/Kconfig: select CRYPTO_MICHAEL_MIC

Signed-off-by: James Prestwood <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>
Link: https://lore.kernel.org/r/[email protected]

show more ...

wifi: ath12k: driver for Qualcomm Wi-Fi 7 devices

ath12k is a new mac80211 driver for Qualcomm Wi-Fi 7 devices, first
supporting QCN9274 and WCN7850 PCI devices. QCN9274 supports both AP
and statio

wifi: ath12k: driver for Qualcomm Wi-Fi 7 devices

ath12k is a new mac80211 driver for Qualcomm Wi-Fi 7 devices, first
supporting QCN9274 and WCN7850 PCI devices. QCN9274 supports both AP
and station; WCN7850 supports only station mode. Monitor mode is not
(yet) supported. Only PCI bus devices are supported.

ath12k is forked from an earlier version of ath11k. It was simpler to
have a "clean start" for the new generation and not try to share the
code with ath11k. This makes maintenance easier and avoids major
changes in ath11k, which would have significantly increased the risk
of regressions in existing setups.

ath12k uses le32 and cpu_to_le32() macros to handle endian
conversions, instead of using the firmware byte swap feature utilized
by ath11k. There is only one kernel module, named ath12k.ko.

Currently ath12k only supports HE mode (IEEE 802.11ax) or older, but
work is ongoing to add EHT mode (IEEE 802.11be) support.

The size of the driver is ~41 kLOC and 45 files. To make the review
easier, this initial version of ath12k does not support Device Tree,
debugfs or any other extra features. Those will be added later, after
ath12k is accepted to upstream.

The driver is build tested by Intel's kernel test robot with both GCC
and Clang. Sparse reports no warnings. The driver is mostly free of
checkpatch warnings, albeit few of the warnings are omitted on
purpose, list of them here:

https://github.com/qca/qca-swiss-army-knife/blob/master/tools/scripts/ath12k/ath12k-check#L52

The driver has had multiple authors who are listed in alphabetical
order below.

Co-developed-by: Balamurugan Selvarajan <[email protected]>
Signed-off-by: Balamurugan Selvarajan <[email protected]>
Co-developed-by: Baochen Qiang <[email protected]>
Signed-off-by: Baochen Qiang <[email protected]>
Co-developed-by: Bhagavathi Perumal S <[email protected]>
Signed-off-by: Bhagavathi Perumal S <[email protected]>
Co-developed-by: Carl Huang <[email protected]>
Signed-off-by: Carl Huang <[email protected]>
Co-developed-by: Jeff Johnson <[email protected]>
Signed-off-by: Jeff Johnson <[email protected]>
Co-developed-by: Karthikeyan Periyasamy <[email protected]>
Signed-off-by: Karthikeyan Periyasamy <[email protected]>
Co-developed-by: P Praneesh <[email protected]>
Signed-off-by: P Praneesh <[email protected]>
Co-developed-by: Pradeep Kumar Chitrapu <[email protected]>
Signed-off-by: Pradeep Kumar Chitrapu <[email protected]>
Co-developed-by: Ramya Gnanasekar <[email protected]>
Signed-off-by: Ramya Gnanasekar <[email protected]>
Co-developed-by: Sriram R <[email protected]>
Signed-off-by: Sriram R <[email protected]>
Co-developed-by: Vasanthakumar Thiagarajan <[email protected]>
Signed-off-by: Vasanthakumar Thiagarajan <[email protected]>
Co-developed-by: Wen Gong <[email protected]>
Signed-off-by: Wen Gong <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>

show more ...