Home
last modified time | relevance | path

Searched refs:parallel (Results 1 – 25 of 136) sorted by relevance

123456

/f-stack/freebsd/contrib/device-tree/Bindings/sound/
H A Dimg,parallel-out.txt5 - compatible : Compatible list, must contain "img,parallel-out".
22 - resets: Contains a phandle to the parallel out reset signal
28 - interrupts : Contains the parallel out interrupt, if present
32 parallel_out: parallel-out@18100c00 {
33 compatible = "img,parallel-out";
H A Dimg,spdif-out.txt28 - interrupts : Contains the parallel out interrupt, if present
/f-stack/freebsd/contrib/device-tree/Bindings/media/i2c/
H A Dov5640.txt1 * Omnivision OV5640 MIPI CSI-2 / parallel sensor
25 OV5640 can be connected to a MIPI CSI-2 bus or a parallel bus endpoint.
32 Endpoint node required properties for parallel connection are:
34 - bus-width: shall be set to <8> for 8 bits parallel bus
35 or <10> for 10 bits parallel bus
36 - data-shift: shall be set to <2> for 8 bits parallel bus
37 (lines 9:2 are used) or <0> for 10 bits parallel bus
H A Dtvp5150.txt39 endpoint (video bitstream output at YOUT[0-7] parallel bus)
41 Required Endpoint Properties for parallel synchronization on output port:
H A Dadv7180.txt4 digital interfaces like MIPI CSI-2 or parallel video.
/f-stack/freebsd/contrib/device-tree/Bindings/media/
H A Dstih407-c8sectpfe.txt28 - pinctrl-names : a pinctrl state named tsin%d-serial or tsin%d-parallel (where %d is tsin-num)
43 - serial-not-parallel : Bool property to configure input bus width (serial on ts_data<7>).
65 "tsin0-parallel",
75 serial-not-parallel;
83 serial-not-parallel;
H A Dsamsung-fimc.txt93 'parallel-ports' node
96 This node should contain child 'port' nodes specifying active parallel video
109 I2C0) nodes and linked to a port node in the csis or the parallel-ports node,
172 /* parallel camera ports */
173 parallel-ports {
H A Dimx.txt33 controller's 32-bit output image bus onto four 16-bit parallel busses
47 through 4 are output ports connecting with parallel
H A Drenesas,vin.yaml17 Each VIN instance has a single parallel input that supports RGB and YUV video,
72 A node containing a parallel input with a single endpoint definitions as
133 Input port node, single endpoint describing a parallel input source.
360 # Device node example for Gen3 platform with CSI-2 and parallel
/f-stack/freebsd/contrib/device-tree/src/arm/
H A Dgemini-wbd111.dts46 /* Conflict with TVC and extended parallel flash */
52 /* Conflict with TVC and extended parallel flash */
58 /* Conflict with TVC and extended parallel flash */
64 /* Conflict with TVC and extended parallel flash */
H A Dgemini-wbd222.dts45 /* Conflict with TVC and extended parallel flash */
51 /* Conflict with TVC and extended parallel flash */
57 /* Conflict with TVC and extended parallel flash */
63 /* Conflict with TVC and extended parallel flash */
H A Dstihxxx-b2120.dtsi169 "tsin0-parallel",
179 serial-not-parallel;
H A Dimx6dl-aristainetos_7.dts21 compatible = "fsl,imx-parallel-display";
/f-stack/freebsd/contrib/device-tree/Bindings/i2c/
H A Di2c-pca-platform.txt4 parallel-bus microcontrollers/microprocessors and the serial I2C-bus
5 and allows the parallel bus system to communicate bi-directionally
/f-stack/freebsd/contrib/device-tree/Bindings/display/bridge/
H A Dthine,thc63lvd1024.yaml15 streams to parallel data outputs. The chip supports single/dual input/output
56 description: First digital CMOS/TTL parallel output
60 description: Second digital CMOS/TTL parallel output
H A Dlvds-codec.yaml62 For LVDS encoders, port 0 is the parallel input
69 For LVDS decoders, port 1 is the parallel output
/f-stack/freebsd/contrib/device-tree/Bindings/phy/
H A Dmxs-usb-phy.txt18 high-speed trimming resistor connected in parallel with the 45 ohm resistor
21 high-speed trimming resistor connected in parallel with the 45 ohm resistor
/f-stack/freebsd/contrib/device-tree/Bindings/mux/
H A Dadi,adg792a.txt5 - #mux-control-cells : <0> if parallel (the three muxes are bound together
53 * Three parallel muxes with one mux controller, useful e.g. if
/f-stack/app/redis-5.0.5/
H A Dsentinel.conf121 sentinel parallel-syncs mymaster 1
/f-stack/freebsd/contrib/libsodium/
H A Dappveyor.yml23 parallel: true
/f-stack/dpdk/doc/guides/prog_guide/
H A Dmeson_ut.rst48 * ``is_parallel`` is used to run test case either in parallel or non-parallel mode.
H A Dpacket_classif_access_ctrl.rst300 …This effectively provides a "parallel lookup" by enabling a single search to return multiple resul…
373 * **RTE_ACL_CLASSIFY_SSE**: vector implementation, can process up to 8 flows in parallel. Require…
376 * **RTE_ACL_CLASSIFY_AVX2**: vector implementation, can process up to 16 flows in parallel. Requi…
380 in parallel. Requires NEON support. Requires max SIMD bitwidth to be at least 128.
383 flows in parallel. Requires ALTIVEC support. Requires max SIMD bitwidth to be at least 128.
386 flows in parallel. Uses 256-bit width SIMD registers.
390 flows in parallel. Uses 512-bit width SIMD registers.
394 …tations can manually exploit IA SIMD instructions and process several input data flows in parallel.
/f-stack/freebsd/contrib/device-tree/Bindings/net/
H A Dmicrel-ks8851.txt4 - compatible = "micrel,ks8851-mll" of parallel interface
/f-stack/freebsd/contrib/device-tree/src/powerpc/
H A Damigaone.dts143 parallel@378 {
144 device_type = "parallel";
/f-stack/freebsd/contrib/device-tree/Bindings/display/panel/
H A Dnec,nl8048hl11.yaml10 The NEC NL8048HL11 is a 4.1" WVGA TFT LCD panel with a 24-bit RGB parallel

123456