Home
last modified time | relevance | path

Searched refs:routed (Results 1 – 25 of 73) sorted by relevance

123

/f-stack/freebsd/contrib/device-tree/Bindings/leds/
H A Dleds-bcm6328.txt207 /* USB link/activity routed to USB LED */
213 /* INET activity routed to INET LED */
219 /* EPHY0 link routed to EPHY0 LED */
225 /* EPHY1 link routed to EPHY1 LED */
231 /* EPHY2 link routed to EPHY2 LED */
237 /* EPHY3 link routed to EPHY3 LED */
265 /* EPHY0/1/2/3 link routed to EPHY0 LED */
293 /* EPHY3 link routed to EPHY0 LED */
299 /* EPHY2 link routed to EPHY1 LED */
305 /* EPHY1 link routed to EPHY2 LED */
[all …]
/f-stack/freebsd/contrib/device-tree/src/arm/
H A Darmada-385-turris-omnia.dts161 /* routed to PCIe0/mSATA connector (CN7A) */
169 /* routed to PCIe1/USB2 connector (CN61A) */
177 /* routed to PCIe2 connector (CN62A) */
185 /* routed to SFP+ */
344 /* MISO, MOSI, SCLK and CS1 are routed to pin header CN11 */
H A Dberlin2cd-valve-steamlink.dts66 /* RX/TX are routed to TP50/TP51 on the board. */
H A Dlogicpd-torpedo-37xx-devkit.dts28 * MMC3 can be routed with jumpers to the second MMC slot on the devkit and
H A Dkirkwood-blackarmor-nas220.dts95 * Serial port routed to connector CN5
/f-stack/freebsd/contrib/device-tree/Bindings/interrupt-controller/
H A Dinterrupts.txt13 which the interrupts are routed; see section 2 below for details.
20 interrupts are routed and contains a single phandle referring to the interrupt
116 interrupts routed to them, so that they can wakeup the SoC from suspend. These
H A Driscv,cpu-intc.txt7 Every interrupt is ultimately routed through a hart's HLIC before it
15 interrupts connect all other device interrupts to the HLIC, which are routed
H A Dbrcm,bcm6345-l1-intc.txt13 peripheral IRQs to be routed to any CPU
H A Dbrcm,bcm7038-l1-intc.txt14 peripheral IRQs to be routed to any CPU
/f-stack/freebsd/netpfil/pf/
H A Dpf_mtag.h52 u_int8_t routed; member
/f-stack/freebsd/contrib/device-tree/Bindings/thermal/
H A Dti_soc_thermal.txt20 the talert signal is routed to;
23 line the tshut signal is routed to. The informed GPIO will
/f-stack/freebsd/contrib/device-tree/Bindings/clock/
H A Dlpc1850-ccu.txt22 Shall contain a list of phandles for the base clocks routed
26 Shall contain a list of names for the base clock routed
H A Dlpc1850-creg-clk.txt9 The 32 kHz can also be routed to other peripherials to enable low
/f-stack/freebsd/contrib/device-tree/Bindings/net/
H A Dicplus-ip101ag.txt17 interrupts are not routed outside the PHY in this mode.
/f-stack/freebsd/contrib/device-tree/src/powerpc/
H A Dmpc5121ads.dts74 * all irqs but touch screen are routed to irq0 (ipic 48)
75 * touch screen is statically routed to irq1 (ipic 17)
/f-stack/freebsd/contrib/device-tree/Bindings/mailbox/
H A Domap-mailbox.txt11 interrupt lines. An output interrupt line is routed to an interrupt controller
25 routed to different processor sub-systems on DRA7xx as they are routed through
29 all these clusters are multiplexed and routed to different processor subsystems
/f-stack/freebsd/contrib/device-tree/src/arm64/bitmain/
H A Dbm1880-sophon-edge.dts13 * NC = not connected (pin out but not routed from the chip to
22 * For the lines routed to the external connectors the
/f-stack/freebsd/contrib/device-tree/Bindings/connector/
H A Dusb-connector.yaml162 # Micro-USB connector with HS lines routed via controller (MUIC).
172 # USB-C connector attached to CC controller (s2mm005), HS lines routed
174 # DisplayPort video lines are routed to the connector via SS mux in USB3 PHY.
H A Dsamsung,usb-connector-11pin.txt27 Micro-USB connector with HS lines routed via controller (MUIC) and MHL lines
/f-stack/freebsd/contrib/device-tree/Bindings/watchdog/
H A Dti,rti-wdt.yaml17 generated can be routed to either interrupt a safety controller or
/f-stack/dpdk/drivers/common/octeontx2/
H A Dotx2_dev.c176 int offset, routed = 0; struct otx2_mbox *mbox = &dev->mbox_vfpf; in vf_pf_process_msgs() local
224 routed++; in vf_pf_process_msgs()
229 if (routed > 0) { in vf_pf_process_msgs()
231 dev->pf, routed, vf); in vf_pf_process_msgs()
232 af_pf_wait_msg(dev, vf, routed); in vf_pf_process_msgs()
/f-stack/freebsd/contrib/device-tree/src/arm64/hisilicon/
H A Dhi6220-hikey.dts349 * NC = not connected (not routed from the SoC)
359 * For the lines routed to the external connectors the
488 /* GPIO blocks 16 thru 19 do not appear to be routed to pins */
/f-stack/freebsd/contrib/device-tree/src/arm64/actions/
H A Ds900-bubblegum-96.dts69 * NC = not connected (pin out but not routed from the chip to
78 * For the lines routed to the external connectors the
/f-stack/freebsd/contrib/device-tree/Bindings/arm/omap/
H A Dcrossbar.txt14 - ti,max-crossbar-sources: Maximum number of crossbar sources that can be routed.
/f-stack/freebsd/contrib/device-tree/Bindings/soc/mediatek/
H A Dpwrap.txt14 The signals of these pins are routed over the SPI bus using the pwrap

123