371 	PMD_INIT_LOG(DEBUG, "Setting port %d, %s queue_id %d to stat index %d",  in txgbe_dev_queue_stats_mapping_set()
377 		PMD_INIT_LOG(ERR, "Nb of stat mapping registers exceeded");  in txgbe_dev_queue_stats_mapping_set()
397 	PMD_INIT_LOG(DEBUG, "Set port %d, %s queue_id %d to stat index %d",  in txgbe_dev_queue_stats_mapping_set()
400 	PMD_INIT_LOG(DEBUG, "%s[%d] = 0x%08x", is_rx ? "RQSMR" : "TQSM", n,  in txgbe_dev_queue_stats_mapping_set()
506 			PMD_INIT_LOG(NOTICE, "No TX queues configured yet. "  in eth_txgbe_dev_init()
535 		PMD_INIT_LOG(ERR, "Shared code init failed: %d", err);  in eth_txgbe_dev_init()
558 		PMD_INIT_LOG(ERR, "The EEPROM init failed: %d", err);  in eth_txgbe_dev_init()
565 		PMD_INIT_LOG(ERR, "The EEPROM checksum is not valid: %d", err);  in eth_txgbe_dev_init()
590 		PMD_INIT_LOG(ERR, "This device is a pre-production adapter/"  in eth_txgbe_dev_init()
593 		PMD_INIT_LOG(ERR, "If you are experiencing problems "  in eth_txgbe_dev_init()
597 		PMD_INIT_LOG(ERR, "Unsupported SFP+ Module");  in eth_txgbe_dev_init()
600 		PMD_INIT_LOG(ERR, "Hardware Initialization Failure: %d", err);  in eth_txgbe_dev_init()
614 		PMD_INIT_LOG(ERR,  in eth_txgbe_dev_init()
629 		PMD_INIT_LOG(ERR,  in eth_txgbe_dev_init()
660 		PMD_INIT_LOG(DEBUG, "MAC: %d, PHY: %d, SFP+: %d",  in eth_txgbe_dev_init()
664 		PMD_INIT_LOG(DEBUG, "MAC: %d, PHY: %d",  in eth_txgbe_dev_init()
667 	PMD_INIT_LOG(DEBUG, "port %d vendorID=0x%x deviceID=0x%x",  in eth_txgbe_dev_init()
1124 			PMD_INIT_LOG(INFO, "ETH_MQ_RX_VMDQ_DCB mode supported in SRIOV");  in txgbe_check_mq_mode()
1128 			PMD_INIT_LOG(ERR, "SRIOV active,"  in txgbe_check_mq_mode()
1137 					PMD_INIT_LOG(ERR, "SRIOV is active,"  in txgbe_check_mq_mode()
1152 			PMD_INIT_LOG(ERR, "SRIOV is active,"  in txgbe_check_mq_mode()
1160 			PMD_INIT_LOG(INFO, "ETH_MQ_TX_VMDQ_DCB mode supported in SRIOV");  in txgbe_check_mq_mode()
1172 			PMD_INIT_LOG(ERR, "SRIOV is active,"  in txgbe_check_mq_mode()
1181 			PMD_INIT_LOG(ERR, "VMDQ+DCB+RSS mq_mode is"  in txgbe_check_mq_mode()
1190 				PMD_INIT_LOG(ERR, "VMDQ+DCB, nb_rx_q != %d.",  in txgbe_check_mq_mode()
1197 				PMD_INIT_LOG(ERR, "VMDQ+DCB selected,"  in txgbe_check_mq_mode()
1207 				PMD_INIT_LOG(ERR, "VMDQ+DCB, nb_tx_q != %d",  in txgbe_check_mq_mode()
1214 				PMD_INIT_LOG(ERR, "VMDQ+DCB selected,"  in txgbe_check_mq_mode()
1229 				PMD_INIT_LOG(ERR, "DCB selected, nb_tcs != %d"  in txgbe_check_mq_mode()
1242 				PMD_INIT_LOG(ERR, "DCB selected, nb_tcs != %d"  in txgbe_check_mq_mode()
1403 		PMD_INIT_LOG(ERR,  in txgbe_dev_start()
1449 			PMD_INIT_LOG(ERR, "Failed to allocate %d rx_queues"  in txgbe_dev_start()
1464 		PMD_INIT_LOG(ERR, "Unable to initialize RX hardware");  in txgbe_dev_start()
1472 		PMD_INIT_LOG(ERR, "Unable to set VLAN offload");  in txgbe_dev_start()
1498 		PMD_INIT_LOG(ERR, "Unable to start rxtx queues");  in txgbe_dev_start()
1535 		PMD_INIT_LOG(ERR, "Invalid link setting");  in txgbe_dev_start()
1575 			PMD_INIT_LOG(INFO, "lsc won't enable because of"  in txgbe_dev_start()
1604 	PMD_INIT_LOG(ERR, "failure in dev start: %d", err);  in txgbe_dev_start()
1758 			PMD_INIT_LOG(ERR,  in txgbe_dev_close()
2165 			PMD_INIT_LOG(WARNING, "id value %d isn't valid", i);  in txgbe_dev_xstats_get_names()
2186 			PMD_INIT_LOG(WARNING, "id value %d isn't valid", i);  in txgbe_dev_xstats_get_names_by_id()
2218 			PMD_INIT_LOG(WARNING, "id value %d isn't valid", i);  in txgbe_dev_xstats_get()
2252 			PMD_INIT_LOG(WARNING, "id value %d isn't valid", i);  in txgbe_dev_xstats_get_()
2275 			PMD_INIT_LOG(WARNING, "id value %d isn't valid", i);  in txgbe_dev_xstats_get_by_id()
2691 		PMD_INIT_LOG(INFO, "Port %d: Link Up - speed %u Mbps - %s",  in txgbe_dev_link_status_print()
2697 		PMD_INIT_LOG(INFO, " Port %d: Link Down",  in txgbe_dev_link_status_print()
2700 	PMD_INIT_LOG(DEBUG, "PCI Address: " PCI_PRI_FMT,  in txgbe_dev_link_status_print()
2938 	PMD_INIT_LOG(DEBUG, "Rx packet buffer size = 0x%x", rx_buf_size);  in txgbe_flow_ctrl_set()
2947 		PMD_INIT_LOG(ERR, "Invalid high/low water setup value in KB");  in txgbe_flow_ctrl_set()
2948 		PMD_INIT_LOG(ERR, "High_water must <= 0x%x", max_high_water);  in txgbe_flow_ctrl_set()
2971 	PMD_INIT_LOG(ERR, "txgbe_fc_enable = 0x%x", err);  in txgbe_flow_ctrl_set()
2999 	PMD_INIT_LOG(DEBUG, "Rx packet buffer size = 0x%x", rx_buf_size);  in txgbe_priority_flow_ctrl_set()
3007 		PMD_INIT_LOG(ERR, "Invalid high/low water setup value in KB");  in txgbe_priority_flow_ctrl_set()
3008 		PMD_INIT_LOG(ERR, "High_water must <= 0x%x", max_high_water);  in txgbe_priority_flow_ctrl_set()
3024 	PMD_INIT_LOG(ERR, "txgbe_dcb_pfc_enable = 0x%x", err);  in txgbe_priority_flow_ctrl_set()
3166 		PMD_INIT_LOG(ERR, "Stop port first.");  in txgbe_dev_mtu_set()