Lines Matching refs:command

136 this mode by sending an 'Interrogate Joystick' command to the ikbd.
152 command in this mode not only stop the output but also temporarily stops
162 until reset or commanded into another mode. The PAUSE command in this mode not
204 the mouse. After any joystick command, the ikbd assumes that joysticks are
205 connected to both Joystick0 and Joystick1. Any mouse command (except MOUSE
207 both buttons are logically connected to it. If a mouse disable command is
209 assigned to Joystick1 (until the mouse is reenabled by another mouse command).
226 N.B. The RESET command is the only two byte command understood by the ikbd.
227 Any byte following an 0x80 command byte other than 0x01 is ignored (and causes
231 Executing the RESET command returns the keyboard to its default (power-up)
233 The RESET command or function causes the ikbd to perform a simple self-test.
235 of receipt of the RESET command (or the end of the break, or power-up). The
254 This command sets how the ikbd should treat the buttons on the mouse. The
288 command sets the maximum positive value that can be attained in the scaled
305 command is not affected by the mouse motion origin.
316 This command sets the threshold before a mouse event is generated. Note that
318 command is valid only in RELATIVE MOUSE POSITIONING mode. The thresholds
330 This command sets the scale factor for the ABSOLUTE MOUSE POSITIONING mode.
356 The INTERROGATE MOUSE POSITION command is valid when in the ABSOLUTE MOUSE
371 This command allows the user to preset the internally maintained absolute
381 This command makes the origin of the Y axis to be at the bottom of the
405 Resume sending data to the host. Since any command received by the ikbd after
406 its output has been paused also causes an implicit RESUME this command can be
407 thought of as a NO OPERATION command. If this command is received by the ikbd
418 disabled). Any valid mouse mode command resumes mouse motion monitoring. (The
422 command DOES affect their actions.
431 Stop sending data to the host until another valid command is received. Key
442 Because of the limitations of the microcontroller memory this command should
446 OUTPUT command is received in the middle of a multiple byte report, the packet
449 MONITORING mode, the PAUSE OUTPUT command also temporarily stops the
479 Return a record indicating the current state of the joysticks. This command
496 Sets the ikbd to do nothing but monitor the serial command line, maintain the
512 Set the ikbd to do nothing but monitor the serial command line, maintain the
559 disabled). Any valid joystick mode command resumes joystick monitoring. (The
610 This command permits the host to load arbitrary values into the ikbd
626 This command permits the host to read from the ikbd controller memory.
637 This command allows the host to command the execution of a subroutine in the
646     relevant SET command.
671 or the parameters associated with a given command. All status reports are