1 /* 2 * consumer.h -- SoC Regulator consumer support. 3 * 4 * Copyright (C) 2007, 2008 Wolfson Microelectronics PLC. 5 * 6 * Author: Liam Girdwood <[email protected]> 7 * 8 * This program is free software; you can redistribute it and/or modify 9 * it under the terms of the GNU General Public License version 2 as 10 * published by the Free Software Foundation. 11 * 12 * Regulator Consumer Interface. 13 * 14 * A Power Management Regulator framework for SoC based devices. 15 * Features:- 16 * o Voltage and current level control. 17 * o Operating mode control. 18 * o Regulator status. 19 * o sysfs entries for showing client devices and status 20 * 21 * EXPERIMENTAL FEATURES: 22 * Dynamic Regulator operating Mode Switching (DRMS) - allows regulators 23 * to use most efficient operating mode depending upon voltage and load and 24 * is transparent to client drivers. 25 * 26 * e.g. Devices x,y,z share regulator r. Device x and y draw 20mA each during 27 * IO and 1mA at idle. Device z draws 100mA when under load and 5mA when 28 * idling. Regulator r has > 90% efficiency in NORMAL mode at loads > 100mA 29 * but this drops rapidly to 60% when below 100mA. Regulator r has > 90% 30 * efficiency in IDLE mode at loads < 10mA. Thus regulator r will operate 31 * in normal mode for loads > 10mA and in IDLE mode for load <= 10mA. 32 * 33 */ 34 35 #ifndef __LINUX_REGULATOR_CONSUMER_H_ 36 #define __LINUX_REGULATOR_CONSUMER_H_ 37 38 #include <linux/device.h> 39 40 /* 41 * Regulator operating modes. 42 * 43 * Regulators can run in a variety of different operating modes depending on 44 * output load. This allows further system power savings by selecting the 45 * best (and most efficient) regulator mode for a desired load. 46 * 47 * Most drivers will only care about NORMAL. The modes below are generic and 48 * will probably not match the naming convention of your regulator data sheet 49 * but should match the use cases in the datasheet. 50 * 51 * In order of power efficiency (least efficient at top). 52 * 53 * Mode Description 54 * FAST Regulator can handle fast changes in it's load. 55 * e.g. useful in CPU voltage & frequency scaling where 56 * load can quickly increase with CPU frequency increases. 57 * 58 * NORMAL Normal regulator power supply mode. Most drivers will 59 * use this mode. 60 * 61 * IDLE Regulator runs in a more efficient mode for light 62 * loads. Can be used for devices that have a low power 63 * requirement during periods of inactivity. This mode 64 * may be more noisy than NORMAL and may not be able 65 * to handle fast load switching. 66 * 67 * STANDBY Regulator runs in the most efficient mode for very 68 * light loads. Can be used by devices when they are 69 * in a sleep/standby state. This mode is likely to be 70 * the most noisy and may not be able to handle fast load 71 * switching. 72 * 73 * NOTE: Most regulators will only support a subset of these modes. Some 74 * will only just support NORMAL. 75 * 76 * These modes can be OR'ed together to make up a mask of valid register modes. 77 */ 78 79 #define REGULATOR_MODE_FAST 0x1 80 #define REGULATOR_MODE_NORMAL 0x2 81 #define REGULATOR_MODE_IDLE 0x4 82 #define REGULATOR_MODE_STANDBY 0x8 83 84 /* 85 * Regulator notifier events. 86 * 87 * UNDER_VOLTAGE Regulator output is under voltage. 88 * OVER_CURRENT Regulator output current is too high. 89 * REGULATION_OUT Regulator output is out of regulation. 90 * FAIL Regulator output has failed. 91 * OVER_TEMP Regulator over temp. 92 * FORCE_DISABLE Regulator forcibly shut down by software. 93 * VOLTAGE_CHANGE Regulator voltage changed. 94 * DISABLE Regulator was disabled. 95 * 96 * NOTE: These events can be OR'ed together when passed into handler. 97 */ 98 99 #define REGULATOR_EVENT_UNDER_VOLTAGE 0x01 100 #define REGULATOR_EVENT_OVER_CURRENT 0x02 101 #define REGULATOR_EVENT_REGULATION_OUT 0x04 102 #define REGULATOR_EVENT_FAIL 0x08 103 #define REGULATOR_EVENT_OVER_TEMP 0x10 104 #define REGULATOR_EVENT_FORCE_DISABLE 0x20 105 #define REGULATOR_EVENT_VOLTAGE_CHANGE 0x40 106 #define REGULATOR_EVENT_DISABLE 0x80 107 108 struct regulator; 109 110 /** 111 * struct regulator_bulk_data - Data used for bulk regulator operations. 112 * 113 * @supply: The name of the supply. Initialised by the user before 114 * using the bulk regulator APIs. 115 * @consumer: The regulator consumer for the supply. This will be managed 116 * by the bulk API. 117 * 118 * The regulator APIs provide a series of regulator_bulk_() API calls as 119 * a convenience to consumers which require multiple supplies. This 120 * structure is used to manage data for these calls. 