| /freebsd-14.2/sys/contrib/device-tree/Bindings/power/reset/ |
| H A D | gpio-poweroff.txt | 10 output, and drive active, so triggering a level triggered power off
12 triggering positive edge triggered power off. After a delay of 100ms,
14 triggering negative edge triggered power off. After another 100ms
|
| H A D | gpio-restart.txt | 12 triggering a level triggered reset condition. This will also cause an
13 inactive->active edge condition, triggering positive edge triggered
15 inactive, thus causing an active->inactive edge, triggering negative edge
|
| H A D | gpio-restart.yaml | 21 is configured as an output, and driven active, triggering a level triggered reset condition.
22 This will also cause an inactive->active edge condition, triggering positive edge triggered
24 active->inactive edge, triggering negative edge triggered reset. After a delay specified by
|
| /freebsd-14.2/contrib/ntp/ |
| H A D | check-scm-rev.mf | 6 @: FRC.scm-rev is always out of date, triggering the check every make invocation.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mips/cavium/ |
| H A D | ciu3.txt | 13 The second cell indicates the triggering semantics, and may have a
|
| H A D | cib.txt | 19 CIB. The second cell specifies the triggering semantics of the
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | gpio-thunderx.txt | 16 - Second cell is triggering flags as defined in interrupts.txt.
|
| H A D | cavium-octeon-gpio.txt | 20 triggering protocol and may have one of four values:
|
| H A D | brcm,kona-gpio.txt | 9 GPIO controller only supports edge, not level, triggering of interrupts.
|
| /freebsd-14.2/contrib/llvm-project/lldb/source/Plugins/Trace/intel-pt/ |
| H A D | TraceIntelPTProperties.td | 9 "packet must have been decoded before triggering the verification of "
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/firmware/ |
| H A D | nvidia,tegra210-bpmp.txt | 20 and for triggering messages ("tx")
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/iio/proximity/ |
| H A D | parallax-ping.yaml | 30 Definition of the GPIO for the triggering and echo (output and input)
|
| H A D | devantech-srf04.yaml | 36 Definition of the GPIO for the triggering (output)
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/power/supply/ |
| H A D | maxim,max77693.yaml | 61 Threshold voltage in uV for triggering input voltage regulation loop.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/interconnect/ |
| H A D | qcom,bcm-voter.yaml | 27 upon triggering. If not specified, then the AMC and WAKE sets wait for
|
| /freebsd-14.2/sys/contrib/xen/ |
| H A D | physdev.h | 246 uint8_t triggering; member
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/interrupt-controller/ |
| H A D | apple,aic.yaml | 23 - Software triggering (ORed with hw line)
|
| H A D | apple,aic2.yaml | 21 - Software triggering (ORed with hw line)
|
| /freebsd-14.2/sys/dev/mmc/ |
| H A D | mmcbus_if.m | 65 # Pause re-tuning, optionally with triggering re-tuning up-front. Requires
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mfd/ |
| H A D | max77693.txt | 72 triggering input voltage regulation loop. If input voltage decreases
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mailbox/ |
| H A D | omap-mailbox.txt | 106 to send messages without triggering a Tx ready interrupt,
|
| H A D | ti,omap-mailbox.yaml | 108 messages without triggering a Tx ready interrupt, and to control
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/leds/ |
| H A D | common.yaml | 177 List of devices which should be used as a source triggering this LED
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/thermal/ |
| H A D | nvidia,tegra124-soctherm.txt | 72 required for triggering an interrupt. Interrupts are not triggered if
|
| /freebsd-14.2/contrib/libxo/xohtml/external/ |
| H A D | jquery.qtip.js | 124 this.hiddenDuringWait = this.positioning = this.triggering = FALSE;
290 !this.triggering && this.hide();
1375 this.triggering = TRUE;
1377 this.triggering = FALSE;
|