| /linux-6.15/drivers/md/dm-vdo/indexer/ |
| H A D | index-layout.c | 172 struct index_save_layout *saves; member
389 sil->saves[i].index_save = (struct layout_region) { in setup_sub_index()
658 *lr++ = layout->index.saves[i].index_save; in make_layout_region_table()
784 &layout->index.saves); in create_index_layout()
842 isl = &layout->index.saves[i]; in find_latest_uds_index_save_slot()
944 isl = &layout->index.saves[i]; in select_oldest_index_save_layout()
1290 sil->saves[i].index_save = table->regions[i + 4]; in verify_sub_index()
1296 next_block += sil->saves[i].index_save.block_count; in verify_sub_index()
1315 __func__, &layout->index.saves); in reconstitute_layout()
1572 isl = &layout->index.saves[j]; in load_sub_index_regions()
[all …]
|
| /linux-6.15/drivers/pmdomain/sunxi/ |
| H A D | Kconfig | 9 Say y to enable the PPU power domain driver. This saves power
|
| /linux-6.15/Documentation/iio/ |
| H A D | ad4000.rst | 71 is not possible. This connection mode saves one wire and works with any SPI
91 the previous wiring configuration but saves the use of a CS line.
|
| H A D | bno055.rst | 32 with this calibration data. This saves the user from performing the
|
| /linux-6.15/drivers/net/ethernet/asix/ |
| H A D | Kconfig | 27 Say Y here to enable SPI transfer compression. It saves up
|
| /linux-6.15/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-prepare-buf.rst | 38 in advance saves time during the actual I/O.
|
| H A D | metafmt-intel-ipu3.rst | 25 The struct :c:type:`ipu3_uapi_4a_config` saves all configurable parameters.
|
| /linux-6.15/drivers/memory/samsung/ |
| H A D | Kconfig | 29 in basic operation mode only saves and restores SROM registers
|
| /linux-6.15/arch/arm/mach-omap1/ |
| H A D | Kconfig | 72 This timer saves power compared to the OMAP_MPU_TIMER, and has
104 This option saves power, but assumes all drivers are
|
| /linux-6.15/drivers/net/ethernet/toshiba/ |
| H A D | Kconfig | 38 use wireless feature, disabling this option saves memory. As
|
| /linux-6.15/Documentation/block/ |
| H A D | cmdline-partition.rst | 9 It has no MBR, so saves storage space. Bootloader can be easily accessed
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | pstore | 39 data saved on each oops/panic. Pstore saves (possibly
|
| /linux-6.15/drivers/net/wireless/ath/wil6210/ |
| H A D | Kconfig | 27 it saves extra target transaction;
|
| /linux-6.15/fs/cramfs/ |
| H A D | Kconfig | 43 This saves some memory since no intermediate buffering is
|
| /linux-6.15/Documentation/userspace-api/media/drivers/ |
| H A D | dw100.rst | 76 rightmost/bottommost block is the remainder. The dewarping map only saves
|
| /linux-6.15/Documentation/arch/s390/ |
| H A D | zfcpdump.rst | 9 hardware saves some memory plus the register sets of the boot CPU before the
|
| /linux-6.15/arch/arc/kernel/ |
| H A D | entry.S | 185 ; don't call ret_from_system_call as it saves r0, already done above
|
| /linux-6.15/arch/arm/mm/ |
| H A D | proc-v7m.S | 128 @ point to writeable memory because the processor saves
|
| /linux-6.15/arch/arm64/boot/dts/qcom/ |
| H A D | qcs8550.dtsi | 22 * This will be described as: UEFI saves the physical address of
|
| /linux-6.15/Documentation/gpu/amdgpu/ |
| H A D | thermal.rst | 118 GFXOFF is a feature found in most recent GPUs that saves power at runtime. The
|
| /linux-6.15/Documentation/networking/devlink/ |
| H A D | devlink-health.rst | 104 saves a single dump. If an dump is not already stored by devlink
|
| /linux-6.15/Documentation/filesystems/nfs/ |
| H A D | reexport.rst | 88 filesystem identifier that saves 8 bytes.
|
| /linux-6.15/Documentation/security/secrets/ |
| H A D | coco.rst | 42 On kernel start, the kernel's EFI driver saves the location of the secret area
|
| /linux-6.15/Documentation/filesystems/ |
| H A D | cramfs.rst | 56 instead of going through the block device layer. This saves some memory
|
| /linux-6.15/Documentation/arch/parisc/ |
| H A D | registers.rst | 103 (GR) saves and restores in interruption handlers.
|