Lines Matching refs:used
41 The motion commands can be used after an operator command, to have the command
43 position before and after the motion. Operators are generally used to delete
102 motion isn't yet), a special set of mappings can be used. See |:omap|.
135 Be careful with forcing a linewise movement to be used characterwise or
139 v When used after an operator, before the motion command: Force
144 inclusive/exclusive. This can be used to make an exclusive
148 V When used after an operator, before the motion command: Force
153 CTRL-V When used after an operator, before the motion command: Force
252 the line is not on the screen or when a count is used.
267 characters may be used, see |utf-8-char-arg|.
269 in Insert mode can be used to switch this on/off
311 Differs from 'k' when lines wrap, and when used with
316 Differs from 'j' when lines wrap, and when used with
356 line number this formula is used:
363 last number in it used as the byte count. End-of-line
377 If "k", "-" or CTRL-P is used with a [count] and there are less than [count]
457 first column. When used after an operator, then also
497 the '{' flag is in 'cpoptions' then '{' in the first column is used as a
524 This is a series of commands that can only be used while in Visual mode or
538 When used in Visual linewise mode "aw" switches to
544 When used in Visual linewise mode "iw" switches to
551 When used in Visual linewise mode "aW" switches to
557 When used in Visual linewise mode "iW" switches to
563 When used in Visual mode it is made characterwise.
568 When used in Visual mode it is made characterwise.
575 When used in Visual mode it is made linewise.
582 When used in Visual mode it is made linewise.
589 When used in Visual mode it is made characterwise.
596 When used in Visual mode it is made characterwise.
604 When used in Visual mode it is made characterwise.
611 When used in Visual mode it is made characterwise.
617 When used in Visual mode it is made characterwise.
623 When used in Visual mode it is made characterwise.
630 When used in Visual mode it is made characterwise.
637 When used in Visual mode it is made characterwise.
644 When used in Visual mode it is made characterwise.
651 When used in Visual mode it is made characterwise.
658 is used to skip escaped quotes.
665 When used in Visual mode it is made characterwise.
667 included. A count is currently not used.
677 When used after an operator:
692 When used in Visual mode:
704 movement commands are used.
737 the tags will be included (otherwise nothing would change). Also, "it" used
843 Lowercase marks can be used in combination with operators. For example: "d't"
899 |:keepjumps| command modifier was used.
913 when Insert mode was stopped. This is used by the
915 modifier was used.
1017 Note that ":keepjumps" must be used for every command.
1086 The pointer will be set at the last used jump position. The next CTRL-O
1103 When the |:keepjumps| command modifier is used, jumps are not stored in the
1131 previous change. Two commands can be used to jump to positions of changes,
1156 to the change list. When 'textwidth' is zero 'wrapmargin' is used. When that
1157 also isn't set a fixed number of 79 is used. Detail: For the computations
1158 bytes are used, not characters, to avoid a speed penalty (this only matters
1165 When the `:keepjumps` command modifier is used the position of a change is not
1207 For other items the matchit plugin can be used, see
1224 Perl, where single quotes are used for strings.
1247 The above four commands can be used to go to the start or end of the current