| /f-stack/freebsd/contrib/device-tree/Bindings/net/ |
| H A D | realtek-bluetooth.yaml | 14 RTL8723CS/RTL8723CS/RTL8822CS is WiFi + BT chip. WiFi part is connected over
15 SDIO, while BT is connected over serial. It speaks H5 protocol with few
27 description: GPIO specifier, used to wakeup the BT module
31 description: GPIO specifier, used to enable the BT module
|
| H A D | nokia-bluetooth.txt | 16 - reset-gpios: GPIO specifier, used to reset the BT module (active low)
17 - bluetooth-wakeup-gpios: GPIO specifier, used to wakeup the BT module (active high)
29 /* controlled (enabled/disabled) directly by BT module */
|
| H A D | ti-bluetooth.txt | 9 * TI WiLink 7/8 (wl12xx/wl18xx) Shared Transport BT/FM/GPS devices
13 standard BT HCI protocol with additional channels for the other functions.
36 - enable-gpios : GPIO signal controlling enabling of BT. Active high.
|
| H A D | qualcomm-bluetooth.txt | 45 label = "BT-UART";
|
| H A D | broadcom-bluetooth.txt | 24 - shutdown-gpios: GPIO specifier, used to enable the BT module
|
| /f-stack/freebsd/contrib/device-tree/Bindings/ipmi/ |
| H A D | aspeed,ast2400-ibt-bmc.txt | 1 * Aspeed BT (Block Transfer) IPMI interface
4 (BaseBoard Management Controllers) and the BT interface can be used to
16 - interrupts: interrupt generated by the BT interface. without an
|
| /f-stack/freebsd/contrib/device-tree/src/arm/ |
| H A D | bcm2837-rpi-3-a-plus.dts | 92 /* Used by BT module */
136 * WL_REG_ON and BT_REG_ON of the CYW43455 Wifi/BT module are driven
163 /* uart0 communicates with the BT module */
|
| H A D | bcm2837-rpi-3-b-plus.dts | 99 /* Used by BT module */
165 /* uart0 communicates with the BT module */
|
| H A D | bcm2837-rpi-3-b.dts | 92 /* Used by BT module */
133 /* uart0 communicates with the BT module */
|
| H A D | bcm2711-rpi-4-b.dts | 133 /* Used by BT module */
210 /* uart0 communicates with the BT module */
|
| H A D | dove-d2plug.dts | 54 /* Marvell SD8787 WLAN/BT */
|
| H A D | imx6qdl-sr-som-brcm.dtsi | 125 /* UART4 - Connected to optional BRCM Wifi/BT/FM */
133 /* USDHC1 - Connected to optional BRCM Wifi/BT/FM */
|
| H A D | dove-d3plug.dts | 72 /* Marvell SD8787 WLAN/BT */
|
| H A D | imx6qdl-sr-som-ti.dtsi | 132 /* UART4 - Connected to optional TI Wi-Fi/BT/FM */
149 /* USDHC1 - Connected to optional TI Wi-Fi/BT/FM */
|
| H A D | kirkwood-guruplug-server-plus.dts | 49 /* AzureWave AW-GH381 WiFi/BT */
|
| /f-stack/freebsd/contrib/device-tree/src/arm64/allwinner/ |
| H A D | sun50i-h6-orangepi-lite2.dts | 11 serial1 = &uart1; /* BT-UART */
58 /* There's the BT part of the AP6255 connected to that UART */
|
| H A D | sun50i-h6-orangepi-3.dts | 68 /* Always on 3.3V regulator for WiFi and BT */
78 /* Always on 1.8V/300mA regulator for WiFi and BT IO */
308 /* There's the BT part of the AP6256 connected to that UART */
|
| /f-stack/freebsd/contrib/device-tree/Bindings/clock/ |
| H A D | samsung,s2mps11.txt | 8 The S2MPS11/13/15 and S5M8767 provide three(AP/CP/BT) buffered 32.768 kHz
9 outputs. The S2MPS14 provides two (AP/BT) buffered 32.768 KHz outputs.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/sound/ |
| H A D | mtk-btcvsd-snd.txt | 1 Mediatek ALSA BT SCO CVSD/MSBC Driver
|
| /f-stack/freebsd/contrib/device-tree/Bindings/soc/qcom/ |
| H A D | qcom,wcnss.txt | 4 block and a BT, WiFi and FM radio block, all using SMD as command channels.
76 "pronto" subsystem, with the wcnss device and its wcn3680 BT and WiFi blocks
|
| /f-stack/freebsd/contrib/device-tree/Bindings/media/i2c/ |
| H A D | tvp5150.txt | 5 with discrete syncs or 8-bit ITU-R BT.656 with embedded syncs output formats.
50 BT.656 synchronization.
|
| H A D | adv7604.txt | 58 endpoint will use embedded BT.656 synchronization.
|
| /f-stack/freebsd/contrib/device-tree/Bindings/media/ |
| H A D | allwinner,sun6i-a31-csi.yaml | 106 * embedded BT.656 sync is used.
|
| H A D | samsung-s5c73m3.txt | 4 The S5C73M3 camera ISP supports MIPI CSI-2 and parallel (ITU-R BT.656) video
|
| /f-stack/freebsd/contrib/device-tree/src/arm64/freescale/ |
| H A D | imx8qxp-ai_ml.dts | 84 /* BT */
|