Home
last modified time | relevance | path

Searched refs:both (Results 1 – 25 of 447) sorted by relevance

12345678910>>...18

/f-stack/freebsd/sys/
H A Dumtx.h179 } both;
193 k1->info.both.a == k2->info.both.a &&
194 k1->info.both.b == k2->info.both.b);
/f-stack/freebsd/contrib/device-tree/Bindings/arm/
H A Dsecure.txt9 space, or visible in both. (One example of that situation would be a
32 secure- bindings only need to be used where both the Secure and Normal
43 both default to "okay". This means the following combinations are
46 /* Neither specified: default to visible in both S and NS */
47 secure-status = "okay"; /* visible in both */
48 status = "okay"; /* visible in both */
49 status = "okay"; secure-status = "okay"; /* visible in both */
53 status = "disabled"; /* disabled in both */
54 status = "disabled"; secure-status = "disabled"; /* disabled in both */
/f-stack/freebsd/contrib/device-tree/Bindings/regmap/
H A Dregmap.txt16 On SoCs that can be operated in both big-endian and little-endian
17 modes, with a single hardware switch controlling both the endianness
20 blob in both cases.
/f-stack/freebsd/contrib/device-tree/Bindings/phy/
H A Dkeystone-usb-phy.txt10 gate on the Keystone SOC for both the USB2 and USB3 PHY. Otherwise it is just
11 an NOP PHY driver. Hence this node is referenced as both the usb2 and usb3
/f-stack/freebsd/contrib/device-tree/Bindings/sound/
H A Dfsl-sai.txt40 with Rx) which means both the transmitter and the
46 means both transmitter and receiver will send and
61 - If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
62 default synchronous mode (sync Rx with Tx) will be used, which means both
H A Dadi,axi-i2s.txt4 (capture) or both directions enabled.
15 the core. The core expects two dma channels if both transmit and receive are
H A Dwlf,wm8974.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8728.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8711.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8776.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8510.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8737.txt3 This device supports both I2C and SPI (configured with pin strapping
H A Dwm8750.txt3 These devices support both I2C and SPI (configured with pin strapping
/f-stack/freebsd/contrib/device-tree/Bindings/pinctrl/
H A Dpinctrl-zx.txt38 'TOP pins'. For pins like KEY_ROW2, the pinmux is controlled by both
40 the pin spread in both controllers. This type of pins are called 'AON pins'.
41 Though pinmux implementation is quite different, pinconf is same for both
/f-stack/dpdk/doc/guides/rawdevs/
H A Dntb.rst23 - Set the needed PCIe port as NTB to NTB mode on both hosts.
25 on both hosts (for Ice Lake, bar size can be set as 12-51, namely 4K-128PB).
26 Note that bar size on both hosts should be the same.
27 - Disable split bars for both hosts.
30 - Disable PCIe PII SSC (Spread Spectrum Clocking) for both hosts. This
/f-stack/dpdk/doc/guides/mempool/
H A Dring.rst36 For underlying **rte_ring** both producer and consumer operate in
42 For underlying **rte_ring** both producer and consumer operate in
/f-stack/freebsd/contrib/device-tree/Bindings/media/
H A Drenesas,vin.yaml18 with both external synchronization and BT.656 synchronization for the latter.
83 If both HSYNC and VSYNC polarities are not specified, embedded
89 If both HSYNC and VSYNC polarities are not specified, embedded
145 If both HSYNC and VSYNC polarities are not specified, embedded
151 If both HSYNC and VSYNC polarities are not specified, embedded
/f-stack/freebsd/contrib/openzfs/tests/zfs-tests/tests/functional/cli_user/misc/
H A Dmisc.cfg42 # can iterate over both sets in an array
67 # can iterate over both sets in an array
94 # can iterate over both sets in an array
/f-stack/freebsd/contrib/device-tree/Bindings/clock/
H A Didt,versaclock5.txt21 5p49v6901: (required) either or both of XTAL or CLKIN
30 5p49v6901: (required) either or both of "xin", "clkin".
/f-stack/freebsd/contrib/device-tree/Bindings/reset/
H A Dst,stm32-rcc.txt4 The RCC IP is both a reset and a clock controller.
H A Dst,stm32mp1-rcc.txt4 The RCC IP is both a reset and a clock controller.
/f-stack/freebsd/contrib/device-tree/Bindings/interrupt-controller/
H A Dinterrupts.txt8 "interrupts" property, an "interrupts-extended" property, or both. If both are
27 the inherited one. Each entry in this property contains both the parent phandle
/f-stack/freebsd/contrib/device-tree/Bindings/serial/
H A Dfsl-lpuart.txt30 Note: Optional properties for DMA support. Write them both or both not.
/f-stack/freebsd/contrib/device-tree/Bindings/ata/
H A Dcortina,gemini-sata-bridge.txt11 - resets: phandles to the reset lines for both SATA bridges
36 and whether master, slave or both interfaces get brought out.
/f-stack/freebsd/contrib/device-tree/src/arm64/amd/
H A Damd-seattle-xgbe-b.dtsi92 interrupts = /* Uses combined intr for both
108 interrupts = /* Uses combined intr for both

12345678910>>...18