Home
last modified time | relevance | path

Searched refs:applied (Results 1 – 25 of 92) sorted by relevance

1234

/f-stack/freebsd/contrib/device-tree/Bindings/pinctrl/
H A Dfsl,imx8mp-pinctrl.yaml50 "mux_val" indicates the mux value to be applied.
52 "input_val" indicates the select input value to be applied.
54 "pad_setting" indicates the pad configuration value to be applied.
H A Dfsl,imx8mm-pinctrl.yaml50 "mux_val" indicates the mux value to be applied.
52 "input_val" indicates the select input value to be applied.
54 "pad_setting" indicates the pad configuration value to be applied.
H A Dfsl,imx8mn-pinctrl.yaml50 "mux_val" indicates the mux value to be applied.
52 "input_val" indicates the select input value to be applied.
54 "pad_setting" indicates the pad configuration value to be applied.
H A Dfsl,imx8mq-pinctrl.yaml50 "mux_val" indicates the mux value to be applied.
52 "input_val" indicates the select input value to be applied.
54 "pad_setting" indicates the pad configuration value to be applied.
H A Dnvidia,tegra124-dpaux-padctl.txt24 the functions are being applied to rather than the individual pads.
H A Dpinctrl-vt8500.txt45 will be applied to all pins in wm,pins, or one value for each entry in
H A Dsamsung-pinctrl.txt76 function selection or pin configuration (or both) have to applied. This
86 The pin function selection that should be applied on the pins listed in the
88 of this property that should be applied to each of the pins listed in the
96 configuration that should be applied on all the pins listed in the
/f-stack/freebsd/contrib/device-tree/Bindings/input/touchscreen/
H A Diqs5xx.txt45 - touchscreen-inverted-x : See [2]. Inversion is applied relative to that
49 - touchscreen-inverted-y : See [2]. Inversion is applied relative to that
53 - touchscreen-swapped-x-y : See [2]. Swapping is applied relative to that
/f-stack/freebsd/contrib/device-tree/Bindings/iio/light/
H A Dus5182d.txt15 fractional bits - Q4.4) applied when light > threshold
18 fractional bits - Q4.4) applied when light < threshold
/f-stack/dpdk/doc/guides/sample_app_ug/
H A Drxtx_callbacks.rst12 In the sample application a user defined callback is applied to all received
13 packets to add a timestamp. A separate callback is applied to all packets
142 The ``add_timestamps()`` callback is added to the RX port and is applied to
168 The ``calc_latency()`` callback is added to the TX port and is applied to all
/f-stack/freebsd/contrib/device-tree/Bindings/dma/
H A Dqcom_hidma_mgmt.txt32 applied back to back while writing to the destination before yielding
35 applied back to back while reading the source before yielding the bus.
37 Once a reset is applied to the HW, HW starts a timer for reset operation
/f-stack/freebsd/contrib/device-tree/Bindings/mfd/
H A Dst,stm32-timers.yaml75 configuration should be applied.
82 "filter" gives the filtering value (up to 15) to be applied.
/f-stack/freebsd/contrib/openzfs/contrib/intel_qat/
H A Dreadme.md11 When using QAT with above kernels versions, the following patches needs to be applied using:
/f-stack/freebsd/contrib/openzfs/config/
H A DAbigail.am2 # When performing an ABI check the following options are applied:
/f-stack/freebsd/contrib/device-tree/Bindings/phy/
H A Drockchip-emmc-phy.txt18 If not set, the default value of 50 will be applied.
/f-stack/freebsd/contrib/device-tree/Bindings/iio/potentiostat/
H A Dlmp91000.txt22 - ti,rload-ohm: ohm value of the internal resistor load applied to the gas
/f-stack/freebsd/contrib/device-tree/Bindings/leds/
H A Dleds-trigger-pattern.txt10 change of brightness, i.e. the subsequent brightness will be applied without
/f-stack/freebsd/contrib/device-tree/Bindings/sound/
H A Dmax98504.txt20 applied during the "attack hold" and "timed hold" phase, the value must be
H A Ddavinci-evm-audio.txt14 - ti,codec-clock-rate : The Codec Clock rate (in Hz) applied to the Codec.
/f-stack/freebsd/contrib/device-tree/Bindings/iio/temperature/
H A Dadi,ltc2983.yaml104 This property set's the pulsed current value applied during
162 applied to the diode. Depending on the number of conversions
227 applied to the RTD.
306 applied to the thermistor. Value 0 set's the sensor in auto-range
/f-stack/freebsd/contrib/device-tree/Bindings/media/i2c/
H A Dimx219.yaml45 Must be released (set high) after all supplies are applied.
/f-stack/freebsd/contrib/device-tree/Bindings/i2c/
H A Di2c-s3c2410.txt16 - samsung,i2c-sda-delay: Delay (in ns) applied to data line (SDA) edges.
/f-stack/dpdk/doc/guides/nics/
H A Dfail_safe.rst98 address is generated, that will be subsequently applied to all sub-devices once
187 emit and receive packets. It will store any applied configuration but will fail
192 will be applied. After this configuration pass, the new sub-device will be
/f-stack/freebsd/contrib/device-tree/Bindings/media/
H A Dimx7-mipi-csi2.txt50 shall only be applied to port 0 (sink port), the array's
/f-stack/freebsd/contrib/device-tree/Bindings/iio/adc/
H A Dadi,ad7192.yaml60 External reference applied between the P1/REFIN2(+) and P0/REFIN2(−) pins.

1234