| /f-stack/freebsd/contrib/device-tree/Bindings/iio/adc/ |
| H A D | renesas,gyroadc.txt | 41 of each MB88101A connects to a shared input pin of
51 connects to a shared input pin of the GyroADC.
60 connects to a shared input pin of the GyroADC.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/net/wireless/ |
| H A D | esp,esp8089.txt | 5 that connects the device to the system.
|
| H A D | brcm,bcm43xx-fmac.txt | 5 connects the device to the system.
|
| H A D | ti,wlcore.txt | 5 connects the device to the system.
|
| H A D | marvell-8xxx.txt | 6 connects the device to the system.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/clock/ |
| H A D | renesas,rcar-usb2-clock-sel.txt | 12 Case 1: An external clock connects to R-Car SoC
19 Case 2: An oscillator connects to R-Car SoC
|
| H A D | arm,syscon-icst.yaml | 25 connects the low 8 bits of the VDW (missing one bit), hard-wires RDW to
|
| /f-stack/freebsd/contrib/device-tree/Bindings/sound/ |
| H A D | cs53l30.txt | 26 the hardware design connects both SDOUT1 and SDOUT2
|
| /f-stack/freebsd/contrib/device-tree/Bindings/display/hisilicon/ |
| H A D | dw-dsi.txt | 12 The input port connects to ADE output port with the reg value "0".
|
| /f-stack/freebsd/contrib/device-tree/Bindings/phy/ |
| H A D | rockchip-mipi-dphy-rx0.yaml | 14 The Rockchip SoC has a MIPI D-PHY bus with an RX0 entry which connects to
|
| /f-stack/freebsd/contrib/device-tree/Bindings/arm/stm32/ |
| H A D | st,mlahb.yaml | 14 These bindings describe the STM32 SoCs ML-AHB interconnect bus which connects
|
| /f-stack/freebsd/contrib/device-tree/Bindings/timer/ |
| H A D | sifive,clint.yaml | 16 interrupts. It directly connects to the timer and inter-processor interrupt
|
| /f-stack/freebsd/contrib/ipfilter/netinet/ |
| H A D | ip_dstlist.c | 1124 int connects; local
1157 connects = 0x7fffffff;
1166 if (node->ipfd_states < connects) {
1168 connects = node->ipfd_states;
|
| /f-stack/freebsd/contrib/device-tree/Bindings/net/ |
| H A D | qcom-emac.txt | 5 connects the MAC node to its corresponding internal phy node. Another
|
| /f-stack/freebsd/contrib/device-tree/Bindings/arm/ |
| H A D | coresight-cpu-debug.txt | 7 and eventually the debug module connects with CPU for debugging. And the
|
| /f-stack/freebsd/contrib/device-tree/Bindings/input/ |
| H A D | pxa27x-keypad.txt | 21 tells the level of pins that connects to the direct keyes.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/mfd/ |
| H A D | cros-ec.txt | 8 its own driver which connects to the top level interface-agnostic EC driver.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/interrupt-controller/ |
| H A D | sifive,plic-1.0.0.txt | 6 specification. The PLIC connects all external interrupts in the system to all
|
| /f-stack/freebsd/contrib/device-tree/Bindings/bus/ |
| H A D | socionext,uniphier-system-bus.yaml | 10 The UniPhier System Bus is an external bus that connects on-board devices to
|
| H A D | qcom,ebi2.txt | 7 As it says it connects devices to an external bus interface, meaning address
|
| /f-stack/freebsd/contrib/device-tree/Bindings/display/xlnx/ |
| H A D | xlnx,zynqmp-dpsub.yaml | 34 Source Controller handles the DisplayPort protocol and connects to external
|
| /f-stack/freebsd/contrib/device-tree/Bindings/usb/ |
| H A D | amlogic,meson-g12a-usb-ctrl.yaml | 18 A glue connects the DWC3 core to USB2 PHYs and optionally to an USB3 PHY.
|
| H A D | ci-hdrc-usb2.txt | 33 - fsl,usbphy: phandle of usb phy that connects to the port. Use "phys" instead.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/media/xilinx/ |
| H A D | xlnx,csi2rxss.yaml | 121 connects to MIPI CSI-2 source like sensor.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/powerpc/fsl/ |
| H A D | interlaken-lac.txt | 24 The Interlaken LA controller connects internal platform to Interlaken serial
|