Searched refs:AUX_CS (Results 1 – 3 of 3) sorted by relevance
| /linux-6.15/drivers/staging/gpib/tms9914/ |
| H A D | tms9914.c | 101 write_byte(priv, AUX_SIC | AUX_CS, AUXCR); in tms9914_interface_clear()
113 write_byte(priv, AUX_SRE | AUX_CS, AUXCR); in tms9914_remote_enable()
140 write_byte(priv, AUX_STDL | AUX_CS, AUXCR); in tms9914_t1_delay()
147 write_byte(priv, AUX_VSTDL | AUX_CS, AUXCR); in tms9914_t1_delay()
171 write_byte(priv, AUX_HLDE | AUX_CS, AUXCR); in tms9914_set_holdoff_mode()
176 write_byte(priv, AUX_HLDA | AUX_CS, AUXCR); in tms9914_set_holdoff_mode()
215 write_byte(priv, AUX_CS | AUX_RPP, AUXCR); in tms9914_parallel_poll()
262 write_byte(priv, AUX_RSV2 | AUX_CS, AUXCR); in tms9914_serial_poll_response()
633 write_byte(priv, AUX_LON | AUX_CS, AUXCR); in check_my_address_state()
647 write_byte(priv, AUX_TON | AUX_CS, AUXCR); in check_my_address_state()
[all …]
|
| /linux-6.15/drivers/staging/gpib/include/ |
| H A D | tms9914.h | 248 AUX_CS = 0x80, /* set bit instead of clearing it, used with commands marked 'd' below */ enumerator
251 AUX_VAL = (AUX_INVAL | AUX_CS), // release dac holdoff, valid command byte
|
| /linux-6.15/drivers/staging/gpib/agilent_82357a/ |
| H A D | agilent_82357a.c | 805 write.value |= AUX_CS; in agilent_82357a_interface_clear()
827 write.value |= AUX_CS; in agilent_82357a_remote_enable()
962 writes[0].value = AUX_CS | AUX_RPP; in agilent_82357a_parallel_poll()
1393 writes[0].value = AUX_CS | AUX_CHIP_RESET; in agilent_82357a_go_idle()
|