| /freebsd-13.1/sys/dev/ow/ |
| H A D | ow.c | 428 uint64_t probed, last_mask; in ow_enumerate() local
444 probed = 0; in ow_enumerate()
514 probed |= 1ull << i; in ow_enumerate()
520 foundfp(dev, probed); in ow_enumerate()
521 last_mask = probed; in ow_enumerate()
|
| /freebsd-13.1/stand/libsa/ |
| H A D | smbios.c | 66 int probed; member
445 if (smbios.probed) in smbios_probe()
447 smbios.probed = 1; in smbios_probe()
|
| /freebsd-13.1/sys/xen/xenmem/ |
| H A D | xenmem_if.m | 65 * @param _dev the device whose child was being probed.
83 * @param _dev the device whose child was being probed.
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/mips/img/ |
| H A D | pistachio.txt | 14 be probed via CPS, it is not necessary to specify secondary CPUs. Required
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/openrisc/opencores/ |
| H A D | or1ksim.txt | 19 be probed via CPS, it is not necessary to specify secondary CPUs. Required
|
| /freebsd-13.1/sys/dev/bhnd/ |
| H A D | bhnd_erom_if.m | 58 * and the probed chip identification.
68 * @param[out] cid On success, the probed chip identifier.
71 * parser for the probed bus.
|
| H A D | bhnd_bus_if.m | 421 * All devices on the bhnd(4) bus will be probed, attached, or resumed in
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/reserved-memory/ |
| H A D | qcom,cmd-db.txt | 10 resource properties may change. These properties are dynamically probed by the
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/net/ |
| H A D | brcm,mdio-mux-iproc.txt | 13 Every non-ethernet PHY requires a compatible so that it could be probed based
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | sodaville.txt | 10 There is no compatible property for now because the driver is probed via
|
| /freebsd-13.1/sys/contrib/device-tree/src/mips/mti/ |
| H A D | malta.dts | 34 * controller & should be probed first.
|
| H A D | sead3.dts | 54 * controller & should be probed first.
|
| /freebsd-13.1/share/examples/drivers/ |
| H A D | README | 14 so that you may have several of your 'foobar' devices probed and attached
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/i2c/ |
| H A D | i2c-pxa-pci-ce4100.txt | 8 The driver is probed via the PCI-ID and is gathering the information of
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/remoteproc/ |
| H A D | st,stm32-rproc.yaml | 102 If defined, when remoteproc is probed, it loads the default firmware and
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/sound/ |
| H A D | st,sta32x.txt | 23 If specified, the clock will be enabled when the codec is probed,
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/fsi/ |
| H A D | fsi.txt | 6 nodes to probed engines. This allows for fsi engines to expose non-probeable
|
| /freebsd-13.1/sys/dev/acpica/ |
| H A D | acpi_if.m | 172 # called by the parent bus before the driver is probed.
|
| /freebsd-13.1/sys/contrib/device-tree/src/arm/ |
| H A D | aspeed-bmc-opp-tacoma.dts | 856 /* Hog these as no driver is probed for the entire LPC block */
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/arm/ |
| H A D | coresight.txt | 25 discovered at boot time when the device is probed.
|
| /freebsd-13.1/usr.sbin/bsdconfig/networking/share/ |
| H A D | device.subr | 165 # probed but rather taken from the positional arguments.
|
| /freebsd-13.1/stand/common/ |
| H A D | help.common | 343 On systems where memory cannot be accurately probed,
|
| /freebsd-13.1/sys/conf/ |
| H A D | NOTES | 228 # kernel startup process (before devices are probed) rather than at the
1283 # the devices were probed on the SCSI bus. This means that if you
1286 # as it may have been probed earlier and moved your device configuration
1745 # unit number of the probed UART.
2294 # are automatically probed and attached when found.
|
| /freebsd-13.1/sys/kern/ |
| H A D | bus_if.m | 118 * @param _dev the device whose child was being probed
|
| /freebsd-13.1/usr.sbin/bsdconfig/usermgmt/share/ |
| H A D | user.subr | 948 # Override values probed by f_input_user() with desired values
|