drm/imx: add internal bridge handling display-timings DT node

i.MX DRM DT bindings allow using either a proper panel / bridge graph to
provide information about connected panels, or just a display-t

drm/imx: add internal bridge handling display-timings DT node

i.MX DRM DT bindings allow using either a proper panel / bridge graph to
provide information about connected panels, or just a display-timings DT
node, describing just the timings and the flags. Add helper bridge
driver supporting the latter usecase. It will be used by both LDB and
parallel-display drivers.

Reviewed-by: Philipp Zabel <[email protected]>
Tested-by: Chris Healy <[email protected]>
Tested-by: Philipp Zabel <[email protected]> # on imx6q-nitrogen6x
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
Signed-off-by: Dmitry Baryshkov <[email protected]>

show more ...

drm/bridge: imx: add bridge wrapper driver for i.MX8MP DWC HDMI

Add a simple wrapper driver for the DWC HDMI bridge driver that
implements the few bits that are necessary to abstract the i.MX8MP
SoC

drm/bridge: imx: add bridge wrapper driver for i.MX8MP DWC HDMI

Add a simple wrapper driver for the DWC HDMI bridge driver that
implements the few bits that are necessary to abstract the i.MX8MP
SoC integration.

Signed-off-by: Lucas Stach <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Tested-by: Marek Vasut <[email protected]>
Tested-by: Adam Ford <[email protected]> #imx8mp-beacon
Tested-by: Richard Leitner <[email protected]>
Tested-by: Frieder Schrempf <[email protected]>
Tested-by: Luca Ceresoli <[email protected]>
Signed-off-by: Adam Ford <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Neil Armstrong <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: add driver for HDMI TX Parallel Video Interface

This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a
full timing generator and can switch between different vide

drm/bridge: imx: add driver for HDMI TX Parallel Video Interface

This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a
full timing generator and can switch between different video sources. On
the i.MX8MP however the only supported source is the LCDIF. The block
just needs to be powered up and told about the polarity of the video
sync signals to act in bypass mode.

Signed-off-by: Lucas Stach <[email protected]>
Reviewed-by: Luca Ceresoli <[email protected]>
Tested-by: Marek Vasut <[email protected]>
Tested-by: Luca Ceresoli <[email protected]>
Tested-by: Richard Leitner <[email protected]>
Tested-by: Frieder Schrempf <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Reviewed-by: Luca Ceresoli <[email protected]>
Tested-by: Luca Ceresoli <[email protected]>
Tested-by: Fabio Estevam <[email protected]>
Signed-off-by: Adam Ford <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Neil Armstrong <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add i.MX93 MIPI DSI support

Freescale i.MX93 SoC embeds a Synopsys Designware MIPI DSI host
controller and a Synopsys Designware MIPI DPHY. Some configurations
and extensions to th

drm/bridge: imx: Add i.MX93 MIPI DSI support

Freescale i.MX93 SoC embeds a Synopsys Designware MIPI DSI host
controller and a Synopsys Designware MIPI DPHY. Some configurations
and extensions to them are controlled by i.MX93 media blk-ctrl.

Add a DRM bridge for i.MX93 MIPI DSI by using existing DW MIPI DSI
bridge helpers and implementing i.MX93 MIPI DSI specific extensions.

Signed-off-by: Liu Ying <[email protected]>
Reviewed-by: Robert Foss <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: turn imx8{qm,qxp}-ldb into single-object modules

With the previous fix, these modules are built from a single C file.

Rename the source files so they match the module names.

Signe

drm/bridge: imx: turn imx8{qm,qxp}-ldb into single-object modules

With the previous fix, these modules are built from a single C file.

Rename the source files so they match the module names.

Signed-off-by: Masahiro Yamada <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Reviewed-by: Liu Ying <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: fix mixed module-builtin object

With CONFIG_DRM_IMX8QM_LDB=m and CONFIG_DRM_IMX8QXP_LDB=y (or vice
versa), imx-ldb-helper.o is linked to a module and also to vmlinux
even though the

drm/bridge: imx: fix mixed module-builtin object

With CONFIG_DRM_IMX8QM_LDB=m and CONFIG_DRM_IMX8QXP_LDB=y (or vice
versa), imx-ldb-helper.o is linked to a module and also to vmlinux
even though the expected CFLAGS are different between builtins and
modules.

This is the same situation as fixed by commit 637a642f5ca5 ("zstd:
Fixing mixed module-builtin objects").

Split imx-ldb-helper.c into a separate module.

