Home
last modified time | relevance | path

Searched refs:jack (Results 1 – 25 of 57) sorted by relevance

123

/freebsd-14.2/sys/contrib/device-tree/Bindings/sound/
H A Drt5640.txt38 - realtek,jack-detect-source
40 0: jack-detect is not used
41 1: Use GPIO1 for jack-detect
42 2: Use JD1_IN4P for jack-detect
43 3: Use JD2_IN4N for jack-detect
44 4: Use GPIO2 for jack-detect
45 5: Use GPIO3 for jack-detect
46 6: Use GPIO4 for jack-detect
48 - realtek,jack-detect-not-inverted
49 bool. Normal jack-detect switches give an inverted signal, set this bool
[all …]
H A Drt5651.txt19 - realtek,jack-detect-source
21 1: Use JD1_1 pin for jack-detect
22 2: Use JD1_2 pin for jack-detect
23 3: Use JD2 pin for jack-detect
25 - realtek,jack-detect-not-inverted
26 bool. Normal jack-detect switches give an inverted (active-low) signal,
27 set this bool in the rare case you've a jack-detect switch which is not
H A Dda7218.txt56 - dlg,jack-rate-us : Time between jack detect measurements (us)
58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect
60 - dlg,jack-threshold-pct : Threshold level for jack detection (% of VDD)
64 - dlg,discharge : Boolean flag, auto discharge of Mic Bias on jack removal
97 dlg,jack-rate-us = <40>;
98 dlg,jack-debounce = <2>;
99 dlg,jack-threshold-pct = <84>;
H A Deverest,es8326.yaml30 everest,jack-pol:
33 just the value of reg 57. Bit(3) decides whether the jack polarity is inverted.
56 everest,jack-detect-inverted:
59 Defined to invert the jack detection.
66 Bit(3) 1 means PIN9 is the irq source for jack detection. When set to 0,
68 Bit(4) 1 means PIN27 is the irq source for jack detection.
86 Bit(6) 1 means the chip do not detect jack type after button released.
87 0 means the chip detect jack type again after button released.
112 everest,jack-pol = [0e];
H A Dda7219.txt49 - dlg,btn-cfg : Periodic button press measurements for 4-pole jack (ms)
53 - dlg,jack-ins-deb : Debounce time for jack insertion (ms)
55 - dlg,jack-det-rate: Jack type detection latency (3/4 pole)
57 - dlg,jack-rem-deb : Debounce time for jack removal (ms)
100 dlg,jack-ins-deb = <20>;
101 dlg,jack-det-rate = "32ms_64ms";
102 dlg,jack-rem-deb = <1>;
H A Dqcom,msm8916-wcd-analog.txt16 "mbhc_ins_rem_det1" - jack insert removal detect interrupt 1.
19 "mbhc_ins_rem_det" - jack insert removal detect interrupt.
42 - qcom,hphl-jack-type-normally-open: boolean, present if hphl pin on jack is a
44 its assumed that hphl pin on jack is NC
46 - qcom,gnd-jack-type-normally-open: boolean, present if gnd pin on jack is
48 its assumed that gnd pin on jack is NC
H A Dnau8821.txt11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
33 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
34 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
52 nuvoton,jack-insert-debounce = <7>;
53 nuvoton,jack-eject-debounce = <7>;
H A Dnokia,rx51.txt10 - jack-detection-gpios: GPIO for jack detection
24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
H A Dnau8825.txt11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
69 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
70 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
105 nuvoton,jack-insert-debounce = <7>;
106 nuvoton,jack-eject-debounce = <7>;
H A Dqcom,wcd938x.yaml73 qcom,hphl-jack-type-normally-closed:
74 description: Indicates that HPHL jack switch type is normally closed
77 qcom,ground-jack-type-normally-closed:
126 qcom,hphl-jack-type-normally-closed;
127 qcom,ground-jack-type-normally-closed;
H A Dimx-audio-es8328.txt7 - jack-gpio : Optional GPIO for headphone jack
47 jack-gpio = <&gpio5 15 0>;
H A Dqcom,wcd934x.yaml82 qcom,hphl-jack-type-normally-closed:
83 description: Indicates that HPHL jack switch type is normally closed
86 qcom,ground-jack-type-normally-closed:
219 qcom,hphl-jack-type-normally-closed;
220 qcom,ground-jack-type-normally-closed;
H A Dalc5623.txt14 - jack-det-ctrl: Default register value for Reg-5Ah, Jack Detect
24 jack-det-ctrl = <0x4810>;
H A Drt5645.txt41 1 : Mode-0 (VDD=3.3V), two port jack detection
42 2 : Mode-1 (VDD=3.3V), one port jack detection
43 3 : Mode-2 (VDD=1.8V), one port jack detection
H A Domap-abe-twl6040.txt15 - ti,jack-detection: Need to be present if the board capable to detect jack
62 ti,jack-detection;
H A Dimx-audio-spdif.txt17 or jack on the board or it's connecting to some
23 is a physical S/PDIF in connector/jack on the board.
H A Dimx-audio-hdmi.yaml31 connector or jack on the board or it's connecting to some other IP
39 connector/jack on the board.
H A Dwm8960.txt21 enabled and disabled together with HP_L and HP_R pins in response to jack
24 - wlf,hp-cfg: A list of headphone jack detect configuration register values.
H A Dnau8824.txt64 - nuvoton,jack-eject-debounce: Jack ejection debounce time.
87 nuvoton,jack-eject-debounce = <1>;
H A Dwlf,wm8960.yaml33 HP_R pins in response to jack detect events.
47 A list of headphone jack detect configuration register values:
H A Drt1019.yaml10 - jack[email protected]
/freebsd-14.2/sys/contrib/device-tree/src/arm64/mediatek/
H A Dmt8183-kukui-audio-da7219.dtsi30 dlg,jack-ins-deb = <20>;
31 dlg,jack-det-rate = "32ms_64ms";
32 dlg,jack-rem-deb = <1>;
/freebsd-14.2/sys/contrib/device-tree/Bindings/extcon/
H A Dwlf,arizona.yaml32 Use the additional JD input along with JD1 for dual pin jack detection.
37 Internal pull on JD2 is disabled when used for jack detection.
42 Invert the polarity of the jack detection switch.
/freebsd-14.2/contrib/netbsd-tests/ipf/regress/
H A Dip33 pool ipf/dstlist (name jack; policy weighted connection;)
/freebsd-14.2/contrib/netbsd-tests/ipf/expected/
H A Dip33 pool ipf/dstlist (name jack; policy weighting connection;)

123