| /linux-6.15/Documentation/arch/powerpc/ |
| H A D | syscall64-abi.rst | 91 will be performed as normal, and will return as normal. The syscall will be
92 performed in suspended state, so its side effects will be persistent according
101 be performed and the transaction will be doomed by the kernel with the
119 performed with the sc instruction, if it is 0x3000 then the system call was
120 performed with the scv 0 instruction.
147 The vsyscall is performed with a branch-with-link instruction to the vsyscall
|
| /linux-6.15/Documentation/devicetree/bindings/mtd/partitions/ |
| H A D | partition.yaml | 75 performed.
88 entry itself (the padding is performed only when its parent section is
91 performed.
106 content of the entry itself (the padding is performed only when its
109 no alignment is performed.
|
| /linux-6.15/Documentation/virt/ |
| H A D | guest-halt-polling.rst | 11 1) The POLL flag is set while polling is performed, which allows
17 The downside of guest side polling is that polling is performed
36 performed before halting.
|
| /linux-6.15/Documentation/driver-api/firmware/ |
| H A D | lookup-order.rst | 13 * The ''Direct filesystem lookup'' is performed next, if found we
15 * The ''Platform firmware fallback'' is performed next, but only when
|
| /linux-6.15/Documentation/watchdog/ |
| H A D | mlx-wdt.rst | 45 The last 2 actions are performed without a system reset.
59 initial timeout, performed action in expiration and configuration flags.
65 Access to HW registers is performed through a generic regmap interface.
|
| /linux-6.15/drivers/gpu/drm/amd/display/dc/dml2/dml21/src/inc/ |
| H A D | dml2_internal_shared_types.h | 222 bool performed; member
229 bool performed; member
301 bool performed; member
320 bool performed; member
326 bool performed; member
|
| /linux-6.15/Documentation/userspace-api/gpio/ |
| H A D | chardev_v1.rst | 49 The following operations may be performed on the chip:
78 The following operations may be performed on the line handle:
103 The following operations may be performed on the line event:
|
| H A D | chardev.rst | 53 The following operations may be performed on the chip:
81 The following operations may be performed on the line request:
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | configfs-usb-gadget-tcm | 6 is performed in the "target" subsystem of configfs.
|
| H A D | sysfs-kernel-mm-numa | 19 is performed before swap. It may move data to a NUMA
|
| /linux-6.15/Documentation/driver-api/soundwire/ |
| H A D | stream.rst | 222 to be performed like prepare, enable, disable, de-prepare etc.
274 of the stream. Operations performed before entering in this state:
277 runtime is used as a reference for all the operations performed
304 Configuration state of stream. Operations performed before entering in
339 Prepare state of stream. Operations performed before entering in this state:
383 Operations performed before entering in this state:
412 Operations performed before entering in this state:
448 De-prepare state of stream. Operations performed before entering in this
482 Release state of stream. Operations performed before entering in this state:
|
| /linux-6.15/Documentation/networking/devlink/ |
| H A D | devlink-reload.rst | 45 being performed without fw activation. Therefore, the devlink reload
46 command returns the list of actions which were actrually performed.
|
| /linux-6.15/Documentation/networking/ |
| H A D | checksum-offloads.rst | 52 No offloading of the IP header checksum is performed; it is always done in
107 LCO is performed by the stack when constructing an outer UDP header for an
111 It is also performed when constructing an IPv4 GRE header, in
112 net/ipv4/ip_gre.c:build_header(). It is *not* currently performed when
|
| /linux-6.15/drivers/gpu/drm/armada/ |
| H A D | Kconfig | 14 performed by other IP found on the SoC. This driver provides
|
| /linux-6.15/crypto/krb5/ |
| H A D | Kconfig | 26 will be performed on module load or boot, if compiled in.
|
| /linux-6.15/Documentation/hwmon/ |
| H A D | htu31.rst | 27 Communication with the device is performed via I2C protocol. Sensor's default address
|
| H A D | mcp3021.rst | 35 Communication to the MCP3021/MCP3221 is performed using a 2-wire I2C
|
| /linux-6.15/Documentation/devicetree/bindings/rtc/ |
| H A D | rtc-cmos.txt | 16 instance). If this is not done, it can be performed by the driver.
|
| H A D | epson,rtc7301.yaml | 28 The size (in bytes) of the IO accesses that should be performed
|
| /linux-6.15/Documentation/userspace-api/media/v4l/ |
| H A D | pixfmt-bayer.rst | 13 performed on the image. The formats contain green, red and blue components, with
|
| /linux-6.15/Documentation/ABI/stable/ |
| H A D | sysfs-bus-fsl-mc | 17 of the fsl-mc bus is performed. A non-zero value
|
| /linux-6.15/Documentation/driver-api/md/ |
| H A D | raid5-ppl.rst | 21 contents. PPL recovery is also performed when starting an array after an
37 performed for this stripe (parity is not updated). So it is possible to have
|
| /linux-6.15/Documentation/devicetree/bindings/net/ |
| H A D | broadcom-bcm87xx.txt | 14 value of zero, no read of the existing value is performed.
|
| /linux-6.15/Documentation/devicetree/bindings/cpufreq/ |
| H A D | nvidia,tegra20-cpufreq.txt | 20 A bitwise AND is performed against these values and if any bit
|
| /linux-6.15/Documentation/arch/x86/ |
| H A D | tlb.rst | 21 1. The size of the flush being performed. A flush of the entire
22 address space is obviously better performed by flushing the
|