| /linux-6.15/Documentation/hid/ |
| H A D | hid-alps.rst | 75 Byte2 Address - Byte 0 (LSB)
76 Byte3 Address - Byte 1
77 Byte4 Address - Byte 2
78 Byte5 Address - Byte 3 (MSB)
85 Address is read/write RAM address.
95 Byte2 Address - Byte 0 (LSB)
96 Byte3 Address - Byte 1
97 Byte4 Address - Byte 2
98 Byte5 Address - Byte 3 (MSB)
|
| /linux-6.15/Documentation/arch/loongarch/ |
| H A D | introduction.rst | 107 0x6 Exception Return Address ERA
117 Lower-half Address Space
119 Higher-half Address Space
122 half Address Space
124 half Address Space
141 Address
143 Virtual Address
159 Address
161 Address
307 Name Address Range Attributes
[all …]
|
| /linux-6.15/Documentation/arch/arm64/ |
| H A D | tagged-address-abi.rst | 10 This document describes the usage and semantics of the Tagged Address
22 2. AArch64 Tagged Address ABI
43 The AArch64 Tagged Address ABI has two stages of relaxation depending on
72 Address ABI for the calling thread.
77 - ``PR_TAGGED_ADDR_ENABLE``: enable AArch64 Tagged Address ABI.
83 Address ABI for the calling thread.
91 returns ``-EINVAL`` if the AArch64 Tagged Address ABI is globally
95 When the AArch64 Tagged Address ABI is enabled for a thread, the
112 3. AArch64 Tagged Address ABI Exceptions
|
| H A D | tagged-pointers.rst | 24 Tagged Address ABI explicitly
39 userspace application did not enable the AArch64 Tagged Address ABI may
43 For these reasons, when the AArch64 Tagged Address ABI is disabled,
79 This behaviour is maintained when the AArch64 Tagged Address ABI is
|
| /linux-6.15/Documentation/devicetree/bindings/dsp/ |
| H A D | mediatek,mt8186-dsp.yaml | 24 - description: Address and size of the DSP config registers
25 - description: Address and size of the DSP SRAM
26 - description: Address and size of the DSP secure registers
27 - description: Address and size of the DSP bus registers
|
| /linux-6.15/Documentation/devicetree/bindings/display/msm/ |
| H A D | qcom,msm8998-dpu.yaml | 20 - description: Address offset and size for mdp register set
21 - description: Address offset and size for regdma register set
22 - description: Address offset and size for vbif register set
23 - description: Address offset and size for non-realtime vbif register set
|
| /linux-6.15/Documentation/input/devices/ |
| H A D | iforce-protocol.rst | 84 03 Address of parameter block changed (lsb)
85 04 Address of parameter block changed (msb)
86 05 Address of second parameter block changed (lsb)
125 08-09 Address of periodicity or magnitude parameters
126 0a-0b Address of attack and fade parameters, or ffff if none.
128 08-09 Address of interactive parameters for X-axis,
130 0a-0b Address of interactive parameters for Y-axis,
146 00-01 Address where to store the parameters
159 00-01 Address
169 00-01 Address
[all …]
|
| /linux-6.15/Documentation/arch/arm/samsung/ |
| H A D | bootloader-interface.rst | 21 Address: sysram_ns_base_addr
39 Address: sysram_base_addr
51 Address: pmu_base_addr
67 Address: pmu_base_addr
|
| /linux-6.15/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | ingenic,nemc-peripherals.yaml | 24 description: Address setup time in nanoseconds.
28 description: Address hold time in nanoseconds.
36 description: Address wait time in nanoseconds.
