| /linux-6.15/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-ina2xx-adc | 7 Ready Flag to being set prior to committing a new value to the sample
11 Writing '1' will remove the polling for the Conversion Ready Flags to
|
| H A D | sysfs-class-led-trigger-tty | 38 DSR = Data Set Ready
|
| /linux-6.15/Documentation/devicetree/bindings/mtd/ |
| H A D | lpc32xx-slc.txt | 11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)
12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
|
| H A D | raw-nand-chip.yaml | 90 Contains the native Ready/Busy IDs.
97 Ready/Busy pins. Active state refers to the NAND ready state and
|
| H A D | allwinner,sun4i-a10-nand.yaml | 69 Contains the native Ready/Busy IDs.
|
| H A D | fsl-upm-nand.txt | 12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
|
| H A D | atmel-nand.txt | 42 - rb-gpios: the GPIO(s) used to check the Ready/Busy status of the NAND.
45 - atmel,rb: an integer identifying the native Ready/Busy pin. Only meaningful
|
| /linux-6.15/Documentation/devicetree/bindings/net/ |
| H A D | intel,ixp4xx-hss.yaml | 92 description: Ready To Send (RTS) GPIO line
100 description: Data Terminal Ready (DTR) GPIO line
|
| /linux-6.15/Documentation/devicetree/bindings/remoteproc/ |
| H A D | qcom,pas-common.yaml | 32 - description: Ready interrupt
|
| H A D | qcom,qcs404-cdsp-pil.yaml | 30 - description: Ready interrupt
|
| H A D | qcom,sdm845-adsp-pil.yaml | 30 - description: Ready interrupt
|
| H A D | qcom,sc7280-wpss-pil.yaml | 30 - description: Ready interrupt
|
| H A D | qcom,sc7280-adsp-pil.yaml | 34 - description: Ready interrupt
|
| H A D | qcom,sc7180-mss-pil.yaml | 40 - description: Ready interrupt
|
| H A D | qcom,sc7280-mss-pil.yaml | 44 - description: Ready interrupt
|
| H A D | qcom,msm8916-mss-pil.yaml | 45 - description: Ready interrupt
|
| H A D | qcom,msm8996-mss-pil.yaml | 44 - description: Ready interrupt
|
| /linux-6.15/Documentation/devicetree/bindings/serial/ |
| H A D | renesas,scif.yaml | 103 - description: Data Ready interrupt
105 - description: Transmit End/Data Ready interrupt
|
| /linux-6.15/Documentation/devicetree/bindings/iio/adc/ |
| H A D | microchip,mcp3911.yaml | 47 Data Ready Pin Inactive State Control
|
| H A D | adi,ad4130.yaml | 38 Specify which interrupt pin should be configured as Data Ready / FIFO
|
| H A D | adi,ad7173.yaml | 67 Ready: multiplexed with SPI data out. While SPI CS is low,
|
| /linux-6.15/rust/kernel/net/ |
| H A D | phy.rs | 26 Ready, enumerator
112 bindings::phy_state_PHY_READY => DeviceState::Ready, in state()
|
| /linux-6.15/Documentation/networking/ |
| H A D | udplite.rst | 112 Ready-made header files for various distros are in the UDP-Lite tarball.
|
| /linux-6.15/Documentation/driver-api/soundwire/ |
| H A D | bra.rst | 95 (c) Not Ready
|
| /linux-6.15/Documentation/scsi/ |
| H A D | aic79xx.rst | 159 - Allow Test Unit Ready commands to take a full 5 seconds
|