| /linux-6.15/Documentation/userspace-api/media/dvb/ |
| H A D | fe-set-voltage.rst | 13 FE_SET_VOLTAGE - Allow setting the DC level sent to the antenna subsystem. 34 This ioctl allows to set the DC voltage level sent through the antenna 37 Usually, a satellite antenna subsystems require that the digital TV 45 .. attention:: if more than one device is connected to the same antenna,
|
| H A D | fe-set-tone.rst | 37 Usually, satellite antenna subsystems require that the digital TV device 42 .. attention:: If more than one device is connected to the same antenna,
|
| H A D | fe-diseqc-send-master-cmd.rst | 36 to the antenna subsystem.
|
| H A D | fe-enable-high-lnb-voltage.rst | 34 to compensate for long antenna cables.
|
| H A D | fe-diseqc-reset-overload.rst | 13 FE_DISEQC_RESET_OVERLOAD - Restores the power to the antenna subsystem, if it was powered off due -…
|
| /linux-6.15/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-rf-tuner.rst | 12 In this context, RF tuner is radio receiver circuit between antenna and 13 demodulator. It receives radio frequency (RF) from the antenna and 60 path, just right after the antenna input. The difference between the 68 signal path. It is located very close to tuner antenna input. Used
|
| /linux-6.15/arch/arm/boot/dts/broadcom/ |
| H A D | bcm2711-rpi-cm4.dtsi | 70 /* internal antenna enabled */ 78 /* external antenna disabled */
|
| /linux-6.15/Documentation/devicetree/bindings/net/wireless/ |
| H A D | silabs,wfx.yaml | 39 - const: silabs,wf200 # Chip alone without antenna 68 silabs,antenna-config-file: 70 description: Use an alternative file for antenna configuration (aka
|
| H A D | brcm,bcm4329-fmac.yaml | 117 apple,antenna-sku: 119 description: Antenna SKU used to identify a specific antenna configuration 121 platforms with different antenna configs to have different firmware and/or
|
| /linux-6.15/Documentation/networking/ |
| H A D | radiotap-headers.rst | 91 0x01 //<-- antenna 107 int pkt_rate_100kHz = 0, antenna = 0, pwr = 0; 136 antenna = *iterator.this_arg);
|
| /linux-6.15/Documentation/admin-guide/media/ |
| H A D | si470x.rst | 34 - Si4704: FM radio receiver, no external antenna required 35 - Si4705: FM radio receiver, no external antenna required, RDS support, Dig I/O 36 - Si4706: Enhanced FM RDS/TMC radio receiver, no external antenna required, RDS
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-sx9324 | 11 + connected to an antenna where it can act as a base
|
| /linux-6.15/drivers/net/wireless/ralink/rt2x00/ |
| H A D | rt2x00link.c | 252 void rt2x00link_reset_tuner(struct rt2x00_dev *rt2x00dev, bool antenna) in rt2x00link_reset_tuner() argument 284 if (antenna) in rt2x00link_reset_tuner()
|
| H A D | rt2x00reg.h | 29 enum antenna { enum
|
| /linux-6.15/drivers/media/tuners/ |
| H A D | mt20xx.c | 428 static void mt2050_set_antenna(struct dvb_frontend *fe, unsigned char antenna) in mt2050_set_antenna() argument 434 buf[1] = antenna ? 0x11 : 0x10; in mt2050_set_antenna() 436 tuner_dbg("mt2050: enabled antenna connector %d\n", antenna); in mt2050_set_antenna()
|
| /linux-6.15/drivers/net/wireless/ath/ath9k/ |
| H A D | Makefile | 9 antenna.o \
|
| /linux-6.15/Documentation/devicetree/bindings/gnss/ |
| H A D | gnss-common.yaml | 24 device and the receiver antenna.
|
| /linux-6.15/arch/arm64/boot/dts/apple/ |
| H A D | t8112-j413.dts | 50 apple,antenna-sku = "XX";
|
| H A D | t8103-jxxx.dtsi | 79 apple,antenna-sku = "XX";
|
| /linux-6.15/drivers/net/wireless/silabs/wfx/ |
| H A D | data_rx.c | 73 hdr->antenna = 0; in wfx_rx_cb()
|
| /linux-6.15/Documentation/devicetree/bindings/media/i2c/ |
| H A D | max2175.txt | 32 in this hardware for AM antenna input.
|
| /linux-6.15/Documentation/devicetree/bindings/iio/proximity/ |
| H A D | awinic,aw96103.yaml | 20 power of the antenna to keep the SAR within a safe range. Therefore,
|
| /linux-6.15/drivers/net/wireless/intersil/p54/ |
| H A D | eeprom.h | 114 } __packed, antenna);
|
| /linux-6.15/Documentation/devicetree/bindings/pinctrl/ |
| H A D | mediatek,mt76x8-pinctrl.yaml | 38 enum: [antenna, debug, gpio, i2c, i2s, jtag, p0led_an, p0led_kn, 58 const: antenna
|
| /linux-6.15/Documentation/netlink/specs/ |
| H A D | nl80211.yaml | 269 name: antenna-selection-info 627 name: wiphy-antenna-tx 630 name: wiphy-antenna-rx 651 name: wiphy-antenna-avail-tx 654 name: wiphy-antenna-avail-rx 1923 - wiphy-antenna-avail-rx 1924 - wiphy-antenna-avail-tx 1925 - wiphy-antenna-rx 1926 - wiphy-antenna-tx
|