| /f-stack/freebsd/contrib/openzfs/lib/libicp/ |
| H A D | Makefile.am | 17 asm-x86_64/modes/gcm_pclmulqdq.S \ 18 asm-x86_64/modes/aesni-gcm-x86_64.S \ 19 asm-x86_64/modes/ghash-x86_64.S \ 41 algs/modes/modes.c \ 42 algs/modes/cbc.c \ 43 algs/modes/gcm_generic.c \ 44 algs/modes/gcm_pclmulqdq.c \ 45 algs/modes/gcm.c \ 46 algs/modes/ctr.c \ 47 algs/modes/ccm.c \ [all …]
|
| /f-stack/freebsd/contrib/openzfs/module/icp/ |
| H A D | Makefile.in | 35 $(MODULE)-objs += algs/modes/cbc.o 36 $(MODULE)-objs += algs/modes/ccm.o 37 $(MODULE)-objs += algs/modes/ctr.o 38 $(MODULE)-objs += algs/modes/ecb.o 39 $(MODULE)-objs += algs/modes/gcm_generic.o 40 $(MODULE)-objs += algs/modes/gcm.o 41 $(MODULE)-objs += algs/modes/modes.o 58 $(MODULE)-$(CONFIG_X86_64) += asm-x86_64/modes/ghash-x86_64.o 63 $(MODULE)-$(CONFIG_X86) += algs/modes/gcm_pclmulqdq.o 83 algs/modes \ [all …]
|
| /f-stack/dpdk/drivers/common/sfc_efx/base/ |
| H A D | efx_nic.c | 1023 efx_qword_t modes; in efx_mcdi_get_loopback_modes() local 1056 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1060 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1064 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1071 modes = *MCDI_OUT2(req, efx_qword_t, in efx_mcdi_get_loopback_modes() 1073 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1081 modes = *MCDI_OUT2(req, efx_qword_t, in efx_mcdi_get_loopback_modes() 1083 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1093 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() 1103 EFX_AND_QWORD(modes, mask); in efx_mcdi_get_loopback_modes() [all …]
|
| /f-stack/freebsd/contrib/device-tree/Bindings/arm/freescale/ |
| H A D | fsl,imx7ulp-pm.txt | 5 the MCU into and out of all stop and run power modes. Specifically, it 6 monitors events to trigger transitions between power modes while 11 Standby modes for either Cortex family. Run, Wait, and Stop are the 12 common terms used for the primary operating modes of Kinetis
|
| /f-stack/freebsd/kern/ |
| H A D | kern_ntptime.c | 357 modes = ntv->modes; in kern_ntp_adjtime() 359 if (modes) in kern_ntp_adjtime() 364 if (modes & MOD_MAXERROR) in kern_ntp_adjtime() 366 if (modes & MOD_ESTERROR) in kern_ntp_adjtime() 368 if (modes & MOD_STATUS) { in kern_ntp_adjtime() 387 if (modes & MOD_TAI) { in kern_ntp_adjtime() 392 if (modes & MOD_PPSMAX) { in kern_ntp_adjtime() 401 if (modes & MOD_NANO) in kern_ntp_adjtime() 403 if (modes & MOD_MICRO) in kern_ntp_adjtime() 405 if (modes & MOD_CLKB) in kern_ntp_adjtime() [all …]
|
| /f-stack/freebsd/contrib/openzfs/tests/zfs-tests/tests/functional/delegate/ |
| H A D | delegate_common.kshlib | 502 set -A modes "on" "off" 526 set -A modes 1 2 3 1067 set -A modes "on" "off" 1086 set -A modes "on" "off" 1241 set -A modes "on" "off" 1264 set -A modes "on" "off" 1275 $perm=${modes[$n]} $fs 1276 if [[ ${modes[$n]} != \ 1290 $perm=${modes[$n]} $fs 1300 $perm=${modes[$n]} $fs [all …]
|
| /f-stack/freebsd/contrib/openzfs/ |
| H A D | COPYRIGHT | 23 * GCM Implementation: module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.cryptogams 24 * GCM Implementation: module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.openssl 25 * GHASH Implementation: module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.cryptogams 26 * GHASH Implementation: module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.openssl
|
| H A D | Makefile.am | 41 EXTRA_DIST += module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.cryptogams 42 EXTRA_DIST += module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.cryptogams.descrip 43 EXTRA_DIST += module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.openssl 44 EXTRA_DIST += module/icp/asm-x86_64/modes/THIRDPARTYLICENSE.openssl.descrip
|
| /f-stack/freebsd/contrib/device-tree/Bindings/regulator/ |
| H A D | mcp16502-regulator.txt | 21 Regulator modes: 41 regulator-allowed-modes = <2>, <4>; 60 regulator-allowed-modes = <2>, <4>; 79 regulator-allowed-modes = <2>, <4>; 98 regulator-allowed-modes = <2>, <4>;
|
| H A D | act8945a-regulator.txt | 18 regulator-initial-mode, regulator-allowed-modes and regulator-mode could be 42 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_FIXED>, 61 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_FIXED>, 83 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_NORMAL>,
|
