Home
last modified time | relevance | path

Searched refs:inbound (Results 1 – 25 of 81) sorted by relevance

1234

/linux-6.15/Documentation/scsi/
H A Dhptiop.rst110 All queued requests are handled via inbound/outbound queue port.
115 - Get a free request packet by reading the inbound queue port or
118 The value returned from the inbound queue port is an offset
125 - Post the packet to IOP by writing it to inbound queue. For requests
126 allocated in IOP memory, write the offset to inbound queue port. For
128 to the inbound queue port.
147 Non-queued requests (reset/flush etc) can be sent via inbound message
149 of an inbound message.
155 All queued requests are handled via inbound/outbound list.
168 Set up the inbound list write pointer with the index of previous unit,
[all …]
H A Darcmsr_spec.rst40 offset 0xa00 for inbound message code message_rwbuffer
61 (inbound queue port)
152 ->offset 0xa00 :for inbound message code message_rwbuffer
167 ->offset 0xa00 for inbound message code message_rwbuffer
/linux-6.15/Documentation/arch/arm/
H A Dcluster-pm-race-avoidance.rst237 "inbound" state: The state of the cluster on the inbound side.
280 The parallelism of the inbound and outbound CPUs is observed by
296 <cluster state>/<inbound state> (<transitioner>)
299 can occur; either the inbound or the outbound side.
304 CLUSTER_DOWN/INBOUND_COMING_UP (inbound)
317 In this state, an inbound CPU sets up the cluster, including
327 CLUSTER_UP/INBOUND_COMING_UP (inbound)
345 CLUSTER_UP/INBOUND_NOT_COMING_UP (inbound)
380 should check the inbound cluster state for asynchronous
393 CLUSTER_GOING_DOWN/INBOUND_COMING_UP (inbound)
[all …]
/linux-6.15/Documentation/devicetree/bindings/soc/qcom/
H A Dqcom,smp2p.yaml60 Two identifiers of the inbound and outbound smem items used for this edge.
66 Each SMP2P pair contain a set of inbound and outbound entries, these are
73 Marks the entry as inbound; the node should be specified as a two
83 The name of this entry, for inbound entries this will be used to
123 # inbound and one outbound entry.
/linux-6.15/drivers/soc/qcom/
H A Dsmp2p.c160 struct list_head inbound; member
239 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_notify_in()
250 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_notify_in()
549 INIT_LIST_HEAD(&smp2p->inbound); in qcom_smp2p_probe()
611 list_add(&entry->node, &smp2p->inbound); in qcom_smp2p_probe()
654 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_probe()
679 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_remove()
/linux-6.15/drivers/hv/
H A Dvmbus_drv.c383 struct hv_ring_buffer_debug_info inbound; in in_intr_mask_show() local
389 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_intr_mask_show()
401 struct hv_ring_buffer_debug_info inbound; in in_read_index_show() local
407 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_read_index_show()
419 struct hv_ring_buffer_debug_info inbound; in in_write_index_show() local
425 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_write_index_show()
438 struct hv_ring_buffer_debug_info inbound; in in_read_bytes_avail_show() local
444 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_read_bytes_avail_show()
457 struct hv_ring_buffer_debug_info inbound; in in_write_bytes_avail_show() local
463 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_write_bytes_avail_show()
[all …]
H A Dring_buffer.c180 mutex_init(&channel->inbound.ring_buffer_mutex); in hv_ringbuffer_pre_init()
465 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_first()
525 struct hv_ring_buffer_info *rbi = &channel->inbound; in __hv_pkt_iter_next()
573 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_close()
H A Dconnection.c415 if (likely(hv_end_read(&channel->inbound) == 0)) in vmbus_on_event()
