| /linux-6.15/tools/testing/selftests/zram/ |
| H A D | README | 5 The zram module creates RAM based block devices named /dev/zram<id>
26 zram01.sh: creates general purpose ram disks with ext4 filesystems
27 zram02.sh: creates block device for swap
|
| /linux-6.15/Documentation/driver-api/ |
| H A D | sync_file.rst | 35 the driver creates an out-fence to be able to notify, through
37 Out-fences are fences that the driver creates.
47 When a driver needs to send an out-fence userspace it creates a sync_file.
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | debugfs-pktcdvd | 7 The pktcdvd module (packet writing driver) creates
|
| H A D | sysfs-firmware-opal-powercap | 29 creates a request for setting a new-powercap. The
|
| /linux-6.15/Documentation/admin-guide/gpio/ |
| H A D | gpio-mockup.rst | 35 The line above creates three chips. The first one will expose 8 lines,
50 Each mockup chip creates its own subdirectory in /sys/kernel/debug/gpio-mockup/.
|
| /linux-6.15/Documentation/arch/x86/ |
| H A D | amd_hsmp.rst | 30 Kconfig option CONFIG_AMD_HSMP_PLAT compiles plat.c and creates amd_hsmp.ko.
31 Kconfig option CONFIG_AMD_HSMP_ACPI compiles acpi.c and creates hsmp_acpi.ko.
33 compiles common code hsmp.c and creates hsmp_common.ko module.
|
| /linux-6.15/Documentation/driver-api/hte/ |
| H A D | hte.rst | 59 HTE subsystem creates debugfs attributes at ``/sys/kernel/debug/hte/``.
60 It also creates line/signal-related debugfs attributes at
|
| /linux-6.15/samples/vfio-mdev/ |
| H A D | README.rst | 7 The sample driver creates an mdev device that simulates a serial port over a PCI
12 This step creates a dummy device, /sys/devices/virtual/mtty/mtty/
|
| /linux-6.15/Documentation/w1/slaves/ |
| H A D | w1_ds28e17.rst | 22 This driver creates a new I2C bus for any DS28E17 device detected. I2C buses
65 The driver creates sysfs files /sys/bus/w1/devices/19-<id>/speed and
|
| /linux-6.15/arch/arm64/boot/dts/freescale/ |
| H A D | imx8qm-apalis.dtsi | 324 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates
333 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates
|
| /linux-6.15/tools/memory-model/litmus-tests/ |
| H A D | dep+plain.litmus | 10 * conditional of P0()'s if-statement creates a control dependency
|
| /linux-6.15/Documentation/userspace-api/ |
| H A D | dcdbas.rst | 32 The driver creates the following sysfs entries for systems management
59 The driver creates the following sysfs entries for systems management software
|
| /linux-6.15/drivers/net/ethernet/sunplus/ |
| H A D | Kconfig | 28 The network device creates two net-device interfaces.
|
| /linux-6.15/Documentation/networking/devlink/ |
| H A D | devlink-health.rst | 26 Device driver creates a "health reporter" per each error/health type.
58 To handle devlink health diagnose and health dump requests, devlink creates a
|
| /linux-6.15/Documentation/devicetree/bindings/clock/ |
| H A D | lpc1850-creg-clk.txt | 6 is a fixed divider that creates a 1 kHz clock from the 32 kHz osc.
|
| /linux-6.15/fs/nilfs2/ |
| H A D | Kconfig | 15 NILFS2 creates a number of checkpoints every few seconds or per
|
| /linux-6.15/Documentation/admin-guide/mm/damon/ |
| H A D | usage.rst | 36 creates multiple directories and files under its sysfs directory,
115 ``nr_kdamonds``. Writing a number (``N``) to the file creates the number of
171 number (``N``) to the file creates the number of child directories named as
247 number (``N``) to the file creates the number of child directories named ``0``
277 number (``N``) to the file creates the number of child directories named ``0``
302 number (``N``) to the file creates the number of child directories named ``0``
389 number (``N``) to the file creates the number of child directories named ``0``
442 number (``N``) to the file creates the number of child directories named ``0``
512 that reading it returns the total size of the scheme tried regions, and creates
|
| /linux-6.15/Documentation/admin-guide/cgroup-v1/ |
| H A D | net_cls.rst | 13 Creating a net_cls cgroups instance creates a net_cls.classid file.
|
| /linux-6.15/drivers/char/xillybus/ |
| H A D | Kconfig | 17 its capabilities, and creates device files accordingly.
|
| /linux-6.15/drivers/mtd/parsers/ |
| H A D | Kconfig | 25 magic value. This driver does that and creates subpartitions for
103 header and creates up to two partitions, kernel and rootfs.
133 This driver reads partitions table, parses it and creates MTD
|
| /linux-6.15/Documentation/driver-api/memory-devices/ |
| H A D | ti-emif.rst | 59 The driver creates two debugfs entries per device.
|
| /linux-6.15/Documentation/PCI/endpoint/ |
| H A D | pci-vntb-howto.rst | 55 The "mkdir func1" above creates the pci-epf-ntb function device that will
87 The PCI endpoint framework also automatically creates a sub-directory in the
|
| H A D | pci-ntb-howto.rst | 59 The "mkdir func1" above creates the pci-epf-ntb function device that will
91 The PCI endpoint framework also automatically creates a sub-directory in the
|
| /linux-6.15/Documentation/misc-devices/ |
| H A D | pci-endpoint-test.rst | 23 This misc driver creates /dev/pci-endpoint-test.<num> for every
|
| /linux-6.15/Documentation/sound/designs/ |
| H A D | jack-controls.rst | 17 The new jack code creates embedded jack kcontrols for each jack that
|