Home
last modified time | relevance | path

Searched refs:chipselect (Results 1 – 25 of 50) sorted by relevance

12

/f-stack/freebsd/contrib/device-tree/Bindings/powerpc/fsl/
H A Dlbc.txt6 chipselect number, and the remaining cells are the
7 offset into the chipselect.
8 - #size-cells : Either one or two, depending on how large each chipselect
10 - ranges : Each range corresponds to a single chipselect, and cover
/f-stack/freebsd/contrib/device-tree/Bindings/mtd/
H A Ddavinci-nand.txt20 - ti,davinci-chipselect: number of chipselect. Indicates on the
21 davinci_nand driver which chipselect is used
39 - ti,davinci-mask-chipsel: mask for chipselect address. Needed to mask
40 addresses for given chipselect.
82 ti,davinci-chipselect = <1>;
/f-stack/freebsd/contrib/device-tree/Bindings/rtc/
H A Dnxp,rtc-2123.txt6 - reg: should be the SPI slave chipselect address
9 - spi-cs-high: PCF2123 needs chipselect high
H A Depson,rx6110.txt27 - spi-cs-high: RX6110 needs chipselect high
/f-stack/freebsd/contrib/device-tree/Bindings/memory-controllers/fsl/
H A Difc.txt10 chipselect number, and the remaining cells are the
11 offset into the chipselect.
12 - #size-cells : Either one or two, depending on how large each chipselect
24 - ranges : Each range corresponds to a single chipselect, and covers
/f-stack/freebsd/mips/nlm/
H A Dboard_cpld.c82 uint64_t nlm_board_cpld_base(int node, int chipselect) in nlm_board_cpld_base() argument
87 cpld_phys = nlm_read_gbu_reg(gbubase, GBU_CS_BASEADDR(chipselect)); in nlm_board_cpld_base()
H A Dboard.h152 uint64_t nlm_board_cpld_base(int node, int chipselect);
/f-stack/freebsd/contrib/device-tree/Bindings/gpio/
H A Dspear_spics.txt5 PL022 control. If chipselect remain under PL022 control then they would be
12 directly control each PL022 chipselect. Hence, it is natural for SPEAr to export
21 * st-spics,cs-value-bit: bit offset to drive chipselect low or high
/f-stack/freebsd/contrib/device-tree/Bindings/iio/adc/
H A Drenesas,gyroadc.txt3 The GyroADC block is a reduced SPI block with up to 8 chipselect lines,
38 MB88101A is required. The Cx chipselect lines of the
48 8 chips are required. A 3:8 chipselect demuxer is
57 8 chips are required. A 3:8 chipselect demuxer is
H A Dlltc,ltc2496.yaml24 description: spi chipselect number according to the usual spi bindings
/f-stack/freebsd/contrib/device-tree/Bindings/spi/
H A Dspi-gpio.yaml36 description: GPIOs to use for chipselect lines.
42 description: Number of chipselect lines. Should be <0> if a single device
H A Dspi-fsl-dspi.txt21 - spi-num-chipselects : the number of the chipselect signals.
26 - bus-num : the slave chip chipselect signal number.
H A Dspi_oc_tiny.txt5 - gpios : should specify GPIOs used for chipselect.
/f-stack/dpdk/drivers/raw/ifpga/base/
H A Dopae_spi_transaction.c200 ret = spi_command(dev->dev, dev->chipselect, tx_len, tx_buffer, in byte_to_core_convert()
461 int chipselect) in spi_transaction_init() argument
471 spi_tran_dev->chipselect = chipselect; in spi_transaction_init()
H A Dopae_spi.h107 int chipselect; member
132 int chipselect);
/f-stack/freebsd/contrib/device-tree/src/powerpc/
H A Dac14xx.dts105 chipselect = <2 0x00009000 0x00009100>;
112 chipselect = <6 0x00009000 0x00009100>;
120 chipselect = <3 0x00101140 0x00203100>;
128 chipselect = <5 0x00009000 0x00009100>;
/f-stack/freebsd/contrib/device-tree/src/arm/
H A Dkeystone-k2l-evm.dts67 ti,cs-chipselect = <0>;
84 ti,davinci-chipselect = <0>;
H A Dkeystone-k2e-evm.dts94 ti,cs-chipselect = <0>;
111 ti,davinci-chipselect = <0>;
H A Dkeystone-k2hk-evm.dts111 ti,cs-chipselect = <0>;
128 ti,davinci-chipselect = <0>;
/f-stack/freebsd/contrib/device-tree/Bindings/memory-controllers/
H A Dti-aemif.txt73 - ti,cs-chipselect: number of chipselect. Indicates on the aemif driver
74 which chipselect is used for accessing the memory. For
163 ti,cs-chipselect = <2>;
192 ti,cs-chipselect = <0>;
/f-stack/freebsd/contrib/device-tree/Bindings/net/ieee802154/
H A Dadf7242.txt6 - reg: the chipselect index
H A Dmrf24j40.txt9 - reg: the chipselect index
H A Dmcr20a.txt7 - reg: the chipselect index
H A Dat86rf230.txt8 - reg: the chipselect index
/f-stack/freebsd/contrib/device-tree/Bindings/pinctrl/
H A Dpinctrl-mcp23s08.txt26 SPI uses this to specify the chipselect line which the chip is
28 multiple chips on the same chipselect. Have a look at
35 SPI chipselect. Set a bit in bit0-7 in this mask to 1 if there is a
39 possible to mix mcp23s08 and mcp23s17 on the same chipselect. Set at

12