| /freebsd-14.2/sys/contrib/device-tree/Bindings/bus/ |
| H A D | brcm,gisb-arb.txt | 6 "brcm,bcm7278-gisb-arb" for V7 28nm chips 7 "brcm,gisb-arb" or "brcm,bcm7445-gisb-arb" for other 28nm chips 8 "brcm,bcm7435-gisb-arb" for newer 40nm chips 9 "brcm,bcm7400-gisb-arb" for older 40nm chips and all 65nm chips 10 "brcm,bcm7038-gisb-arb" for 130nm chips
|
| H A D | brcm,gisb-arb.yaml | 17 - brcm,bcm7445-gisb-arb # for other 28nm chips 21 - brcm,bcm7278-gisb-arb # for V7 28nm chips 22 - brcm,bcm7435-gisb-arb # for newer 40nm chips 23 - brcm,bcm7400-gisb-arb # for older 40nm chips and all 65nm chips 24 - brcm,bcm7038-gisb-arb # for 130nm chips
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/net/bluetooth/ |
| H A D | nxp,88w8987-bt.yaml | 7 title: NXP Bluetooth chips 10 This binding describes UART-attached NXP bluetooth chips. These chips 11 are dual-radio chips supporting WiFi and Bluetooth. The bluetooth
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/powerpc/fsl/ |
| H A D | ccf.txt | 12 Example chips: T4240, B4860 15 Example chips: P5040, P5020, P4080, P3041, P2041 20 used for both CCF version 1 chips and CCF version 2 21 chips. It should be specified after either
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | gpio-max3191x.txt | 17 Number of chips in the daisy-chain (default is 1). 21 (if all chips are wired to the same pin). 30 - maxim,modesel-8bit: Boolean whether the modesel pin of the chips is 39 (in 16-bit mode). Use this if the chips are powered
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mtd/ |
| H A D | jedec,spi-nor.txt | 1 * SPI NOR flash: ST M25Pxx (and similar) serial flash chips 51 designate quirky versions of flash chips that do not support the 69 all chips and support for it can not be detected at runtime. 70 Refer to your chips' datasheet to check if this is supported
|
| H A D | cypress,hyperflash.txt | 1 Bindings for HyperFlash NOR flash chips compliant with Cypress HyperBus 5 - compatible : "cypress,hyperflash", "cfi-flash" for HyperFlash NOR chips
|
| H A D | arm-versatile.txt | 3 These flash chips are found in the ARM reference designs like Integrator, 6 They are regular CFI compatible (Intel or AMD extended) flash chips with
|
| H A D | jedec,spi-nor.yaml | 7 title: SPI NOR flash ST M25Pxx (and similar) serial flash chips 57 "read" opcode. This opcode is not supported by all chips and support for 58 it can not be detected at runtime. Refer to your chips' datasheet to check
|
| H A D | cadence-nand-controller.txt | 24 Child nodes represent the available NAND chips. 26 Required properties of NAND chips:
|
| H A D | mtd-physmap.txt | 3 Flash chips (Memory Technology Devices) are often used for solid state 11 non-identical chips can be described in one node. 13 device width times the number of interleaved chips.
|
| H A D | mtd-physmap.yaml | 13 Flash chips (Memory Technology Devices) are often used for solid state 68 non-identical chips can be described in one node. 74 the number of interleaved chips.
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/memory-controllers/ddr/ |
| H A D | jedec,lpddr-channel.yaml | 11 CK, etc.) that connect one or more LPDDR chips to a host system. The main 13 amount of individual LPDDR chips and the ranks per chip. 32 chips, and the CA, CS, etc. pins of the different chips all shorted
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/arm/tegra/ |
| H A D | nvidia,tegra20-ahb.txt | 9 Tegra20, Tegra30, and Tegra114 chips, the value must be <0x6000c004 10 0x10c>. For Tegra124, Tegra132 and Tegra210 chips, the value should
|
| /freebsd-14.2/sys/dev/bxe/ |
| H A D | bxe_dump.h | 60 uint32_t chips; member 69 uint32_t chips; member
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | pinctrl-mcp23s08.txt | 28 multiple chips on the same chipselect. Have a look at 31 Required device specific properties (only for SPI chips): 34 chips - as the name suggests. Multiple SPI chips can share the same 40 least one bit to 1 for SPI chips. 58 IO 8-15 are bank 2. These chips have two different interrupt outputs:
|
| H A D | ste,nomadik.txt | 6 - nomadik-gpio-chips: array of phandles to the corresponding GPIO chips 79 nomadik-gpio-chips = <&gpio0>, <&gpio1>, <&gpio2>, <&gpio3>;
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/iio/adc/ |
| H A D | renesas,rcar-gyroadc.yaml | 80 thus for 8-channel operation, 8 chips are required. 82 of the TI/ADI chips to the GyroADC, while MISO line of each 88 8-channel operation, 8 chips are required. 90 of the MAX chips to the GyroADC, while MISO line of each Maxim
|
| H A D | renesas,gyroadc.txt | 48 8 chips are required. A 3:8 chipselect demuxer is 49 required to connect the nCS line of the TI/ADI chips 57 8 chips are required. A 3:8 chipselect demuxer is 58 required to connect the nCS line of the MAX chips
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/media/ |
| H A D | si4713.txt | 13 - interrupts-extended: Interrupt specifier for the chips interrupt 14 - reset-gpios: GPIO specifier for the chips reset line
|
| /freebsd-14.2/tools/tools/ifinfo/ |
| H A D | rfc1650.c | 89 const char *const *chips; member 122 printf("%s\n", chipset_names[vendor].chips[part]); in identify_chipset()
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/sound/ |
| H A D | tas571x.txt | 25 - AVDD-supply: regulator phandle for the AVDD supply (all chips) 26 - DVDD-supply: regulator phandle for the DVDD supply (all chips)
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/display/mediatek/ |
| H A D | mediatek,hdmi.txt | 9 - the supported chips are mt2701, mt7623 and mt8173 36 - the supported chips are mt7623 and mt8173 49 - the supported chips are mt7623 and mt8173
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/mux/ |
| H A D | mux-controller.yaml | 35 it is idle. For multiplexer chips that expose several mux controllers, the 40 mux controller chips with more than one mux controller, particularly when 93 left as is when it is idle. For multiplexer chips that expose several mux 99 mux controller chips with more than one mux controller, particularly when
|
| /freebsd-14.2/sys/contrib/device-tree/Bindings/gnss/ |
| H A D | sirfstar.yaml | 14 chips, starting from the SiRFstarIII which was a chip that was introduced in 20 SiRF chips can be used over UART, I2C or SPI buses.
|