| /linux-6.15/arch/arm/boot/dts/samsung/ |
| H A D | exynos4412-itop-scp-core.dtsi | 179 op_mode = <1>; /* Normal Mode */ 189 op_mode = <1>; /* Normal Mode */ 197 op_mode = <1>; /* Normal Mode */ 205 op_mode = <1>; /* Normal Mode */ 218 op_mode = <1>; /* Normal Mode */ 226 op_mode = <1>; /* Normal Mode */ 233 op_mode = <1>; /* Normal Mode */ 240 op_mode = <1>; /* Normal Mode */ 247 op_mode = <1>; /* Normal Mode */ 255 op_mode = <1>; /* Normal Mode */ [all …]
|
| H A D | exynos4412-origen.dts | 168 op_mode = <1>; /* Normal Mode */ 176 op_mode = <1>; /* Normal Mode */ 184 op_mode = <1>; /* Normal Mode */ 192 op_mode = <1>; /* Normal Mode */ 200 op_mode = <1>; /* Normal Mode */ 208 op_mode = <1>; /* Normal Mode */ 216 op_mode = <1>; /* Normal Mode */ 224 op_mode = <1>; /* Normal Mode */ 232 op_mode = <1>; /* Normal Mode */ 240 op_mode = <1>; /* Normal Mode */ [all …]
|
| /linux-6.15/Documentation/arch/arm64/ |
| H A D | arm-cca.rst | 10 world" model (Normal and Secure World) into four worlds: Normal, Secure, 19 running in the Normal World. The Normal World hypervisor uses the Realm 25 mapped in this half cannot be seen by the Normal World and the RMM 26 restricts what operations the Normal World can perform on this memory 27 (e.g. the Normal World cannot replace pages in this region without the 28 guest's cooperation). The upper half is shared, the Normal World is free 37 guest to give up memory to be returned to the Normal World, or to 38 request new memory from the Normal World. Without an explicit request 39 from the Realm guest the RMM will otherwise prevent the Normal World 51 * MMIO devices must be either unprotected (e.g. emulated by the Normal [all …]
|
| /linux-6.15/Documentation/devicetree/bindings/clock/ |
| H A D | ti,lmk04832.yaml | 74 Normal SYNC 0 123 CMOS (Normal/Off) 0x0b 125 CMOS (Inverted/Normal) 0x0d 126 CMOS (Normal/Inverted) 0x0e 127 CMOS (Normal/Normal) 0x0f
|
| /linux-6.15/Documentation/devicetree/bindings/arm/ |
| H A D | secure.txt | 4 "Normal" and "Secure". Most devicetree consumers (including the Linux 5 kernel) are not TrustZone aware and run entirely in either the Normal 8 visible only in the Secure address space, only in the Normal address 19 world value is the same as specified for the Normal world by the 32 secure- bindings only need to be used where both the Secure and Normal 70 Normal world OS).
|
| /linux-6.15/rust/kernel/ |
| H A D | device.rs | 222 pub struct Normal; struct 232 impl Sealed for super::Normal {} implementation 236 impl DeviceContext for Normal {} implementation
|
| /linux-6.15/Documentation/devicetree/bindings/media/i2c/ |
| H A D | tvp7002.txt | 21 0 = Normal Operation (Active Low, Default) 27 0 = Normal Operation (Active Low, Default)
|
| /linux-6.15/Documentation/input/devices/ |
| H A D | sentelic.rst | 108 Byte 1: Bit7~Bit6 => 00, Normal data packet 132 Byte 1: Bit7~Bit6 => 00, Normal data packet 142 Mode Type => 0xA5 (Normal/Icon mode status) 145 Mode Type => 0x00 (Normal) 160 Byte 1: Bit7~Bit6 => 00, Normal data packet 185 Byte 1: Bit7~Bit6 => 00, Normal data packet 210 Byte 1: Bit7~Bit6 => 00, Normal data packet 252 Byte 1: Bit7~Bit6 => 00, Normal data packet 279 Byte 1: Bit7~Bit6 => 00, Normal data packet 307 Byte 1: Bit7~Bit6 => 00, Normal data packet [all …]
|
| /linux-6.15/Documentation/devicetree/bindings/mmc/ |
| H A D | renesas,mmcif.yaml | 82 - description: Normal operation interrupt 97 - description: Normal operation interrupt
|
| /linux-6.15/Documentation/devicetree/bindings/mfd/ |
| H A D | samsung,s5m8767.yaml | 227 op_mode = <1>; /* Normal Mode */ 238 op_mode = <1>; /* Normal Mode */ 247 op_mode = <1>; /* Normal Mode */ 290 op_mode = <1>; /* Normal Mode */
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | sysfs-class-leds-gt683r | 16 Normal: LEDs are fully on when enabled
|
| H A D | sysfs-bus-iio-magnetometer-hmc5843 | 10 normal Normal measurement configurations (default)
|
| H A D | sysfs-devices-memory | 58 applicable kernel zone (DMA, DMA32, or Normal). However, 86 the kernel zones (DMA, DMA32, Normal) is applicable for a single
|
| /linux-6.15/drivers/firmware/arm_ffa/ |
| H A D | Kconfig | 11 the Secure world and Normal world. It also leverages the
|
| /linux-6.15/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-axxia.txt | 15 the default 100 kHz frequency will be used. As only Normal and Fast modes
|
| /linux-6.15/Documentation/userspace-api/media/v4l/ |
| H A D | metafmt-vsp1-hgo.rst | 44 .. flat-table:: VSP1 HGO Data - 64 Bins, Normal Mode (792 bytes) 120 .. flat-table:: VSP1 HGO Data - 256 Bins, Normal Mode (1032 bytes)
|
| /linux-6.15/Documentation/ABI/stable/ |
| H A D | sysfs-driver-misc-cp500 | 14 bitstream on reset. Normal FPGA behavior and default is to keep
|
| /linux-6.15/arch/arm/mach-mvebu/ |
| H A D | pmsu_ll.S | 20 strb r0, [r1] @ switch SCU power state to Normal mode
|
| /linux-6.15/Documentation/devicetree/bindings/display/bridge/ |
| H A D | ti,tdp158.yaml | 24 # OE = H: Normal Operation
|
| /linux-6.15/Documentation/devicetree/bindings/sound/ |
| H A D | cs53l30.txt | 31 * 1) Normal I2S mode on two data pins -- each SDOUT
|
| H A D | rt5651.txt | 26 bool. Normal jack-detect switches give an inverted (active-low) signal,
|
| /linux-6.15/sound/soc/generic/ |
| H A D | audio-graph-card2-custom-sample1.dtsi | 61 * [Normal] 347 /* [Normal] */ 379 /* [Normal] */
|
| /linux-6.15/Documentation/devicetree/bindings/iio/resolver/ |
| H A D | adi,ad2s1210.yaml | 29 0 0 Normal mode - position output 30 0 1 Normal mode - velocity output
|
| /linux-6.15/Documentation/hwmon/ |
| H A D | hp-wmi-sensors.rst | 91 ``possible_states`` ``Normal,Caution,Critical,Not Present`` 92 ``current_state`` ``Normal``
|
| /linux-6.15/Documentation/devicetree/bindings/power/reset/ |
| H A D | reboot-mode.yaml | 23 - normal: Normal reboot mode, system reboot with command "reboot".
|