121 */ 122 struct regulator_bulk_data { 123 const char *supply; 124 struct regulator *consumer; 125 126 /* private: Internal use */ 127 int ret; 128 }; 129 130 #if defined(CONFIG_REGULATOR) 131 132 /* regulator get and put */ 133 struct regulator *__must_check regulator_get(struct device *dev, 134 const char *id); 135 struct regulator *__must_check regulator_get_exclusive(struct device *dev, 136 const char *id); 137 void regulator_put(struct regulator *regulator); 138 139 /* regulator output control and status */ 140 int regulator_enable(struct regulator *regulator); 141 int regulator_disable(struct regulator *regulator); 142 int regulator_force_disable(struct regulator *regulator); 143 int regulator_is_enabled(struct regulator *regulator); 144 int regulator_disable_deferred(struct regulator *regulator, int ms); 145 146 int regulator_bulk_get(struct device *dev, int num_consumers, 147 struct regulator_bulk_data *consumers); 148 int regulator_bulk_enable(int num_consumers, 149 struct regulator_bulk_data *consumers); 150 int regulator_bulk_disable(int num_consumers, 151 struct regulator_bulk_data *consumers); 152 void regulator_bulk_free(int num_consumers, 153 struct regulator_bulk_data *consumers); 154 155 int regulator_count_voltages(struct regulator *regulator); 156 int regulator_list_voltage(struct regulator *regulator, unsigned selector); 157 int regulator_is_supported_voltage(struct regulator *regulator, 158 int min_uV, int max_uV); 159 int regulator_set_voltage(struct regulator *regulator, int min_uV, int max_uV); 160 int regulator_set_voltage_time(struct regulator *regulator, 161 int old_uV, int new_uV); 162 int regulator_get_voltage(struct regulator *regulator); 163 int regulator_sync_voltage(struct regulator *regulator); 164 int regulator_set_current_limit(struct regulator *regulator, 165 int min_uA, int max_uA); 166 int regulator_get_current_limit(struct regulator *regulator); 167 168 int regulator_set_mode(struct regulator *regulator, unsigned int mode); 169 unsigned int regulator_get_mode(struct regulator *regulator); 170 int regulator_set_optimum_mode(struct regulator *regulator, int load_uA); 171 172 /* regulator notifier block */ 173 int regulator_register_notifier(struct regulator *regulator, 174 struct notifier_block *nb); 175 int regulator_unregister_notifier(struct regulator *regulator, 176 struct notifier_block *nb); 177 178 /* driver data - core doesn't touch */ 179 void *regulator_get_drvdata(struct regulator *regulator); 180 void regulator_set_drvdata(struct regulator *regulator, void *data); 181 182 #else 183 184 /* 185 * Make sure client drivers will still build on systems with no software 186 * controllable voltage or current regulators. 187 */ 188 static inline struct regulator *__must_check regulator_get(struct device *dev, 189 const char *id) 190 { 191 /* Nothing except the stubbed out regulator API should be 192 * looking at the value except to check if it is an error 193 * value. Drivers are free to handle NULL specifically by 194 * skipping all regulator API calls, but they don't have to. 195 * Drivers which don't, should make sure they properly handle 196 * corner cases of the API, such as regulator_get_voltage() 197 * returning 0. 198 */ 199 return NULL; 200 } 201 static inline void regulator_put(struct regulator *regulator) 202 { 203 } 204 205 static inline int regulator_enable(struct regulator *regulator) 206 { 207 return 0; 208 } 209 210 static inline int regulator_disable(struct regulator *regulator) 211 { 212 return 0; 213 } 214 215 static inline int regulator_disable_deferred(struct regulator *regulator, 216 int ms) 217 { 218 return 0; 219 } 220 221 static inline int regulator_is_enabled(struct regulator *regulator) 222 { 223 return 1; 224 } 225 226 static inline int regulator_bulk_get(struct device *dev, 227 int num_consumers, 228 struct regulator_bulk_data *consumers) 229 { 230 return 0; 231 } 232 233 static inline int regulator_bulk_enable(int num_consumers, 234 struct regulator_bulk_data *consumers) 235 { 236 return 0; 237 } 238 239 static inline int regulator_bulk_disable(int num_consumers, 240 struct regulator_bulk_data *consumers) 241 { 242 return 0; 243 } 244 245 static inline void regulator_bulk_free(int num_consumers, 246 struct regulator_bulk_data *consumers) 247 { 248 } 249 250 static inline int regulator_set_voltage(struct regulator *regulator, 251 int min_uV, int max_uV) 252 { 253 return 0; 254 } 255 256 static inline int regulator_get_voltage(struct regulator *regulator) 257 { 258 return 0; 259 } 260 261 static inline int regulator_set_current_limit(struct regulator *regulator, 262 int min_uA, int max_uA) 263 { 264 return 0; 265 } 266 267 static inline int regulator_get_current_limit(struct regulator *regulator) 268 { 269 return 0; 270 } 271 272 static inline int regulator_set_mode(struct regulator *regulator, 273 unsigned int mode) 274 { 275 return 0; 276 } 277 278 static inline unsigned int regulator_get_mode(struct regulator *regulator) 279 { 280 return REGULATOR_MODE_NORMAL; 281 } 282 283 static inline int regulator_set_optimum_mode(struct regulator *regulator, 284 int load_uA) 285 { 286 return REGULATOR_MODE_NORMAL; 287 } 288 289 static inline int regulator_register_notifier(struct regulator *regulator, 290 struct notifier_block *nb) 291 { 292 return 0; 293 } 294 295 static inline int regulator_unregister_notifier(struct regulator *regulator, 296 struct notifier_block *nb) 297 { 298 return 0; 299 } 300 301 static inline void *regulator_get_drvdata(struct regulator *regulator) 302 { 303 return NULL; 304 } 305 306 static inline void regulator_set_drvdata(struct regulator *regulator, 307 void *data) 308 { 309 } 310 311 #endif 312 313 #endif 314