1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Micrel device configuration 4# 5 6config NET_VENDOR_MICREL 7 bool "Micrel devices" 8 default y 9 depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM 10 help 11 If you have a network (Ethernet) card belonging to this class, say Y. 12 13 Note that the answer to this question doesn't directly affect the 14 kernel: saying N will just cause the configurator to skip all 15 the questions about Micrel devices. If you say Y, you will be asked 16 for your specific card in the following questions. 17 18if NET_VENDOR_MICREL 19 20config KS8842 21 tristate "Micrel KSZ8841/42 with generic bus interface" 22 depends on HAS_IOMEM && DMA_ENGINE 23 help 24 This platform driver is for KSZ8841(1-port) / KS8842(2-port) 25 ethernet switch chip (managed, VLAN, QoS) from Micrel or 26 Timberdale(FPGA). 27 28config KS8851 29 tristate "Micrel KS8851 SPI" 30 depends on SPI 31 select MII 32 select CRC32 33 select EEPROM_93CX6 34 select PHYLIB 35 select MICREL_PHY 36 help 37 SPI driver for Micrel KS8851 SPI attached network chip. 38 39config KS8851_MLL 40 tristate "Micrel KS8851 MLL" 41 depends on HAS_IOMEM 42 depends on PTP_1588_CLOCK_OPTIONAL 43 select MII 44 select CRC32 45 select EEPROM_93CX6 46 select PHYLIB 47 select MICREL_PHY 48 help 49 This platform driver is for Micrel KS8851 Address/data bus 50 multiplexed network chip. 51 52config KSZ884X_PCI 53 tristate "Micrel KSZ8841/2 PCI" 54 depends on PCI 55 select MII 56 select CRC32 57 help 58 This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. 59 60 To compile this driver as a module, choose M here. The module 61 will be called ksz884x. 62 63endif # NET_VENDOR_MICREL 64