Home
last modified time | relevance | path

Searched refs:MAC (Results 1 – 25 of 329) sorted by relevance

12345678910>>...14

/freebsd-13.1/tests/sys/net/
H A Dif_lagg_test.sh42 local TAP0 TAP1 LAGG MAC
62 MAC=`ifconfig $LAGG | awk '/ether/ {print $2}'`
85 local TAP0 TAP1 LAGG MAC
140 local TAP0 TAP1 LAGG MAC
200 local TAP0 TAP1 LAGG MAC SRCDIR
259 local TAP0 TAP1 LAGG MAC SRCDIR
318 local TAP0 TAP1 LAGG MAC
323 MAC="00:11:22:33:44:55"
336 atf_check ifconfig $LAGG ether ${MAC}
356 local TAP0 TAP1 LAGG MAC
[all …]
/freebsd-13.1/sys/contrib/device-tree/Bindings/net/
H A Dhisilicon-femac.txt1 Hisilicon Fast Ethernet MAC controller
9 The first region is the MAC core register base and size.
10 The second region is the global MAC control register.
11 - interrupts: should contain the MAC interrupt.
12 - clocks: A phandle to the MAC main clock.
13 - resets: should contain the phandle to the MAC reset signal(required) and
24 The MAC address will be determined using the optional properties
H A Dethernet-controller.yaml18 Specifies the MAC address that was assigned to the network device.
26 Specifies the MAC address that was last used by the boot
27 program; should be used in cases where the MAC address assigned
50 Reference to an nvmem node for the MAC address
60 # There is not a standard bus between the MAC and the PHY,
62 # MAC.
72 # RX and TX delays are added by the MAC when required
76 # the MAC should not add the RX or TX delays in this case
79 # RGMII with internal RX delay provided by the PHY, the MAC
83 # RGMII with internal TX delay provided by the PHY, the MAC
H A Dqcom-emac.txt3 This network controller consists of two devices: a MAC and an SGMII
5 connects the MAC node to its corresponding internal phy node. Another
10 MAC node:
14 - mac-address : The 6-byte MAC address. If present, it is the default
15 MAC address.
H A Dimx-dwmac.txt1 IMX8 glue layer controller, NXP imx8 families support Synopsys MAC 5.10a IP.
13 Should be "pclk" for the MAC apb clock.
14 Should be "ptp_ref" for the MAC timer clock.
15 Should be "tx" for the MAC RGMII TX clock:
21 Should be "macirq" for the main MAC IRQ
H A Dhisilicon-hix5hd2-gmac.txt14 The first region is the MAC register base and size.
16 - interrupts: should contain the MAC interrupt.
23 - resets: should contain the phandle to the MAC core reset signal(optional),
24 the MAC interface reset signal(optional)
33 The MAC address will be determined using the properties defined in
H A Daltera_tse.txt1 * Altera Triple-Speed Ethernet MAC driver (TSE)
11 "control_port": MAC configuration space region
22 - rx-fifo-depth: MAC receive FIFO buffer depth in bytes
23 - tx-fifo-depth: MAC transmit FIFO buffer depth in bytes
49 The MAC address will be determined using the optional properties defined in
H A Dftgmac100.txt27 - clocks: In accordance with the generic clock bindings. Must describe the MAC
29 required MAC clock must be the first cell.
32 - "MACCLK": The MAC IP clock
H A Dmediatek-dwmac.txt11 - interrupts: Should contain the MAC interrupts
14 Should be "macirq" for the main MAC IRQ
43 2. tx clock inside MAC will be inversed relative to reference clock
49 2. reference clock will be inversed when arrived at MAC in RMII case, when
51 3. the inside clock, which be sent to MAC, will be inversed in RMII case when
/freebsd-13.1/crypto/openssh/
H A DPROTOCOL.chacha20poly130512 Poly1305[2], also by Daniel Bernstein, is a one-time Carter-Wegman MAC
19 data passed to the MAC and in the addition of encryption of the packet
26 authentication. As such, no separate MAC is required. If the
28 the offered MAC algorithms are ignored and no MAC is required to be
49 the MAC. By using an independently-keyed cipher instance to encrypt the
52 its MAC (assuming key derivation, ChaCha20 and Poly1305 are secure).
71 Once the entire packet has been received, the MAC MUST be checked
73 above and the MAC tag calculated using Poly1305 with this key over the
75 MAC is then compared in constant time with the one appended to the
82 encrypted length. Finally, calculate a MAC tag and append it.
/freebsd-13.1/crypto/openssl/crypto/poly1305/asm/
H A Dpoly1305-c64xplus.pl267 my ($MAC,$NONCEA,$NONCEB)=($INPB,$LEN,$PADBIT);