418 hv_begin_read(&channel->inbound); in vmbus_on_event()
/linux-6.15/Documentation/admin-guide/perf/
H A Dmrvl-pem-pmu.rst9 The counters track inbound and outbound transactions which
11 Also, inbound and outbound memory read requests along with their
17 tlps in inbound and outbound transactions. ATS events are measured by
/linux-6.15/drivers/uio/
H A Duio_hv_generic.c83 dev->channel->inbound.ring_buffer->interrupt_mask = !irq_state; in hv_uio_irqcontrol()
101 chan->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_channel_cb()
167 new_sc->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_new_channel()
211 dev->channel->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_open()
/linux-6.15/Documentation/trace/
H A Dhisi-ptt.rst99 type. Rx means the inbound while Tx means outbound. The packets will
132 direction of inbound and traced data format of 8DW.
177 You can specify multiple types when tracing inbound TLP headers, but can only
185 This is optional and the default parameter is inbound. The parameter value
189 - 4'b0000: inbound TLPs (P, NP, CPL)
191 - 4'b0010: outbound TLPs (P, NP, CPL) and inbound TLPs (P, NP, CPL B)
192 - 4'b0011: outbound TLPs (P, NP, CPL) and inbound TLPs (CPL A)
199 - 4'b0010: inbound TLPs (P, NP, CPL B)
200 - 4'b0011: inbound TLPs (CPL A)
/linux-6.15/drivers/net/ppp/
H A Dppp_async.c108 int len, int inbound);
945 int len, int inbound) in async_lcp_peek() argument
961 if (code == (inbound? CONFACK: CONFREQ)) { in async_lcp_peek()
970 if (!inbound) { in async_lcp_peek()
981 } else if (inbound) in async_lcp_peek()
992 if (inbound) in async_lcp_peek()
999 if (inbound) in async_lcp_peek()
/linux-6.15/arch/arm/common/
H A Dmcpm_entry.c92 sync_cache_r(&c->inbound); in __mcpm_outbound_enter_critical()
93 if (c->inbound == INBOUND_COMING_UP) in __mcpm_outbound_enter_critical()
437 mcpm_sync.clusters[i].inbound = INBOUND_NOT_COMING_UP; in mcpm_sync_init()
/linux-6.15/Documentation/ABI/testing/
H A Dsysfs-bus-rpmsg23 inbound messages arrive to this address, the rpmsg core
41 inbound messages arrive to this address, the rpmsg core
49 and it is listening for inbound messages that may be sent
/linux-6.15/Documentation/driver-api/rapidio/
H A Dtsi721.rst9 It supports maintenance read and write operations, inbound and outbound RapidIO
10 doorbells, inbound maintenance port-writes and RapidIO messaging.
17 For inbound messages this driver uses destination ID matching to forward messages
/linux-6.15/Documentation/devicetree/bindings/pci/
H A Dmbvl,gpex40-pcie.yaml14 has up to 8 outbound and inbound windows for address translation.
51 description: number of requested PPIO inbound windows
H A Dcdns-pcie-host.yaml28 significant bits kept during inbound (PCIe -> AXI) address translations
H A Dxgene-pci.txt15 - dma-ranges: ranges for the inbound memory regions.
/linux-6.15/arch/arm/include/asm/
H A Dmcpm.h294 s8 inbound __aligned(__CACHE_WRITEBACK_GRANULE);
/linux-6.15/drivers/pci/controller/mobiveil/
H A DKconfig31 Soft IP. It has up to 8 outbound and inbound windows
/linux-6.15/Documentation/networking/
H A Dsecid.rst19 If this is an inbound flow, the label is derived from the IPSec security
H A Dxfrm_proc.rst33 i.e. Either inbound SPI, address, or IPsec protocol at SA is wrong
/linux-6.15/Documentation/ABI/stable/
H A Dfirewire-cdev42 link layers, reception of inbound requests to such
44 to inbound requests
/linux-6.15/include/net/sctp/
H A Dulpevent.h79 __u16 inbound,
/linux-6.15/Documentation/staging/
H A Drpmsg.rst60 a unique rpmsg local address (a 32-bit integer). This way when inbound messages
63 with the payload of the inbound message).
204 inbound messages arrive, they are dispatched by the rpmsg bus using the
218 relevant inbound messages arrive (i.e. messages which their dst address

1234