| /freebsd-13.1/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | pinctrl-vt8500.txt | 3 These SoCs contain a combined Pinmux/GPIO module. Each pin may operate as
23 Each pin configuration node lists the pin(s) to which it applies, and one or
25 configuration. Each subnode only affects those parameters that are explicitly
31 - wm,pins: An array of cells. Each cell contains the ID of a pin.
44 Each of wm,function and wm,pull may contain either a single value which
|
| H A D | lantiq,pinctrl-falcon.txt | 13 subnodes. Each of these subnodes represents some desired configuration for a
21 Each subnode only affects those parameters that are explicitly listed. In
32 - lantiq,groups : An array of strings. Each string contains the name of a group.
50 - lantiq,pins : An array of strings. Each string contains the name of a pin.
|
| H A D | brcm,bcm2835-gpio.txt | 39 Each pin configuration node lists the pin(s) to which it applies, and one or
41 configuration. Each subnode only affects those parameters that are explicitly
65 - brcm,pins: An array of cells. Each cell contains the ID of a pin. Valid IDs
83 Each of brcm,function and brcm,pull may contain either a single value which
|
| H A D | pinctrl-sirf.txt | 17 Each of these subnodes represents some desired configuration for a group of pins.
20 - sirf,pins : An array of strings. Each string contains the name of a group.
|
| H A D | pinctrl-atlas7.txt | 64 Each of these subnodes represents some desired configuration for a group of pins.
67 - groups : An array of strings. Each string contains the name of a group.
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/interrupt-controller/ |
| H A D | sifive,plic-1.0.0.txt | 13 Each interrupt can be enabled on per-context basis. Any context can claim
16 Each interrupt has a configurable priority. Higher priority interrupts are
17 serviced first. Each context can specify a priority threshold. Interrupts
38 with "-1" specifying that a context is not present. Each node pointed
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/dma/ |
| H A D | st,stm32-mdma.yaml | 43 0x00: Each MDMA request triggers a buffer transfer (max 128 bytes)
44 0x1: Each MDMA request triggers a block transfer (max 64K bytes)
45 0x2: Each MDMA request triggers a repeated block transfer
46 0x3: Each MDMA request triggers a linked list transfer
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/leds/ |
| H A D | leds-netxbig.txt | 9 - timers: Timer array. Each timer entry is represented by three integers:
12 Each LED is represented as a sub-node of the netxbig-leds device.
16 - mode-val: Mode to value mapping. Each entry is represented by two integers:
|
| H A D | leds-pwm.txt | 6 Each LED is represented as a sub-node of the pwm-leds device. Each
|
| H A D | leds-gpio.yaml | 14 Each LED is represented as a sub-node of the gpio-leds device. Each
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/input/ |
| H A D | microchip,qt1050.txt | 19 Each button (key) is represented as a sub-node:
21 Each not specified key or key with linux,code set to KEY_RESERVED gets disabled
34 Each touchpad need some time to precharge. The value depends on the mechanical
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/powerpc/opal/ |
| H A D | sensor-groups.txt | 7 servers. Each child node indicates a sensor group.
11 Each child node contains below properties:
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/c6x/ |
| H A D | dscr.txt | 46 a lock register. Each tuple consists of the register offset, lock register
56 MAC addresses are contained in two registers. Each element of a MAC address
57 is contained in a single byte. This property has two tuples. Each tuple has
65 Each tuple describes a range of identical bitfields used to control one or
81 for device states controlled by the DSCR. Each tuple describes a range of
|
| /freebsd-13.1/sys/dts/ |
| H A D | bindings-mpp.txt | 7 - pin-map : array of pin configurations. Each pin is defined by 2 cells,
14 User Manual. Each pin can have many possible functions depending on the
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/media/xilinx/ |
| H A D | xlnx,video.txt | 8 video IP cores. Each video IP core is represented as documented in video.txt
18 in Documentation/devicetree/bindings/dma/dma.txt) per port. Each port
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/i2c/ |
| H A D | nuvoton,npcm7xx-i2c.yaml | 11 both master and slave mode. Each controller can switch between master and slave
12 at run time (i.e. IPMB mode). Each controller has two 16 byte HW FIFO for TX and
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/soc/fsl/cpm_qe/qe/ |
| H A D | pincfg.txt | 4 - pio-map : array of pin configurations. Each pin is defined by 6
23 tables in User Manual. Each pin can have up to 4 possible functions in
|
| /freebsd-13.1/contrib/libarchive/libarchive/test/ |
| H A D | README | 9 Each test is a function named test_foo in a file named test_foo.c.
11 Each file must start with this line:
26 Each test function can rely on the following:
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/scsi/ |
| H A D | hisilicon-sas.txt | 26 Phy interrupts : Each phy has 3 interrupt sources:
43 Phy interrupts : Each controller has 2 phy interrupts:
46 Sata interrupts : Each phy on the controller has 1 Sata
|
| /freebsd-13.1/contrib/smbfs/examples/ |
| H A D | dot.nsmbrc | 12 # This file consist from a set of sections. Each section started by section name
17 # Each section can contain zero or more parameters:
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/sound/ |
| H A D | qcom,sdm845.txt | 17 Each entry is a pair of strings, the first being the
28 Each subnode of sndcard represents either a dailink, and subnodes of each
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | nvidia,tegra186-gpio.txt | 31 implemented by the SoC. Each GPIO is assigned to a port, and a port may control
48 Each GPIO controller can generate a number of interrupt signals. Each signal
54 Each GPIO controller in fact generates multiple interrupts signals for each set
55 of ports. Each GPIO may be configured to feed into a specific one of the
|
| H A D | gpio-vf610.txt | 4 functionality. Each pair serves 32 GPIOs. The VF610 has 5 instances of
33 Note: Each GPIO port should have an alias correctly numbered in "aliases"
|
| /freebsd-13.1/sys/contrib/device-tree/Bindings/mailbox/ |
| H A D | omap-mailbox.txt | 10 Each mailbox IP block/cluster has a certain number of h/w fifo queues and output
15 (excluding the SoCs that have a Interrupt Crossbar IP). Each interrupt line is
78 Each child node should have a unique node name across all the different
88 Each of the above ti,mbox-tx and ti,mbox-rx properties should have 3 cells of
112 for details). Each value of the mboxes property should contain a phandle to the
|
| /freebsd-13.1/usr.bin/m4/ |
| H A D | NOTES | 37 the call frames and the arguments. Each frame is back-linked to a
39 each nested call is completed. Each argument is a character pointer
|