| /f-stack/freebsd/contrib/device-tree/Bindings/leds/ |
| H A D | leds-powernv.txt | 12 - led-types : Supported LED types (attention/identify/fault) provided
22 led-types = "identify", "fault";
|
| /f-stack/freebsd/contrib/device-tree/Bindings/misc/ |
| H A D | nvidia,tegra186-misc.txt | 4 used to identify a given chip and various strapping options.
|
| /f-stack/freebsd/contrib/device-tree/src/arm/ |
| H A D | armada-370-seagate-nas-2bay.dts | 11 * Here are some information allowing to identify the device:
|
| H A D | armada-370-seagate-personal-cloud.dts | 11 * Here are some information allowing to identify the device:
|
| H A D | armada-370-seagate-personal-cloud-2bay.dts | 11 * Here are some information allowing to identify the device:
|
| H A D | aspeed-bmc-opp-romulus.dts | 61 identify {
249 "led-identify","","","",
|
| H A D | aspeed-bmc-opp-nicole.dts | 63 identify {
247 "led-power","","","led-identify",
|
| H A D | armada-370-seagate-nas-4bay.dts | 11 * Here are some information allowing to identify the device:
|
| H A D | aspeed-bmc-microsoft-olympus.dts | 47 identify {
|
| /f-stack/freebsd/contrib/device-tree/Bindings/mailbox/ |
| H A D | rockchip-mailbox.txt | 17 - #mbox-cells: Common mailbox binding property to identify the number
|
| H A D | altera-mailbox.txt | 8 - #mbox-cells: Common mailbox binding property to identify the number
|
| /f-stack/freebsd/contrib/device-tree/Bindings/thermal/ |
| H A D | da9062-thermal.txt | 6 Junction temperature thermal module uses an interrupt signal to identify
|
| H A D | qcom-spmi-temp-alarm.txt | 5 interrupt signal and status register to identify high PMIC die temperature.
|
| H A D | imx8mm-thermal.yaml | 33 Number of cells required to uniquely identify the thermal
|
| H A D | thermal-sensor.yaml | 34 Used to uniquely identify a thermal sensor instance within an IC. Will be
|
| /f-stack/freebsd/contrib/device-tree/Bindings/arm/ |
| H A D | primecell.yaml | 14 identify the peripheral type, vendor, and revision. This value can be used for
|
| /f-stack/freebsd/contrib/device-tree/Bindings/serial/ |
| H A D | cdns,uart.txt | 11 - clock-names: Tuple to identify input clocks, must contain "uart_clk" and "pclk"
|
| /f-stack/freebsd/contrib/device-tree/Bindings/interrupt-controller/ |
| H A D | fsl,ls-scfg-msi.txt | 5 - compatible: should be "fsl,<soc-name>-msi" to identify
|
| H A D | ti,keystone-irq.txt | 5 The IRQ handler running on HOST OS can identify DSP signal source by
|
| /f-stack/freebsd/contrib/device-tree/Bindings/watchdog/ |
| H A D | arm,sp805.txt | 4 can be used to identify the peripheral type, vendor, and revision.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/i2c/ |
| H A D | i2c-opal.txt | 12 - ibm,opal-id: Refers to a specific bus and used to identify it when calling
|
| /f-stack/freebsd/contrib/device-tree/Bindings/soc/fsl/cpm_qe/qe/ |
| H A D | par_io.txt | 34 - gpio-controller : node to identify gpio controllers.
|
| /f-stack/dpdk/doc/guides/howto/ |
| H A D | debug_troubleshoot.rst | 20 consolidate a few commonly seen issues for reference. Then, isolate to identify
81 * Make use of ``rte_eth_dev_stats`` to identify the drops cause.
133 * If the TX rate is falling behind the application fill rate, identify if
310 * Identify core role using ``rte_eal_lcore_role`` to identify RTE, OFF,
373 * Periodically checks stats for queue and port to identify the starvation.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/power/ |
| H A D | wakeup-source.txt | 13 then they need to specify/identify the same using device specific
|
| /f-stack/freebsd/contrib/device-tree/Bindings/pci/ |
| H A D | xgene-pci.txt | 5 - compatible: should contain "apm,xgene-pcie" to identify the core.
|