280 		PMD_INIT_LOG(ERR, "port_id %d vendorID=0x%x deviceID=0x%x: "  in eth_em_dev_init()
291 		PMD_INIT_LOG(ERR, "Failed to allocate %d bytes needed to "  in eth_em_dev_init()
304 	PMD_INIT_LOG(DEBUG, "port_id %d vendorID=0x%x deviceID=0x%x",  in eth_em_dev_init()
353 		PMD_INIT_LOG(ERR, "MAC Initialization Error");  in em_hw_init()
358 		PMD_INIT_LOG(ERR, "NVM Initialization Error");  in em_hw_init()
363 		PMD_INIT_LOG(ERR, "PHY Initialization Error");  in em_hw_init()
397 			PMD_INIT_LOG(ERR, "EEPROM checksum invalid");  in em_hw_init()
405 		PMD_INIT_LOG(ERR, "EEPROM error while reading MAC address");  in em_hw_init()
412 		PMD_INIT_LOG(ERR, "Hardware initialization failed");  in em_hw_init()
421 		PMD_INIT_LOG(ERR, "PHY reset is blocked due to "  in em_hw_init()
562 		PMD_INIT_LOG(ERR, "Unable to initialize the hardware");  in eth_em_start()
582 			PMD_INIT_LOG(ERR, "Failed to allocate %d rx_queues"  in eth_em_start()
595 		PMD_INIT_LOG(ERR, "Unable to initialize RX hardware");  in eth_em_start()
606 		PMD_INIT_LOG(ERR, "Unable to update vlan offload");  in eth_em_start()
674 				PMD_INIT_LOG(ERR, "Unable to setup interrupts");  in eth_em_start()
684 			PMD_INIT_LOG(INFO, "lsc won't enable because of"  in eth_em_start()
698 	PMD_INIT_LOG(DEBUG, "<<");  in eth_em_start()
703 	PMD_INIT_LOG(ERR, "Invalid advertised speeds (%u) for port %u",  in eth_em_start()
1605 		PMD_INIT_LOG(INFO, " Port %d: Link Up - speed %u Mbps - %s",  in eth_em_interrupt_action()
1610 		PMD_INIT_LOG(INFO, " Port %d: Link Down", dev->data->port_id);  in eth_em_interrupt_action()
1612 	PMD_INIT_LOG(DEBUG, "PCI Address: " PCI_PRI_FMT,  in eth_em_interrupt_action()
1719 	PMD_INIT_LOG(DEBUG, "Rx packet buffer size = 0x%x", rx_buf_size);  in eth_em_flow_ctrl_set()
1725 		PMD_INIT_LOG(ERR, "e1000 incorrect high/low water value");  in eth_em_flow_ctrl_set()
1726 		PMD_INIT_LOG(ERR, "high water must <= 0x%x", max_high_water);  in eth_em_flow_ctrl_set()
1756 	PMD_INIT_LOG(ERR, "e1000_setup_link_generic = 0x%x", err);  in eth_em_flow_ctrl_set()