xref: /f-stack/dpdk/lib/librte_eal/linux/eal_timer.c (revision 2d9fd380)

/* SPDX-License-Identifier: BSD-3-Clause
 * Copyright(c) 2010-2014 Intel Corporation.
 * Copyright(c) 2012-2013 6WIND S.A.
 */

#include <string.h>
#include <stdlib.h>
#include <stdio.h>
#include <stdint.h>
#include <unistd.h>
#include <fcntl.h>
#include <inttypes.h>
#include <sys/mman.h>
#include <sys/queue.h>
#include <pthread.h>
#include <errno.h>

#include <rte_common.h>
#include <rte_log.h>
#include <rte_cycles.h>
#include <rte_lcore.h>
#include <rte_memory.h>
#include <rte_eal.h>
#include <rte_debug.h>

#include "eal_private.h"
#include "eal_internal_cfg.h"

enum timer_source eal_timer_source = EAL_TIMER_HPET;

#ifdef RTE_LIBEAL_USE_HPET

#define DEV_HPET "/dev/hpet"

/* Maximum number of counters. */
#define HPET_TIMER_NUM 3

/* General capabilities register */
#define CLK_PERIOD_SHIFT     32 /* Clock period shift. */
#define CLK_PERIOD_MASK      0xffffffff00000000ULL /* Clock period mask. */

/**
 * HPET timer registers. From the Intel IA-PC HPET (High Precision Event
 * Timers) Specification.
 */
struct eal_hpet_regs {
	/* Memory-mapped, software visible registers */
	uint64_t capabilities;      /**< RO General Capabilities Register. */
	uint64_t reserved0;         /**< Reserved for future use. */
	uint64_t config;            /**< RW General Configuration Register. */
	uint64_t reserved1;         /**< Reserved for future use. */
	uint64_t isr;               /**< RW Clear General Interrupt Status. */
	uint64_t reserved2[25];     /**< Reserved for future use. */
	union {
		uint64_t counter;   /**< RW Main Counter Value Register. */
		struct {
			uint32_t counter_l; /**< RW Main Counter Low. */
			uint32_t counter_h; /**< RW Main Counter High. */
		};
	};
	uint64_t reserved3;         /**< Reserved for future use. */
	struct {
		uint64_t config;    /**< RW Timer Config and Capability Reg. */
		uint64_t comp;      /**< RW Timer Comparator Value Register. */
		uint64_t fsb;       /**< RW FSB Interrupt Route Register. */
		uint64_t reserved4; /**< Reserved for future use. */
	} timers[HPET_TIMER_NUM]; /**< Set of HPET timers. */
};

/* Mmap'd hpet registers */
static volatile struct eal_hpet_regs *eal_hpet = NULL;

/* Period at which the HPET counter increments in
 * femtoseconds (10^-15 seconds). */
static uint32_t eal_hpet_resolution_fs = 0;

/* Frequency of the HPET counter in Hz */
static uint64_t eal_hpet_resolution_hz = 0;

/* Incremented 4 times during one 32bits hpet full count */
static uint32_t eal_hpet_msb;

static pthread_t msb_inc_thread_id;

/*
 * This function runs on a specific thread to update a global variable
 * containing used to process MSB of the HPET (unfortunately, we need
 * this because hpet is 32 bits by default under linux).
 */
static void *
hpet_msb_inc(__rte_unused void *arg)
{
	uint32_t t;

	while (1) {
		t = (eal_hpet->counter_l >> 30);
		if (t != (eal_hpet_msb & 3))
			eal_hpet_msb ++;
		sleep(10);
	}
	return NULL;
}

uint64_t
rte_get_hpet_hz(void)
{
	const struct internal_config *internal_conf =
		eal_get_internal_configuration();

	if (internal_conf->no_hpet)
		rte_panic("Error, HPET called, but no HPET present\n");

	return eal_hpet_resolution_hz;
}

uint64_t
rte_get_hpet_cycles(void)
{
	uint32_t t, msb;
	uint64_t ret;
	const struct internal_config *internal_conf =
		eal_get_internal_configuration();

	if (internal_conf->no_hpet)
		rte_panic("Error, HPET called, but no HPET present\n");

	t = eal_hpet->counter_l;
	msb = eal_hpet_msb;
	ret = (msb + 2 - (t >> 30)) / 4;
	ret <<= 32;
	ret += t;
	return ret;
}

#endif

#ifdef RTE_LIBEAL_USE_HPET
/*
 * Open and mmap /dev/hpet (high precision event timer) that will
 * provide our time reference.
 */
int
rte_eal_hpet_init(int make_default)
{
	int fd, ret;
	struct internal_config *internal_conf =
		eal_get_internal_configuration();

	if (internal_conf->no_hpet) {
		RTE_LOG(NOTICE, EAL, "HPET is disabled\n");
		return -1;
	}

	fd = open(DEV_HPET, O_RDONLY);
	if (fd < 0) {
		RTE_LOG(ERR, EAL, "ERROR: Cannot open "DEV_HPET": %s!\n",
			strerror(errno));
		internal_conf->no_hpet = 1;
		return -1;
	}
	eal_hpet = mmap(NULL, 1024, PROT_READ, MAP_SHARED, fd, 0);
	if (eal_hpet == MAP_FAILED) {
		RTE_LOG(ERR, EAL, "ERROR: Cannot mmap "DEV_HPET"!\n"
				"Please enable CONFIG_HPET_MMAP in your kernel configuration "
				"to allow HPET support.\n"
				"To run without using HPET, unset RTE_LIBEAL_USE_HPET "
				"in your build configuration or use '--no-hpet' EAL flag.\n");
		close(fd);
		internal_conf->no_hpet = 1;
		return -1;
	}
	close(fd);

	eal_hpet_resolution_fs = (uint32_t)((eal_hpet->capabilities &
					CLK_PERIOD_MASK) >>
					CLK_PERIOD_SHIFT);

	eal_hpet_resolution_hz = (1000ULL*1000ULL*1000ULL*1000ULL*1000ULL) /
		(uint64_t)eal_hpet_resolution_fs;

	RTE_LOG(INFO, EAL, "HPET frequency is ~%"PRIu64" kHz\n",
			eal_hpet_resolution_hz/1000);

	eal_hpet_msb = (eal_hpet->counter_l >> 30);

	/* create a thread that will increment a global variable for
	 * msb (hpet is 32 bits by default under linux) */
	ret = rte_ctrl_thread_create(&msb_inc_thread_id, "hpet-msb-inc", NULL,
				     hpet_msb_inc, NULL);
	if (ret != 0) {
		RTE_LOG(ERR, EAL, "ERROR: Cannot create HPET timer thread!\n");
		internal_conf->no_hpet = 1;
		return -1;
	}

	if (make_default)
		eal_timer_source = EAL_TIMER_HPET;
	return 0;
}
#endif

uint64_t
get_tsc_freq(void)
{
#ifdef CLOCK_MONOTONIC_RAW
#define NS_PER_SEC 1E9
#define CYC_PER_10MHZ 1E7

	struct timespec sleeptime = {.tv_nsec = NS_PER_SEC / 10 }; /* 1/10 second */

	struct timespec t_start, t_end;
	uint64_t tsc_hz;

	if (clock_gettime(CLOCK_MONOTONIC_RAW, &t_start) == 0) {
		uint64_t ns, end, start = rte_rdtsc();
		nanosleep(&sleeptime,NULL);
		clock_gettime(CLOCK_MONOTONIC_RAW, &t_end);
		end = rte_rdtsc();
		ns = ((t_end.tv_sec - t_start.tv_sec) * NS_PER_SEC);
		ns += (t_end.tv_nsec - t_start.tv_nsec);

		double secs = (double)ns/NS_PER_SEC;
		tsc_hz = (uint64_t)((end - start)/secs);
		/* Round up to 10Mhz. 1E7 ~ 10Mhz */
		return RTE_ALIGN_MUL_NEAR(tsc_hz, CYC_PER_10MHZ);
	}
#endif
	return 0;
}

int
rte_eal_timer_init(void)
{

	eal_timer_source = EAL_TIMER_TSC;

	set_tsc_freq();
	return 0;
}