1/dts-v1/; 2 3/include/ "rt3050.dtsi" 4 5/ { 6 compatible = "FREESTATION5", "ralink,rt3050-soc"; 7 model = "ARC FreeStation5"; 8 9 chosen { 10 bootargs = "console=ttyS0,115200"; 11 }; 12 13 pinctrl { 14 state_default: pinctrl0 { 15 gpio { 16 ralink,group = "spi", "i2c", "jtag", "rgmii", "mdio", "uartf"; 17 ralink,function = "gpio"; 18 }; 19 }; 20 }; 21 22 cfi@1f000000 { 23 compatible = "cfi-flash"; 24 reg = <0x1f000000 0x800000>; 25 bank-width = <2>; 26 device-width = <2>; 27 #address-cells = <1>; 28 #size-cells = <1>; 29 30 partition@0 { 31 label = "u-boot"; 32 reg = <0x0 0x30000>; 33 read-only; 34 }; 35 36 partition@30000 { 37 label = "u-boot-env"; 38 reg = <0x30000 0x10000>; 39 read-only; 40 }; 41 42 factory: partition@40000 { 43 label = "factory"; 44 reg = <0x40000 0x10000>; 45 read-only; 46 }; 47 48 partition@50000 { 49 label = "firmware"; 50 reg = <0x50000 0x7b0000>; 51 }; 52 }; 53 54 ethernet@10100000 { 55 mtd-mac-address = <&factory 0x4>; 56 }; 57 58 esw@10110000 { 59 mediatek,portmap = <0x01>; 60 }; 61 62 wmac@10180000 { 63 ralink,mtd-eeprom = <&factory 0>; 64 }; 65 66 otg@101c0000 { 67 status = "okay"; 68 }; 69 70 gpio-export { 71 compatible = "gpio-export"; 72 73 // Used to enable power-over-ethernet passthrough from port0 to port1. 74 // Disable passthrough by default to prevent accidental equipment damage. 75 poe { 76 gpio-export,name = "poe-passthrough"; 77 gpio-export,output = <1>; // OUT_INIT_HIGH 78 gpios = <&gpio0 11 1>; // GPIO 11, ACTIVE_LOW 79 }; 80 }; 81 82 gpio-leds { 83 compatible = "gpio-leds"; 84 85 // The following leds are defined in the ArcOS firmware, but reportedly 86 // not present in the Freestation5 device. 87 wifi { 88 label = "freestation5:unknown:wifi"; 89 gpios = <&gpio0 7 1>; 90 }; 91 92 powerg { 93 label = "freestation5:unknown:powerg"; 94 gpios = <&gpio0 9 1>; 95 }; 96 97 usb { 98 label = "freestation5:unknown:usb"; 99 gpios = <&gpio0 14 1>; 100 }; 101 }; 102}; 103