| /freebsd-13.1/sys/contrib/device-tree/Bindings/sound/ |
| H A D | rt5640.txt | 35 - realtek,jack-detect-source 37 0: jack-detect is not used 38 1: Use GPIO1 for jack-detect 39 2: Use JD1_IN4P for jack-detect 40 3: Use JD2_IN4N for jack-detect 41 4: Use GPIO2 for jack-detect 42 5: Use GPIO3 for jack-detect 43 6: Use GPIO4 for jack-detect 45 - realtek,jack-detect-not-inverted 46 bool. Normal jack-detect switches give an inverted signal, set this bool [all …]
|
| H A D | rt5651.txt | 19 - realtek,jack-detect-source 21 1: Use JD1_1 pin for jack-detect 22 2: Use JD1_2 pin for jack-detect 23 3: Use JD2 pin for jack-detect 25 - realtek,jack-detect-not-inverted 26 bool. Normal jack-detect switches give an inverted (active-low) signal, 27 set this bool in the rare case you've a jack-detect switch which is not
|
| H A D | da7218.txt | 56 - dlg,jack-rate-us : Time between jack detect measurements (us) 58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect 60 - dlg,jack-threshold-pct : Threshold level for jack detection (% of VDD) 64 - dlg,discharge : Boolean flag, auto discharge of Mic Bias on jack removal 97 dlg,jack-rate-us = <40>; 98 dlg,jack-debounce = <2>; 99 dlg,jack-threshold-pct = <84>;
|
| H A D | da7219.txt | 49 - dlg,btn-cfg : Periodic button press measurements for 4-pole jack (ms) 53 - dlg,jack-ins-deb : Debounce time for jack insertion (ms) 55 - dlg,jack-det-rate: Jack type detection latency (3/4 pole) 57 - dlg,jack-rem-deb : Debounce time for jack removal (ms) 100 dlg,jack-ins-deb = <20>; 101 dlg,jack-det-rate = "32ms_64ms"; 102 dlg,jack-rem-deb = <1>;
|
| H A D | qcom,msm8916-wcd-analog.txt | 16 "mbhc_ins_rem_det1" - jack insert removal detect interrupt 1. 19 "mbhc_ins_rem_det" - jack insert removal detect interrupt. 42 - qcom,hphl-jack-type-normally-open: boolean, present if hphl pin on jack is a 44 its assumed that hphl pin on jack is NC 46 - qcom,gnd-jack-type-normally-open: boolean, present if gnd pin on jack is 48 its assumed that gnd pin on jack is NC
|
| H A D | nokia,rx51.txt | 10 - jack-detection-gpios: GPIO for jack detection 24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
|
| H A D | nau8825.txt | 11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin. 69 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms 70 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms 99 nuvoton,jack-insert-debounce = <7>; 100 nuvoton,jack-eject-debounce = <7>;
|
| H A D | imx-audio-es8328.txt | 7 - jack-gpio : Optional GPIO for headphone jack 47 jack-gpio = <&gpio5 15 0>;
|
| H A D | alc5623.txt | 14 - jack-det-ctrl: Default register value for Reg-5Ah, Jack Detect 24 jack-det-ctrl = <0x4810>;
|
| H A D | rt5645.txt | 41 1 : Mode-0 (VDD=3.3V), two port jack detection 42 2 : Mode-1 (VDD=3.3V), one port jack detection 43 3 : Mode-2 (VDD=1.8V), one port jack detection
|
| H A D | omap-abe-twl6040.txt | 15 - ti,jack-detection: Need to be present if the board capable to detect jack 62 ti,jack-detection;
|
| H A D | imx-audio-spdif.txt | 17 or jack on the board or it's connecting to some 23 is a physical S/PDIF in connector/jack on the board.
|
| H A D | wm8960.txt | 21 enabled and disabled together with HP_L and HP_R pins in response to jack 24 - wlf,hp-cfg: A list of headphone jack detect configuration register values.
|
| H A D | nau8824.txt | 64 - nuvoton,jack-eject-debounce: Jack ejection debounce time. 87 nuvoton,jack-eject-debounce = <1>;
|
| H A D | sirf-audio.txt | 13 - hp-switch-gpios: Need to be present if the board capable to detect jack
|
| H A D | rockchip-max98090.txt | 11 - rockchip,headset-codec: The phandle of Ext chip for jack detection. This is
|
| H A D | omap-twl4030.txt | 11 - ti, jack-det-gpio: Jack detect GPIO
|
| H A D | nvidia,tegra-audio-rt5677.txt | 32 - nvidia,mic-present-gpios: The GPIO that mic jack is plugged in
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/extcon/ |
| H A D | wlf,arizona.yaml | 32 Use the additional JD input along with JD1 for dual pin jack detection. 37 Internal pull on JD2 is disabled when used for jack detection. 42 Invert the polarity of the jack detection switch.
|
| /freebsd-13.1/contrib/netbsd-tests/ipf/regress/ |
| H A D | ip3 | 3 pool ipf/dstlist (name jack; policy weighted connection;)
|
| /freebsd-13.1/contrib/netbsd-tests/ipf/expected/ |
| H A D | ip3 | 3 pool ipf/dstlist (name jack; policy weighting connection;)
|
| /freebsd-13.1/sys/contrib/device-tree/src/arm/ |
| H A D | rk3288-veyron-analog-audio.dtsi | 4 * codec and analog headphone jack.
|
| H A D | omap3-gta04a5.dts | 12 ti,jack-det-gpio = <&twl_gpio 2 GPIO_ACTIVE_HIGH>; /* GTA04A5 only */
|
| H A D | kirkwood-t5325.dts | 119 jack-det-ctrl = <0x4810>;
|
| /freebsd-13.1/sys/contrib/device-tree/src/arm64/rockchip/ |
| H A D | rk3399-gru.dtsi | 419 dlg,jack-ins-deb = <20>; 420 dlg,jack-det-rate = "32ms_64ms"; 421 dlg,jack-rem-deb = <1>;
|