| /freebsd-14.2/contrib/libpcap/doc/ |
| H A D | README.septel | 25 incorrectly specified or the Septel software was not built before configuring
34 when configuring libpcap:
47 configuring parameters.
|
| H A D | README.dag | 22 incorrectly specified or the DAG software was not built before configuring
31 configuring libpcap:
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mmc/ |
| H A D | sdhci-st.txt | 9 to set the internal glue logic used for configuring the MMC
34 - non-removable: Non-removable slot. Also used for configuring mmcss in STiH407 SoC
42 configuring the CCONFIG3 in the mmcss.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/phy/ |
| H A D | ti,phy-am654-serdes.yaml | 44 description: Phandle to the SYSCON entry required for configuring SERDES clock selection.
52 description: Phandle to the SYSCON entry required for configuring SERDES lane function.
|
| H A D | phy-cpcap-usb.txt | 16 mode-gpios: Optional GPIOs for configuring alternate modes
|
| H A D | ti-phy-gmii-sel.txt | 6 The interface mode is selected by configuring the MII mode selection register(s)
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/powerpc/fsl/ |
| H A D | cache_sram.txt | 4 option of configuring a part of (or full) cache memory
|
| /freebsd-14.2/contrib/unbound/ |
| H A D | systemd.m4 | 1 # macros for configuring systemd
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/hwmon/ |
| H A D | ltc2990.txt | 7 An array of two integers for configuring the chip measurement mode.
|
| /freebsd-14.2/share/examples/sound/oss/ |
| H A D | README | 11 configuring sample rate, bit depth and all other configuring of the device
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/net/ |
| H A D | microchip,lan78xx.txt | 14 - microchip,led-modes: a 0..4 element vector, with each element configuring
|
| H A D | xilinx_gmii2rgmii.txt | 10 Different speed modes by configuring the conveter register through mdio write.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mfd/ |
| H A D | aspeed-scu.txt | 2 configuring elements such as clocks, pinmux, and reset.
|
| H A D | aspeed,ast2x00-scu.yaml | 11 configuring elements such as clocks, pinmux, and reset.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/i2c/ |
| H A D | i2c-opal.txt | 5 used by the firmware itself for configuring the port. From the linux
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/clock/ |
| H A D | airoha,en7523-scu.yaml | 15 a collection of registers configuring many different aspects of the SoC.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/media/i2c/ |
| H A D | adv7343.txt | 19 - ad,adv7343-power-mode-dac: array configuring the power on/off DAC's 1..6,
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/pci/ |
| H A D | ti,am65-pci-ep.yaml | 40 description: Phandle to the SYSCON entry required for configuring PCIe in RC or EP mode.
|
| /freebsd-14.2/contrib/wpa/wpa_supplicant/ |
| H A D | todo.txt | 36 - www pages about configuring wpa_supplicant:
53 - try to work around race in configuring PTK and sending msg 4/4 (some NDIS
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/net/wireless/ |
| H A D | qca,ath9k.yaml | 13 This node provides properties for configuring the ath9k wireless device.
|
| H A D | qca,ath9k.txt | 3 This node provides properties for configuring the ath9k wireless device. The
|
| H A D | mediatek,mt76.txt | 3 This node provides properties for configuring the MediaTek mt76xx wireless
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/display/bridge/ |
| H A D | fsl,ldb.yaml | 14 for configuring the on-SoC DPI-to-LVDS serializer. This describes
|
| /freebsd-14.2/sys/contrib/device-tree/src/arm/ |
| H A D | keystone-k2e-clocks.dtsi | 79 * (as cpts, for example) by configuring corresponding clock muxes.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/gpu/host1x/ |
| H A D | nvidia,tegra210-nvdec.yaml | 69 configuring engine-specific behavior in Host1x.
|