| /linux-6.15/Documentation/devicetree/bindings/regulator/ |
| H A D | rohm,bd96801-regulator.yaml | 33 Initial voltage for regulator. Voltage can be tuned +/-150 mV from
50 Initial voltage for regulator. Voltage can be tuned +/-150 mV from
|
| /linux-6.15/Documentation/userspace-api/media/dvb/ |
| H A D | frontend-stat-properties.rst | 109 channel/transponder is tuned.
137 channel/transponder is tuned.
166 channel/transponder is tuned.
194 channel/transponder is tuned.
215 channel/transponder is tuned.
|
| H A D | fe-read-status.rst | 37 tuned. The ioctl takes a pointer to an integer where the status will be
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-adc-stm32 | 6 (e.g. timers, pwm or exti gpio). Then, it can be tuned to start
|
| /linux-6.15/include/media/drv-intf/ |
| H A D | tea575x.h | 47 bool tuned; /* tuned to a station */ member
|
| /linux-6.15/Documentation/devicetree/bindings/sound/ |
| H A D | nvidia,tegra210-peq.yaml | 11 each filter tuned based on certain parameters. It can be used to
|
| /linux-6.15/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-log-status.rst | 34 dealing with problems like no sound, no video and incorrectly tuned
|
| H A D | ext-ctrls-fm-rx.rst | 60 If set, then the tuned programme carries traffic announcements.
|
| H A D | ext-ctrls-fm-tx.rst | 85 If set, then the tuned programme carries traffic announcements.
|
| /linux-6.15/Documentation/devicetree/bindings/spi/ |
| H A D | spi-rockchip.yaml | 74 (may need to be fine tuned for high capacitance lines).
|
| /linux-6.15/drivers/media/radio/ |
| H A D | tea575x.c | 124 tea->tuned = tea->ops->get_pins(tea) & TEA575X_MOST ? 0 : 1; in snd_tea575x_read()
292 v->signal = tea->tuned ? 0xffff : 0; in snd_tea575x_g_tuner()
|
| /linux-6.15/drivers/staging/media/atomisp/ |
| H A D | TODO | 17 picture, the exposure/gain needs to be tuned using v4l2-ctl on the sensor
|
| /linux-6.15/Documentation/scsi/ |
| H A D | megaraid.rst | 77 as new controller classes get added, this will be tuned appropriately.
|
| /linux-6.15/Documentation/misc-devices/ |
| H A D | apds990x.rst | 38 Platform data can provide tuned values to the conversion formulas if
|
| /linux-6.15/arch/arm64/boot/dts/xilinx/ |
| H A D | zynqmp-sck-kv-g-revB.dtso | 143 &sdhci1 { /* on CC with tuned parameters */
|
| H A D | zynqmp-sck-kv-g-revA.dtso | 142 &sdhci1 { /* on CC with tuned parameters */
|
| /linux-6.15/Documentation/admin-guide/media/ |
| H A D | si476x.rst | 136 0x12 readfreq Current tuned frequency
|
| H A D | bt8xx.rst | 48 are in fact necessary may result in DVB devices that cannot be tuned due
|
| /linux-6.15/Documentation/networking/device_drivers/ethernet/intel/ |
| H A D | idpf.rst | 89 is tuned for general workloads. The user can customize the interrupt rate
|
| H A D | e1000e.rst | 122 properly tuned for specific network traffic. Increasing this value adds extra
151 properly tuned for specific network traffic. If the system is reporting
|
| /linux-6.15/drivers/devfreq/ |
| H A D | Kconfig | 40 values that imply the usage rate. A device may provide tuned
|
| /linux-6.15/Documentation/driver-api/media/drivers/ |
| H A D | radiotrack.rst | 30 value, I wanted to see if the tuner could be tuned beyond the usual FM radio
|
| /linux-6.15/drivers/media/dvb-frontends/ |
| H A D | cx24116.c | 1413 goto tuned; in cx24116_set_frontend()
1425 tuned: /* Set/Reset B/W */ in cx24116_set_frontend()
|
| /linux-6.15/Documentation/admin-guide/hw-vuln/ |
| H A D | l1tf.rst | 481 Conditional L1D flushing is the default behaviour and can be tuned. See
504 Conditional L1D flushing is the default behaviour and can be tuned. See
537 SMT control and L1D flushing can be tuned by the command line
|
| /linux-6.15/Documentation/virt/kvm/ |
| H A D | halt-polling.rst | 120 be tuned on a per vm basis.
|