318 STNW A22,*${MAC}[0] ; write the result
319 STNW A24,*${MAC}[1]
320 STNW A26,*${MAC}[2]
321 STNW A28,*${MAC}[3]
/freebsd-13.1/sys/mips/conf/
H A DDIR-655A1.hints10 # Use this to derive ath0 from arge0 MAC address.
11 # 0x1ffe0004 is the arge0 MAC; but it's also the "unit MAC".
12 # So make that the ath0 MAC, and make arge0 -1 from that.
15 # arge1: use +1 from the arge0 MAC, even though
16 # there's a secondary MAC address configured in EEPROM
59 # we do to hook PAD6 up to be RGMII but a PHY, not a MAC?
133 # Note: ath0 MAC is default (00:11:22:33:44:55) and thus
134 # requires replacing via the board MAC address map.
H A DDIR-825C1.hints9 # 0x1ffe0004 is the "unit MAC".
10 # 0x1ffe0018 is the second "MAC".
13 # ath0: unit MAC
14 # ath1: unit MAC + 1
15 # arge0: unit MAC + 2
/freebsd-13.1/sys/security/mac/
H A Dmac_framework.h147 #ifdef MAC
165 #ifdef MAC
242 #ifdef MAC
257 #ifdef MAC
313 #ifdef MAC
329 #ifdef MAC
497 #ifdef MAC
516 #ifdef MAC
535 #ifdef MAC
556 #ifdef MAC
[all …]
/freebsd-13.1/sys/powerpc/conf/dpaa/
H A Dfiles.dpaa52 contrib/ncsw/Peripherals/FM/MAC/dtsec.c optional dpaa \
54 contrib/ncsw/Peripherals/FM/MAC/dtsec_mii_acc.c optional dpaa \
56 contrib/ncsw/Peripherals/FM/MAC/fman_dtsec.c optional dpaa \
58 contrib/ncsw/Peripherals/FM/MAC/fman_dtsec_mii_acc.c optional dpaa \
60 contrib/ncsw/Peripherals/FM/MAC/fm_mac.c optional dpaa \
62 contrib/ncsw/Peripherals/FM/MAC/fman_dtsec.c optional dpaa \
64 contrib/ncsw/Peripherals/FM/MAC/tgec.c optional dpaa \
66 contrib/ncsw/Peripherals/FM/MAC/tgec_mii_acc.c optional dpaa \
68 contrib/ncsw/Peripherals/FM/MAC/fman_tgec.c optional dpaa \
/freebsd-13.1/crypto/openssl/doc/man1/
H A Ddgst.pod129 Create a hashed MAC using "key".
133 Create MAC (keyed Message Authentication Code). The most popular MAC
134 algorithm is HMAC (hash-based MAC), but there are other MAC algorithms
136 supported by B<ccgost> engine. MAC keys and other options should be set
141 Passes options to MAC algorithm, specified by B<-mac> key.
148 Specifies MAC key as alphanumeric string (use if key contain printable
150 the MAC algorithm for example exactly 32 chars for gost-mac.
154 Specifies MAC key in hexadecimal form (two hex digits per byte).
155 Key length must conform to any restrictions of the MAC algorithm
/freebsd-13.1/contrib/wpa/hostapd/
H A Dhostapd.accept1 # List of MAC addresses that are allowed to authenticate (IEEE 802.11)
3 # MAC address if dynamic VLANs (hostapd.conf dynamic_vlan option) are used.
/freebsd-13.1/crypto/openssl/doc/man3/
H A DPKCS12_create.pod27 iteration count to use and B<mac_iter> is the MAC iteration count to use.
37 (currently 2048) and a MAC iteration count of 1.
39 The default MAC iteration count is 1 in order to retain compatibility with
40 old software which did not interpret MAC iteration counts. If such compatibility
62 B<mac_iter> can be set to -1 and the MAC will then be omitted entirely.
/freebsd-13.1/share/examples/netgraph/
H A Dvirtual.chain239 MAC=`printf ${MAC_PREFIX}:%02x:%02x:%02x ${M4} ${M5} ${M6}`
243 echo "Setting MAC address of ${EIFACE} to '${MAC}'"
244 jexec ${NODE_NAME} ifconfig ${EIFACE} link $MAC
H A Dvirtual.lan232 MAC=`printf ${MAC_PREFIX}:%02x:%02x:%02x ${M4} ${M5} ${M6}`
236 echo "Setting MAC address of ${EIFACE} to '${MAC}'"
237 jexec ${NODE_NAME} ifconfig ${EIFACE} link $MAC
/freebsd-13.1/tools/tools/net80211/scripts/mesh/
H A Dtopology.line15 MAC=`ifconfig $WLAN | grep ether | awk '{ print $2 }'`
16 case $MAC in
H A Dtopology.tree24 MAC=`ifconfig $WLAN | grep ether | awk '{ print $2 }'`
25 case $MAC in
H A Dtopology.star14 MAC=`ifconfig $WLAN | grep ether | awk '{ print $2 }'`
15 case $MAC in
H A Dtopology.ring17 MAC=`ifconfig $WLAN | grep ether | awk '{ print $2 }'`
18 case $MAC in
/freebsd-13.1/sys/contrib/device-tree/Bindings/net/dsa/
H A Dsja1105.txt27 default (unless otherwise specified) a port is configured as MAC if it
29 (fixed-link specified, presumably because it is connected to a MAC).
40 is the PHY. The SJA1105 MAC does not apply any internal delays.
43 is the SJA1105 MAC (if hardware-supported). This is only supported
47 the clock skew must either be added by the MAC at the other end of

12345678910>>...14