|
| H A D | samsung,exynos4210-srom-peripheral-props.yaml | 29 Tcah: Address holding time after CSn (0 - 15)
33 Tacs: Address set-up before CSn (0 - 15)
|
| /linux-6.15/Documentation/ABI/testing/ |
| H A D | debugfs-intel-iommu | 13 IOMMU: dmar0 Register Base Address: 26be37000
24 IOMMU: dmar1 Register Base Address: fed90000
35 IOMMU: dmar2 Register Base Address: fed91000
95 IOMMU dmar1: Root Table Address: 0x103027000
105 IOMMU dmar0: Root Table Address: 0x103028000
191 IOMMU: dmar0 Register Base Address: 26be37000
200 IOMMU: dmar2 Register Base Address: fed91000
213 IOMMU: dmar0 Register Base Address: 26be37000
|
| H A D | sysfs-bus-event_source-devices-iommu | 23 filter_ats_en = "config1:3" - Enable Address Type filter
28 filter_ats = "config2:24-28" - Address Type filter
|
| /linux-6.15/Documentation/networking/ |
| H A D | arcnet-hardware.rst | 677 4 5 6 7 8 | Address | Address *)
1108 12345 Address Range Address Range
1447 1 2 3 4 5 | Address | Address *)
1654 7 8 9 10 | Address | Address
1764 678| I/O Address
2061 1 2 3 4 5 | Address | Address *)
2207 1 2 3 4 5 | Address | Address *)
2579 4 5 6 7 8 | Address | Address *)
2773 8 7 6 5 4 | Address | Address
2956 1 2 3 4 5 | Address | Address *)
[all …]
|
| /linux-6.15/drivers/ras/amd/atl/ |
| H A D | Kconfig | 3 # AMD Address Translation Library Kconfig
11 tristate "AMD Address Translation Library"
|
| /linux-6.15/Documentation/devicetree/bindings/remoteproc/ |
| H A D | ti,k3-dsp-rproc.yaml | 99 - description: Address and Size of the L2 SRAM internal memory region
100 - description: Address and Size of the L1 PRAM internal memory region
101 - description: Address and Size of the L1 DRAM internal memory region
118 - description: Address and Size of the L2 SRAM internal memory region
119 - description: Address and Size of the L1 DRAM internal memory region
134 - description: Address and Size of the L2 SRAM internal memory region
|
| /linux-6.15/Documentation/devicetree/bindings/ata/ |
| H A D | ti,da850-ahci.yaml | 18 - description: Address and size of the register map as defined by the AHCI 1.1 standard.
20 … Address and size of Power Down Control Register (PWRDN) for enabling/disabling the SATA clock
|
| /linux-6.15/Documentation/devicetree/bindings/arm/ |
| H A D | arm,coresight-catu.yaml | 7 title: Arm Coresight Address Translation Unit (CATU)
23 The CoreSight Address Translation Unit (CATU) translates addresses between an
62 description: Address translation error interrupt
|
| /linux-6.15/Documentation/admin-guide/RAS/ |
| H A D | address-translation.rst | 3 Address translation
16 AMD Address Translation Library (CONFIG_AMD_ATL) provides translation for
|
| /linux-6.15/drivers/staging/rtl8723bs/core/ |
| H A D | rtw_efuse.c | 170 u16 Address) in EFUSE_Read1Byte() argument
179 if (Address < contentLen) {/* E-fuse 512Byte */ in EFUSE_Read1Byte()
181 temp = Address & 0xFF; in EFUSE_Read1Byte()
185 temp = ((Address >> 8) & 0x03) | (Bytetemp & 0xFC); in EFUSE_Read1Byte()
|
| /linux-6.15/Documentation/devicetree/bindings/mtd/ |
| H A D | orion-nand.txt | 9 - cle : Address line number connected to CLE. Default is 0
10 - ale : Address line number connected to ALE. Default is 1
|
| /linux-6.15/drivers/scsi/mpt3sas/mpi/ |
| H A D | mpi2.h | 879 U32 Address; member
885 U64 Address; member
908 U32 Address; member
916 U64 Address; member
1130 U32 Address; member
1136 U64 Address; member
1172 U64 Address; member
|
| /linux-6.15/Documentation/devicetree/bindings/usb/ |
| H A D | atmel-usb.txt | 8 - reg: Address and length of the register set for the device
35 - reg: Address and length of the register set for the device
62 - reg: Address and length of the register set for the device
93 - reg: Address and length of the register set for the device
|
| /linux-6.15/Documentation/hwmon/ |
| H A D | smsc47b397.rst | 40 pair is located at the HWM Base Address + 0 and the HWM Base Address + 1. The
42 and 0x61 (LSB). Currently we are using 0x480 for the HWM Base Address and
170 Obtaining the HWM Base Address
173 The following is an example of how to read the HWM Base Address located in
|
| /linux-6.15/Documentation/scsi/ |
| H A D | hptiop.rst | 89 0x4000 Inbound List Base Address Low
90 0x4004 Inbound List Base Address High
93 0x4050 Outbound List Base Address Low
94 0x4054 Outbound List Base Address High
95 0x4058 Outbound List Copy Pointer Shadow Base Address Low
96 0x405C Outbound List Copy Pointer Shadow Base Address High
|
| /linux-6.15/drivers/message/fusion/lsi/ |
| H A D | mpi.h | 360 U32 Address; member
367 U64 Address; member
391 U32 Address; member
400 U64 Address; member
|