Lines Matching refs:To

69 3. To create a loadable module, perform the following steps.
70    NOTE: To compile the driver into the kernel, go directly to step 4.
72         a. To compile the module
77         b. To install the compiled module to the system directory:
87 4. To compile the driver into the kernel, enter:
101 5. To assign an IP address to the interface, enter the following:
111 7. To configure the IP address to remain after reboot, edit /etc/rc.conf,
172   To enable Jumbo Frames, use the ifconfig utility to set the Maximum
175   The Jumbo Frames MTU range for Intel Adapters is 1500 to 16110. To modify
180   To confirm the MTU used between two specific devices, use:
188   - To enable Jumbo Frames, increase the MTU size on the interface beyond
241   To create a new VLAN interface:
245   To associate the VLAN interface with a physical interface and
258   To remove a VLAN interface:
266   To enable polling in the driver, add the following options to the kernel
289   To enable checksum offloading:
293   To disable checksum offloading:
297   To confirm the current setting:
322   To enable:
375           a. To compile the module
380    b. To install the compiled module in system directory: