| /f-stack/freebsd/contrib/device-tree/Bindings/power/ |
| H A D | domain-idle-state.yaml | 32 The worst case latency in microseconds required to enter the idle
38 The worst case latency in microseconds required to exit the idle
43 The minimum residency duration in microseconds after which the idle
|
| /f-stack/freebsd/contrib/device-tree/Bindings/net/ |
| H A D | mdio.yaml | 38 RESET pulse width in microseconds. It applies to all MDIO devices
44 Delay after reset deassert in microseconds. It applies to all MDIO
92 Delay after the reset was asserted in microseconds. If this
97 Delay after the reset was deasserted in microseconds. If
|
| H A D | ethernet-phy.yaml | 152 Delay after the reset was asserted in microseconds. If this
157 Delay after the reset was deasserted in microseconds. If
|
| /f-stack/freebsd/contrib/device-tree/Bindings/i2c/ |
| H A D | i2c-arb-gpio-challenge.txt | 34 microseconds).
50 - slew-delay-us: microseconds to wait for a GPIO to go high. Default is 10 us.
51 - wait-retry-us: we'll attempt another claim after this many microseconds.
53 - wait-free-us: we'll give up after this many microseconds. Default is 50000 us.
|
| H A D | i2c-mpc.txt | 21 - fsl,timeout : I2C bus timeout in microseconds.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/mfd/ |
| H A D | max77620.txt | 91 -maxim,shutdown-fps-time-period-us: u32, FPS time period in microseconds
95 -maxim,suspend-fps-time-period-us: u32, FPS time period in microseconds
111 Here supported time periods by device in microseconds are as follows:
112 MAX77620 supports 40, 80, 160, 320, 640, 1280, 2560 and 5120 microseconds.
113 MAX20024 supports 20, 40, 80, 160, 320, 640, 1280 and 2540 microseconds.
114 MAX77663 supports 20, 40, 80, 160, 320, 640, 1280 and 2540 microseconds.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/regulator/ |
| H A D | fixed-regulator.yaml | 50 description: startup time in microseconds
54 description: off delay time in microseconds
|
| H A D | regulator.yaml | 64 description: The time taken, in microseconds, for the supply rail to
73 description: Settling time, in microseconds, for voltage change if regulator
78 description: Settling time, in microseconds, for voltage increase if
84 description: Settling time, in microseconds, for voltage decrease if
|
| H A D | tps65132-regulator.txt | 22 asserted for during active discharge, in microseconds.
|
| H A D | gpio-regulator.yaml | 67 description: startup time in microseconds
|
| /f-stack/freebsd/contrib/device-tree/Bindings/input/ |
| H A D | qcom,pm8xxx-keypad.txt | 57 Definition: time in microseconds that key must be pressed or release
63 Definition: time in microseconds to pause between successive scans
|
| H A D | qcom,pm8xxx-pwrkey.txt | 28 Definition: time in microseconds that key must be pressed or release
|
| H A D | qcom,pm8941-pwrkey.txt | 27 Definition: time in microseconds that key must be pressed or released
|
| H A D | st-keyscan.txt | 28 - st,debounce_us: Debouncing interval time in microseconds
|
| H A D | gpio-matrix-keypad.txt | 25 - col-scan-delay-us: delay, measured in microseconds, that is needed
|
| /f-stack/freebsd/contrib/device-tree/Bindings/iio/adc/ |
| H A D | at91_adc.txt | 13 - atmel,adc-startup-time: Startup Time of the ADC in microseconds as
28 - atmel,adc-sample-hold-time: Sample and Hold Time in microseconds
|
| /f-stack/freebsd/contrib/device-tree/Bindings/rng/ |
| H A D | timeriomem_rng.txt | 6 - period : wait time in microseconds to use between samples
|
| /f-stack/freebsd/contrib/dev/acpica/os_specific/service_layers/ |
| H A D | osunixxf.c | 1245 UINT32 microseconds) in AcpiOsStall() argument
1248 if (microseconds) in AcpiOsStall()
1250 usleep (microseconds); in AcpiOsStall()
|
| /f-stack/freebsd/contrib/device-tree/Bindings/spi/ |
| H A D | spi-controller.yaml | 126 Delay, in microseconds, after a read transfer.
137 Delay, in microseconds, after a write transfer.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/sound/ |
| H A D | ti,tas5086.txt | 14 - ti,charge-period: This property should contain the time in microseconds
|
| /f-stack/freebsd/contrib/device-tree/Bindings/watchdog/ |
| H A D | aspeed-wdt.txt | 41 - aspeed,ext-pulse-duration: External signal pulse duration in microseconds
|
| /f-stack/ |
| H A D | config.ini | 28 # unit: microseconds
35 # unit: microseconds
|
| /f-stack/freebsd/contrib/device-tree/Bindings/leds/ |
| H A D | ams,as3645a.txt | 26 flash-timeout-us: Flash timeout in microseconds. The value must be in
|
| /f-stack/freebsd/contrib/device-tree/Bindings/pci/ |
| H A D | nvidia,tegra194-pcie.txt | 116 to be specified in microseconds
118 specified in microseconds
120 specified in microseconds
|
| /f-stack/freebsd/contrib/device-tree/Bindings/ptp/ |
| H A D | ptp-qoriq.txt | 38 PulseWidth = 1 / OutputClock microseconds
|