Signed-off-by: Masahiro Yamada <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Reviewed-by: Liu Ying <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add LDB support for i.MX8qm

This patch adds a drm bridge driver for i.MX8qm LVDS display bridge(LDB)
which is officially named as pixel mapper. The LDB has two channels.
Each of th

drm/bridge: imx: Add LDB support for i.MX8qm

This patch adds a drm bridge driver for i.MX8qm LVDS display bridge(LDB)
which is officially named as pixel mapper. The LDB has two channels.
Each of them supports up to 30bpp parallel input color format and can
map the input to VESA or JEIDA standards. The two channels can be used
simultaneously, either in dual mode or split mode. In dual mode, the
two channels output identical data. In split mode, channel0 outputs
odd pixels and channel1 outputs even pixels. This patch supports the
LDB single mode and split mode.

Tested-by: Marcel Ziswiler <[email protected]> # Colibri iMX8X, LT170410-2WHC, LP156WF1
Reviewed-by: Robert Foss <[email protected]>
Signed-off-by: Liu Ying <[email protected]>
Acked-by: Sakari Ailus <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add LDB support for i.MX8qxp

This patch adds a drm bridge driver for i.MX8qxp LVDS display bridge(LDB)
which is officially named as pixel mapper. The LDB has two channels.
Each of

drm/bridge: imx: Add LDB support for i.MX8qxp

This patch adds a drm bridge driver for i.MX8qxp LVDS display bridge(LDB)
which is officially named as pixel mapper. The LDB has two channels.
Each of them supports up to 24bpp parallel input color format and can map
the input to VESA or JEIDA standards. The two channels cannot be used
simultaneously, that is to say, the user should pick one of them to use.
Two LDB channels from two LDB instances can work together in LDB split
mode to support a dual link LVDS display. The channel indexes have to be
different. Channel0 outputs odd pixels and channel1 outputs even pixels.
This patch supports the LDB single mode and split mode.

Tested-by: Marcel Ziswiler <[email protected]> # Colibri iMX8X, LT170410-2WHC, LP156WF1
Reviewed-by: Robert Foss <[email protected]>
Signed-off-by: Liu Ying <[email protected]>
Acked-by: Sakari Ailus <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add i.MX8qxp pixel link to DPI support

This patch adds a drm bridge driver for i.MX8qxp pixel link to display
pixel interface(PXL2DPI). The PXL2DPI interfaces the pixel link 36-bit

drm/bridge: imx: Add i.MX8qxp pixel link to DPI support

This patch adds a drm bridge driver for i.MX8qxp pixel link to display
pixel interface(PXL2DPI). The PXL2DPI interfaces the pixel link 36-bit
data output and the DSI controller’s MIPI-DPI 24-bit data input, and
inputs of LVDS Display Bridge(LDB) module used in LVDS mode, to remap
the pixel color codings between those modules. The PXL2DPI is purely
combinatorial.

Tested-by: Marcel Ziswiler <[email protected]> # Colibri iMX8X, LT170410-2WHC, LP156WF1
Reviewed-by: Robert Foss <[email protected]>
Signed-off-by: Liu Ying <[email protected]>
Acked-by: Sakari Ailus <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add i.MX8qm/qxp display pixel link support

This patch adds a drm bridge driver for i.MX8qm/qxp display pixel link.
The pixel link forms a standard asynchronous linkage between
pixel

drm/bridge: imx: Add i.MX8qm/qxp display pixel link support

This patch adds a drm bridge driver for i.MX8qm/qxp display pixel link.
The pixel link forms a standard asynchronous linkage between
pixel sources(display controller or camera module) and pixel
consumers(imaging or displays). It consists of two distinct
functions, a pixel transfer function and a control interface.

Reviewed-by: Robert Foss <[email protected]>
Tested-by: Marcel Ziswiler <[email protected]> # Colibri iMX8X, LT170410-2WHC, LP156WF1
Signed-off-by: Liu Ying <[email protected]>
Acked-by: Sakari Ailus <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...

drm/bridge: imx: Add i.MX8qm/qxp pixel combiner support

This patch adds a drm bridge driver for i.MX8qm/qxp pixel combiner.
The pixel combiner takes two output streams from a single display
controll

drm/bridge: imx: Add i.MX8qm/qxp pixel combiner support

This patch adds a drm bridge driver for i.MX8qm/qxp pixel combiner.
The pixel combiner takes two output streams from a single display
controller and manipulates the two streams to support a number
of modes(bypass, pixel combine, YUV444 to YUV422, split_RGB) configured
as either one screen, two screens, or virtual screens. The pixel
combiner is also responsible for generating some of the control signals
for the pixel link output channel. For now, the driver only supports
the bypass mode.

Reviewed-by: Robert Foss <[email protected]>
Tested-by: Marcel Ziswiler <[email protected]> # Colibri iMX8X, LT170410-2WHC, LP156WF1
Signed-off-by: Liu Ying <[email protected]>
Acked-by: Sakari Ailus <[email protected]>
Signed-off-by: Robert Foss <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

show more ...