| /linux-6.15/Documentation/devicetree/bindings/dma/ti/ |
| H A D | k3-pktdma.yaml | 17 PKTDMA only includes Split channels to service PSI-L based peripherals.
19 The peripherals can be PSI-L native or legacy, non PSI-L native peripherals
20 with PDMAs. PDMA is tasked to act as a bridge between the PSI-L fabric and the
37 The first cell is the PSI-L thread ID of the remote (to PKTDMA) end.
42 Please refer to the device documentation for the PSI-L thread map and also
43 the PSI-L peripheral chapter for the correct thread ID.
|
| H A D | k3-udma.yaml | 29 on the Rx PSI-L interface.
35 All transfers within NAVSS is done between PSI-L source and destination
37 The peripherals serviced by UDMA can be PSI-L native (sa2ul, cpsw, etc) or
38 legacy, non PSI-L native peripherals. In the later case a special, small PDMA
39 is tasked to act as a bridge between the PSI-L fabric and the legacy
54 The cell is the PSI-L thread ID of the remote (to UDMAP) end.
59 Please refer to the device documentation for the PSI-L thread map and also
60 the PSI-L peripheral chapter for the correct thread ID.
|
| H A D | k3-bcdma.yaml | 23 Split channels can be used to service PSI-L based peripherals.
24 The peripherals can be PSI-L native or legacy, non PSI-L native peripherals
25 with PDMAs. PDMA is tasked to act as a bridge between the PSI-L fabric and the
58 PSI-L thread ID of the remote (to BCDMA) end.
63 Please refer to the device documentation for the PSI-L thread map and
64 also the PSI-L peripheral chapter for the correct thread ID.
|
| /linux-6.15/Documentation/networking/devlink/ |
| H A D | iosm.rst | 49 * - ``PSI RAM``
56 PSI RAM and EBL are the RAM images which are injected to the device when the
70 1) When modem is in Boot ROM stage, user can use below command to inject PSI RAM
80 3) Inject EBL after the modem is in PSI stage.
|
| /linux-6.15/Documentation/driver-api/media/drivers/ |
| H A D | vidtv.rst | 144 This is the PSI generator. PSI packets contain general information
145 about a MPEG Transport Stream. A PSI generator is needed so
152 Currently vidtv supports working with 5 PSI tables: PAT, PMT,
161 debugging PSI tables. Vidtv currently tries to replicate the PSI
222 #. Inserting PSI and/or PCR packets, if needed.
349 In order to tune into a channel and read the PSI tables, we can use dvb-scan.
|
| /linux-6.15/Documentation/devicetree/bindings/media/ |
| H A D | ti,j721e-csi2rx-shim.yaml | 11 enables sending captured frames to memory over PSI-L DMA. In the J721E
|
| /linux-6.15/Documentation/translations/zh_CN/accounting/ |
| H A D | psi.rst | 10 PSI——压力阻塞信息
|
| /linux-6.15/Documentation/process/debugging/ |
| H A D | driver_development_debugging_guide.rst | 199 PSI (Pressure stall information tracking)
204 PSI is a measurement tool to identify excessive overcommits on hardware
|
| /linux-6.15/drivers/gpu/drm/amd/pm/swsmu/inc/ |
| H A D | smu_types.h | 395 __SMU_DUMMY_MAP(PSI), \
|
| /linux-6.15/Documentation/accounting/ |
| H A D | psi.rst | 4 PSI - Pressure Stall Information
|
| /linux-6.15/include/linux/ |
| H A D | scmi_protocol.h | 413 PSI = 0x10, enumerator
|
| /linux-6.15/arch/powerpc/boot/dts/ |
| H A D | fsp2.dts | 86 /* PSI and DMA */
|
| /linux-6.15/Documentation/admin-guide/mm/damon/ |
| H A D | reclaim.rst | 127 memory pressure is incurred. System-wide ``some`` memory PSI in microseconds
|
| /linux-6.15/drivers/gpu/drm/amd/pm/swsmu/smu13/ |
| H A D | smu_v13_0_4_ppt.c | 130 FEA_MAP(PSI),
|
| H A D | yellow_carp_ppt.c | 125 FEA_MAP(PSI),
|
| /linux-6.15/drivers/gpu/drm/amd/pm/swsmu/smu14/ |
| H A D | smu_v14_0_0_ppt.c | 165 FEA_MAP(PSI),
|
| /linux-6.15/Documentation/admin-guide/ |
| H A D | cgroup-v2.rst | 1040 Writing "0" to the file will disable the cgroup PSI accounting.
1041 Writing "1" to the file will re-enable the cgroup PSI accounting.
1043 This control attribute is not hierarchical, so disable or enable PSI
1044 accounting in a cgroup does not affect PSI accounting in descendants
1047 The reason this control attribute exists is that PSI accounts stalls for
1051 be used to disable PSI accounting in the non-leaf cgroups.
|
| /linux-6.15/drivers/gpu/drm/amd/pm/swsmu/smu11/ |
| H A D | vangogh_ppt.c | 168 FEA_MAP(PSI),
|
| /linux-6.15/init/ |
| H A D | Kconfig | 671 config PSI config
694 depends on PSI
|
| /linux-6.15/Documentation/mm/damon/ |
| H A D | design.rst | 561 time (PSI) could be examples. Note that users should explicitly set
|
| /linux-6.15/ |
| H A D | MAINTAINERS | 19531 PRESSURE STALL INFORMATION (PSI)
|