Home
last modified time | relevance | path

Searched refs:rails (Results 1 – 25 of 41) sorted by relevance

12

/linux-6.15/drivers/gpu/drm/nouveau/nvkm/subdev/iccsense/
H A Dbase.c117 list_for_each_entry(rail, &iccsense->rails, head) { in nvkm_iccsense_read_all()
141 list_for_each_entry_safe(rail, tmpr, &iccsense->rails, head) { in nvkm_iccsense_dtor()
291 list_add_tail(&rail->head, &iccsense->rails); in nvkm_iccsense_oneinit()
328 INIT_LIST_HEAD(&(*iccsense)->rails); in nvkm_iccsense_new_()
/linux-6.15/drivers/gpu/drm/nouveau/include/nvkm/subdev/
H A Diccsense.h11 struct list_head rails; member
/linux-6.15/drivers/pci/pwrctrl/
H A DKconfig22 PCI slots. The voltage regulators powering the rails of the PCI slots
/linux-6.15/Documentation/devicetree/bindings/mfd/
H A Drichtek,rt5120.yaml15 I/O, and peripheral rails in home entertainment devices. The I2C interface is
16 used for dynamic voltage scaling of the processor voltage, power rails on/off
H A Dmax77620.txt122 GPIO1/nRST_IO pins are HIGH only if all rails
124 If any of the rails goes down(which are enabled for POK
H A Drohm,bd9571mwv.yaml40 This is a bitmask that specifies which DDR power rails need to be kept
H A Dgateworks-gsc.yaml17 - Hardware monitor with ADC's for temperature and voltage rails and
/linux-6.15/Documentation/devicetree/bindings/regulator/
H A Dmax77650-regulator.yaml20 three independent power rails.
H A Dtps65090.txt22 entry then driver will just configure this rails as external control
H A Dpfuze100.yaml57 power rails when PMIC_STBY_REQ line is asserted during the power off sequence.
/linux-6.15/arch/arm64/boot/dts/qcom/
H A Dsa8155p.dtsi6 * Most notably, the RPMhPD setup differs: MMCX and LCX/LMX rails are gone,
H A Dsc7180-trogdor-homestar.dtsi98 * rail and eDP rails are separate from each other on homestar (but
/linux-6.15/arch/arm64/boot/dts/rockchip/
H A Drk3588-jaguar-pre-ict-tester.dtso12 * This adapter routes some GPIOs to power rails and loops together some other
75 * GPIO3_A3 requires two power rails to be properly
97 * GPIO3_B2 requires two power rails to be properly
H A Drk3399-gru.dtsi24 * In general an attempt is made to include all rails called out by
25 * the schematic as long as those rails interact in some way with
29 * - Rails _are_ included if the rails go to the AP even if the AP
34 * If two rails are substantially the same from the AP's point of
36 * put the child rail as an alias of the parent rail. Sometimes rails
40 * - The rails are actually connected to each other by a jumper and
/linux-6.15/Documentation/hwmon/
H A Ducd9200.rst108 rails. See chip datasheets for details.
114 created for enabled rails. See chip datasheets for
H A Dmp2856.rst31 setting of different formats on rails 1 and 2. For VID the following
H A Dlochnagar.rst14 rails provided to the minicards. The Current Monitor does not require any
H A Dmp2975.rst31 setting of different formats on rails 1 and 2. For VID the following
/linux-6.15/Documentation/devicetree/bindings/soc/qcom/
H A Dqcom-stats.yaml14 sleep modes involving powering down of the rails and oscillator clock.
/linux-6.15/Documentation/ABI/testing/
H A Dsysfs-driver-bd9571mwv-regulator6 if DDR power rails will be kept powered during system suspend.
/linux-6.15/Documentation/devicetree/bindings/input/
H A Dgoodix,gt7375p.yaml49 with what the touchscreen is expecting for its IO rails.
/linux-6.15/drivers/regulator/
H A DKconfig631 power rails and an LDO.
833 This driver supports the control of different power rails of device
843 This driver supports the control of different power rails of device
853 This driver supports the control of different power rails of device
862 This driver supports the control of different power rails of device
871 This driver supports the control of different power rails of device
880 This driver supports the control of different power rails of device
889 This driver supports the control of different power rails of device
898 This driver supports the control of different power rails of device
907 This driver supports the control of different power rails of device
[all …]
/linux-6.15/drivers/acpi/pmic/
H A DKconfig8 to control power rails and sensor reading/writing on the
/linux-6.15/Documentation/devicetree/bindings/display/panel/
H A Dpanel-dsi-cm.yaml45 because all its power rails can be driven by the same supply. In that case
/linux-6.15/arch/arm/boot/dts/renesas/
H A Dr8a73a4-ape6evm.dts55 /* Common 1.8V and 3.3V rails, used by several devices on APE6EVM */

12