Lines Matching refs:command

204 opcode    Corresponding SPI command
226 opcode    Corresponding I2C command                             Address
248 can be checked and/or when to initiate a new command. If enabled, the cycle done assertion can
256 So PIO typical use case is, before DMA initialization, write RESET command (PIO write), read
257 RESET response (PIO read or PIO write followed by read), write Power ON command (PIO write), read
318 According to HIDSPI and HIDI2C protocol, every time only one command can be sent to touch IC, and
319 before last command is completely handled, next command cannot be sent, THC write DMA engine only
441 - Issue a command to retrieve device descriptor from Touch IC through PIO write.
444 - Issue a command to retrieve report descriptor from Touch IC through DMA.
500 - Use PIO or TxDMA to write a SET_POWER request to TIC's command register, and check if the
502 - Use PIO or TxDMA to write a RESET request to TIC's command register. If the write operation
551 - THC QuickI2C uses PIO or TXDMA to write a SET_REPORT request to TIC's command register. Report