| H A D | regulator.yaml | 94 description: initial operating mode. The set of possible operating modes 99 regulator-allowed-modes: 100 description: list of operating modes that software is allowed to configure 102 The set of possible operating modes depends on the capabilities of 153 Suspend-to-DISK modes. Equivalent with standby, mem, and disk Linux 184 of possible operating modes depends on the capabilities of every 185 hardware so the valid modes are documented on each regulator device
|
| H A D | act8865-regulator.txt | 37 regulator-initial-mode, regulator-allowed-modes and regulator-mode could be specified 75 regulator-allowed-modes = <ACT8865_REGULATOR_MODE_FIXED>, 101 regulator-allowed-modes = <ACT8865_REGULATOR_MODE_NORMAL>,
|
| /f-stack/dpdk/drivers/net/qede/base/ |
| H A D | ecore_init_ops.c | 419 u16 *p_offset, int modes) argument 429 return ecore_init_cmd_mode_match(p_hwfn, p_offset, modes) ^ 1; 431 arg1 = ecore_init_cmd_mode_match(p_hwfn, p_offset, modes); 432 arg2 = ecore_init_cmd_mode_match(p_hwfn, p_offset, modes); 435 arg1 = ecore_init_cmd_mode_match(p_hwfn, p_offset, modes); 436 arg2 = ecore_init_cmd_mode_match(p_hwfn, p_offset, modes); 440 return (modes & (1 << tree_val)) ? 1 : 0; 445 struct init_if_mode_op *p_cmd, int modes) argument 449 if (ecore_init_cmd_mode_match(p_hwfn, &offset, modes)) 472 int phase, int phase_id, int modes) argument [all …]
|
| /f-stack/freebsd/contrib/device-tree/src/arm/ |
| H A D | armada-370-seagate-nas-4bay.dts | 92 num-modes = <4>; 93 modes-map = <NS_V2_LED_SATA 0 0 102 num-modes = <4>; 103 modes-map = <NS_V2_LED_SATA 0 0
|
| H A D | at91-sama5d27_wlsom1.dtsi | 68 regulator-allowed-modes = <2>, <4>; 87 regulator-allowed-modes = <2>, <4>; 110 regulator-allowed-modes = <2>, <4>; 129 regulator-allowed-modes = <2>, <4>;
|
| H A D | at91-sama5d2_xplained.dts | 200 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_FIXED>, 218 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_FIXED>, 232 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_FIXED>, 246 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_NORMAL>, 260 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_NORMAL>, 274 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_NORMAL>, 288 regulator-allowed-modes = <ACT8945A_REGULATOR_MODE_NORMAL>,
|
| /f-stack/freebsd/contrib/device-tree/Bindings/phy/ |
| H A D | phy-cpcap-usb.txt | 14 pinctrl: Optional alternate pin modes for the PHY 15 pinctrl-names: Names for optional pin modes 16 mode-gpios: Optional GPIOs for configuring alternate modes
|
| /f-stack/freebsd/contrib/device-tree/Bindings/leds/ |
| H A D | leds-ns2.txt | 11 - modes-map: A mapping between LED modes (off, on or SATA activity blinking) and 30 modes-map = <NS_V2_LED_OFF 0 1
|
| /f-stack/dpdk/doc/guides/mempool/ |
| H A D | ring.rst | 9 The following modes of operation are available for the ring mempool driver 50 ``ring_mt_hts`` modes usually provide a better alternative. 52 synchronisation modes please refer to: :doc:`../prog_guide/ring_lib`.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/ata/ |
| H A D | faraday,ftide010.yaml | 15 platform. The controller can do PIO modes 0 through 4, Multi-word DMA 16 (MWDM) modes 0 through 2 and Ultra DMA modes 0 through 6.
|
| /f-stack/freebsd/contrib/device-tree/src/arm64/mediatek/ |
| H A D | mt6358.dtsi | 28 regulator-allowed-modes = <0 1>; 38 regulator-allowed-modes = <0 1>; 47 regulator-allowed-modes = <0 1>; 57 regulator-allowed-modes = <0 1>; 67 regulator-allowed-modes = <0 1>; 76 regulator-allowed-modes = <0 1>; 95 regulator-allowed-modes = <0 1>;
|
| /f-stack/freebsd/contrib/device-tree/Bindings/soc/fsl/cpm_qe/qe/ |
| H A D | firmware.txt | 13 - extended-modes: The Extended Modes bitfield, taken from the 22 extended-modes = <0 0>;
|
| /f-stack/freebsd/contrib/device-tree/Bindings/net/ |
| H A D | microchip,lan78xx.txt | 14 - microchip,led-modes: a 0..4 element vector, with each element configuring 44 microchip,led-modes = <
|
| H A D | xilinx_gmii2rgmii.txt | 7 This core can be used in all three modes of operation(10/100/1000 Mb/s). 10 Different speed modes by configuring the conveter register through mdio write.
|
| /f-stack/tools/ifconfig/ |
| H A D | ifmedia.c | 453 } modes[3]; member 555 for (i = 0; ttos->modes[i].desc != NULL; i++) { in get_media_mode() 556 rval = lookup_media_word(ttos->modes[i].desc, val); in get_media_mode() 665 for (i = 0; ttos->modes[i].desc != NULL; i++) { in get_mode_desc() 666 if (ttos->modes[i].alias) in get_mode_desc() 668 for (desc = ttos->modes[i].desc; in get_mode_desc()
|